Question about Toyota Supra

1 Answer

1991 toyota supra turbo no power sterring

The power sterring is hard to turn replace the pump problem continue, replace the racker problem continue dont know what else to do the gear box is good.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 533 Answers

Flush the whole system to ensure that the fluid is circulating

Posted on Nov 30, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 496 Answers

SOURCE: 1991 toyota supra blue smoke from tail pipe when get of the gas

The intake valve guide seals are worn and are letting oil slip by under high engine vacuum--as when you let up on the gas. The only fix is to take the cylinder head off and replace the valve guide seals. This problem is pretty normal for an older car with high mileage. It will probably run just fine. Just keep checking the oil level and keep it topped up.

Posted on Feb 07, 2009

  • 8 Answers

SOURCE: power steering

blow that dang truck up

Posted on Feb 27, 2009

  • 750 Answers

SOURCE: Toyota Town ace Diesel turbo pump continuously

is it the primming pump? if so replace it if its the the injection pump it may have to be removed and send to a service centre for repair. to save time and money you can look for a junk town ace with engine intact and take the pump from that once its ok

Posted on Sep 27, 2009

  • 1 Answer

SOURCE: 1991 Toyota Supra Turbo

Gotta agree with Noodles on this one.
I saw you turned up your stock turbo to more than 10psi. I've got an 87' and I would love to do the same thing. How'd you do it?

Posted on Feb 24, 2010

caninnova
  • 9 Answers

SOURCE: How do I repair a leak on a Power Steering Gear Box on my 91 Toyota 4Runner

chances are that the high pressure side of the pump is leaking

Posted on Apr 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota celica supra


Yes the points on the relays need to be clean. If the fuel pump does not turn on when you turn the key on the relay is bad.

Oct 11, 2012 | 1984 Toyota Celica Supra

1 Answer

I want a schematic of the turbo on a 1991 toyota supra


Your wish is our comand!


rufasguts_6.jpg

rufasguts_7.jpg I have specifications for testing ,but nothing for overhaul proceedure.

Jul 12, 2011 | Toyota Supra Cars & Trucks

1 Answer

I have a 1989 Toyota Supra Turbo that just started making a high pitch noise. Hard to tell where it's coming from. Almost like a steering pump. Any suggestions? Wish I had more to share and help narrow it...


Hi,
it sounds like you may have a leak on the intake air system or the turbo has a fault.
You don't state your skills level so I am reluctant to dispense advice that you may not be familar with.

A simple test for airleaks on the inlet / intake system would be to start the car, (parking brake applied and trans in P / N or neutral in a manual trans.) Visually check the intake system for broken clamps, damaged hoses, especially the air hose connected to the turbo. A small leak will produce a very evident "whistle". If the turbo has covered a lot of miles, the compressor wheel and turbine blades may be in contact with the housing, due to worn bearings. Turbos spin in excess of 100,000RPM so it doesnt take much to throw them off, as it were. The wastegate should also be checked for correct operation.

You mentioned steerring pump. Slack the drive belt to the PAS pump. If the noise is not evident when that is done, then you have pinpointed the problem.

Jan 31, 2011 | 1989 Toyota Supra

1 Answer

1988 supra non turbo. overheats, pressure builds u...


Check fan clutch does it have silicon,or replace silicon

May 21, 2010 | 1988 Toyota Supra

1 Answer

Power sterring


the pump went out on you!!Sorry

Apr 16, 2009 | 1991 Toyota MR2

1 Answer

1991 toyota supra blue smoke from tail pipe when get of the gas


The intake valve guide seals are worn and are letting oil slip by under high engine vacuum--as when you let up on the gas. The only fix is to take the cylinder head off and replace the valve guide seals. This problem is pretty normal for an older car with high mileage. It will probably run just fine. Just keep checking the oil level and keep it topped up.

Feb 07, 2009 | 1991 Toyota Supra

2 Answers

Can I use a non turbo head on a turbo?


Yes the heads are interchangable. Best way to find out if stuff is interchangable is to go to Toyota dealer and compare part #'s

Nov 30, 2008 | 1989 Toyota Supra

1 Answer

Air flow meter


The turbo uses a completely different air flow meter than the non-turbo.

Nov 07, 2008 | 1991 Toyota Supra

2 Answers

1991 Toyota Supra Turbo


get an aftermarket blow off...hks, greddy

Jun 20, 2008 | 1991 Toyota Supra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...