Question about Cars & Trucks

1 Answer

Theres no warm air from my heater on Kia Sportage 2009

My heater has suddenly stooped producing warm air,and now what I get is a very mild air.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 4 Answers

Have thought of takingthat the heat fan fuse is had it

Posted on Nov 30, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 15 Answers

SOURCE: removing/replacing a 2000 kia sportage 4x4 4 dr heater core

The heater is located under the dash board to the right and down from the radio. To remove and replace it you will have to remove the dash board down to the fire wall. Also, you will have to disconnect two hoses that connect up to it from the engine compartment. These are located in the back of the engine and down on the firewall about midway. Once you remove the dash board and locate the heater core you will be able to see the location of these two hoses. Removing the heater core is time consuming but it will save you about 700 dollars.

Posted on Nov 04, 2008

  • 1 Answer

SOURCE: heater does not produce hot

My 2002 Audi A4 doesn't produce the hot air, It's an Auto computer control temperature system. I took my car to the local mechanic (gas station), he said that the water pump and the timing belt need to be replaced.

The heating system normally produces by the engine, then normally the "thermostat' is causing the issue, but the temperature gauge doesn't indicate the overheat.

Any idea what's cause this problem?


Posted on Nov 10, 2008

  • 1 Answer

SOURCE: 1998 kia sportage heater core removal

I NEED DIOGRAM FOR A 2001 KIA SPORTAGE HEATER CORE

Posted on Feb 24, 2009

  • 25 Answers

SOURCE: A 1999 Kia Sportage. Heater core leaking.

tie both hoses together

Posted on Jun 25, 2009

c17hydro
  • 2984 Answers

SOURCE: the easiest way to pull the heater core from a kia sportage-2000

There is no real easy way to do it....not like the older cars..

  1. Disconnect the negative battery cable.

    CAUTION After disconnecting the negative battery cable, wait for at least 10 minutes for the air bag module to deplete its stored energy.

    1. Remove the driver’s side air bag and steering wheel by performing the following procedure:
    2. Position the front wheels in the straight-ahead position.
  2. Remove the 4 steering wheel-to-air bag module bolts.
  3. Carefully, lift the air bag module and disconnect the electrical connector.

    CAUTION Place the air bag module in a safe location with the front facing upward.

  4. Remove the steering wheel-to-steering column nut.

    NOTE If may be necessary to mark the steering wheel to steering column alignment.

  5. Using a steering wheel puller, press the steering wheel from the steering column.
  6. Drain the cooling system into a clean container for reuse.
  7. Discharge and recover the air conditioning system refrigerant.
    1. Remove the instrument panel by performing the following procedure:
    2. Remove both the rear and front consoles.
    3. Remove the knee bolster assembly.
    4. Remove the “T” bar section.
    5. Remove the relay bracket.
    6. Remove the turn signal assembly and the upper/lower steering column covers.
    7. Remove the hood release handle lockscrew, the hood release handle and the cable assembly nut.
    8. Remove the left side front pillar trim and the lower left side cover.
    9. Remove the 2 left side of the “T” bar-to-chassis bolts.
    10. At the left side of the instrument panel, remove the 3 instrument panel-to-chassis bolts.
    11. Remove the ashtray.
    12. Remove the center panel trim.
    13. Remove the ventilation control panel.
    14. At the center of the windshield next to the windshield, remove the cap and the mounting bolt.
    15. " Remove the right side front pillar trim and the lower right side cover.
    16. Remove the 2 right side of the “T” bar-to-chassis bolts.
    17. At the right side of the instrument panel, remove the 3 instrument panel-to-chassis bolts.
    18. Remove the steering column-to-instrument panel bolts and lower the steering column.
    19. Disconnect the instrument panel electrical connectors.
    20. Remove the instrument panel.
    1. Remove the blower/evaporator housing by performing the following procedure:
    2. Disconnect the air conditioning refrigerant lines from the evaporator core and discard the gaskets. Plug the openings to prevent contamination.
  8. Disconnect the fresh air control cable from the blower/evaporator housing inlet duct.
  9. Disconnect the 5 connectors from the bottom of the blower/evaporator housing.
  10. Move the carpeting from the bulkhead to gain access to the hole cover plate.
  11. Remove the 4 hole cover plate nuts and the plate.
  12. Remove the 2 upper blower/evaporator housing bolts.
  13. Remove the 2 lower blower/evaporator housing-to-bulkhead nuts.
  14. Remove the blower/evaporator housing.
  15. Disconnect the heater hoses from the heater core.
  16. Remove the temperature control cable from the heater housing.
  17. Remove the 2 lower heater housing nuts and the upper heater housing-to-bulkhead nut.
  18. Remove the heater housing.
    1. Disassemble the heater housing by performing the following procedure:
    2. Remove the seal from the heater core tube connections.
    • Remove the vent seal.
    • Remove the 2 wiring harness-to-heater servo screws.
    • Remove the 8 heater housing clips located on the servo side (left side).
    • Remove the left side of the heater housing.
    • Remove the 6 heater housing assembly clips.
    • Remove the 4 heater core tube mounting bracket screws and the bracket.
    • Remove the 8 remaining heater housing clips and disassemble the housings.
    • Remove the heater core from the housing.

  • f277857.gif
    Exploded view of the heater core and heater housing assembly—Kia Sportage


    THIS IS JUST TO REMOVE IT!

    Posted on Oct 18, 2009

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    I HAVE A KIA SPORTAGE 2007 I HAVE WARM AIR FROM THE DRIVERS SIDE BUT COLD AIR FROM THE PASSENGERS SIDE


    If you have dual air control, then the motor for the passenger side needs replaced, most common fail for all makes and models. Usually you can access it by removing the glove box.

    Apr 10, 2016 | Kia Sportage Cars & Trucks

    1 Answer

    Heater fan how to change it? for a kia sportage


    the problem might the fan resistor which is what regulates and selects the different fan speeds for heater and aircon

    Mar 15, 2016 | Kia Sportage Cars & Trucks

    1 Answer

    Kia sportage 2.7 06 no hot air only luke warm air . blowers good


    are the heater hoses warm of hot if only warm then the thermostat needs changed if hot then the heater core is plugged

    Jan 31, 2015 | Kia Cars & Trucks

    1 Answer

    Single Mom needs help with car problem and can't afford to take it to a shop!!! When i have the heat on and idling, the heater blows cold air. When i accelerate for few minutes, theres a mild whistle...


    Check your heater blower motor, for any obstruction of air in the passage line. If this is a newer car inspect your cabin filter,most of the times is located behind the glove box. and please provide the year, make,model, etc.

    Dec 12, 2014 | 2009 Suzuki Grand Vitara

    1 Answer

    How do I get the front heater to produce warm, hot heat from the blower? for 2003 kia sedona


    If the heater hoses for the front heater are getting hot, it could be a blend door problem under the dash.

    Dec 03, 2014 | 2003 Kia Sedona

    1 Answer

    How do I get the front heater to produce warm, hot heat from the blower? for 2003 kia sedona


    First I would check your radiator fluid level, sometimes being low can have this effect. Usually the rear heaters sit at a lower level and so keep working. If that is fine, then you probably have an issue with the diversion door or controller that controls the hot/cold mixture.

    Dec 03, 2014 | 2003 Kia Sedona

    1 Answer

    How to reset air bag light in kia sportage 2009


    if air bag is ok just try leaving the battery dissconnected for a hour or so.

    Nov 20, 2014 | 2009 Kia Sportage LX

    1 Answer

    Kia sportage 98 windows and heater wont work


    Do you know for a fact the blower and power window fuses have power ?

    Jan 06, 2014 | 1998 Kia Sportage

    1 Answer

    Starting problems Kia Sportage


    Its too cold ... get a block heater. At least get an under hood heater, even an old electric blanket will work ... just don't forget to remove it before starting the engine.

    You also might look into holding the preheaters on longer.

    Sep 18, 2009 | 2000 Kia Sportage

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    35 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts

    yadayada
    yadayada

    Level 3 Expert

    75077 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Randy Ohler

    Level 3 Expert

    14585 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...