Question about 1997 Ford Expedition

Open Question

2003 ford expidition check advance trac message is on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 148 Answers

SOURCE: Ball joint replacement-2003 Ford Sport Trac

if you dont have a ball joint press and dont know how to use one then dont do it, but if you do its not that bad of a job just jack the truck up under the control arm remove the brake rotor then take the lower ball joint nut off then use a pickle fork to break the ball joint loose then take the axle nut off push the axle out of the bearing and use the ball joint press to remove and replace the ball joint

Posted on Jul 19, 2009

  • 18 Answers

SOURCE: how do i reset the check engine light on my 2003

Unplug the battery for about 10 min then plug it back up start the engine. the computer should reset, if the light comes back on then u still have problems.

Posted on Jan 07, 2010

  • 1 Answer

SOURCE: Ford sport trac 2003 brake lights are not working

I know this solution will sound weird but put the steering wheel at it's highest position (untilt) and try it..if they come on it's the a wiring harness in the steering column.

Posted on May 21, 2010

woodchuck789
  • 4059 Answers

SOURCE: i have a 2003 ford expidition and the check engine

There are many reasons for the light to come on. anything from emissions to firing problems. You can take the vehicle to Auto Zone or other parts stores and they will read the code for you for free.

Posted on Jul 12, 2010

  • 368 Answers

SOURCE: I need to reset the check engine like on my 2003

All you need to do is turn of your engine, disconnect the postive and negative wire from the battery, leave it like that for half and hour or so until the ECU reset itself. Connect and turn on, check engine light should go off. If it comes back on, you have a issue, a sensor is detecting a malfuction somewhere and you will need to get a code for it or take it to the shop to see what the check engine light is coming on for.

Posted on Feb 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 ford sport trac getting gas odor on passenger's side after driving several miles


have seen loose spark plugs do this. fuel leaks usually don't make it to ground hot engine evaporates it.

Sep 06, 2014 | 2003 Ford Explorer Sport Trac

1 Answer

Advance trac sensor


There are sensors for the ABS System & the Advance Trac
is an add on & sometimes any option, you have to order for that system

You just check your enhanced codes for that system & diagnose it like any other problem

Jul 22, 2014 | 2005 Ford Explorer

1 Answer

Were is the alternator fuse on a 2003 ford expidition


If anywhere its in the power distribution box under the bonnet ,Check for power to the large cable on the alternator and if power then renew the alternator ,they dont last forever and the negative brush and commutator wear out rather quickly compared to older types

Dec 02, 2012 | 2003 Ford Expedition

1 Answer

2003 Ford sport trac - has no power when you accelerate


check your compression or your vaccum lines/tps?

Oct 13, 2010 | 2003 Ford Explorer Sport Trac

2 Answers

2003 Limited, 100K miles: Warning lights on brakes, message that fluid is low, but it isn't. Also, "TRAC off" light is on, message says Advancetrac is off. Engine shudders like a cylinder is cut out at...


was you getting the problem before the tranmission was shot. If no , then carry it back to the person who install the tranmission . that going to throw away money

Aug 13, 2010 | 2003 Ford Windstar

1 Answer

How do i reset the check engine light on my 2003 ford explorer sport trac?


Unplug the battery for about 10 min then plug it back up start the engine. the computer should reset, if the light comes back on then u still have problems.

Jan 04, 2010 | 2003 Ford Explorer Sport Trac

2 Answers

I need fuse box diagram for 2003 ford explorer sport trac


go to 2003 ford explorer owners manual and download it for free from ford then go to roadside emergencies and you will find the fuse box and power distribution box diagram for all fuses

Dec 16, 2009 | 2003 Ford Explorer Sport Trac

1 Answer

Warning Lights on 2003 Windstar


are they still on ?
can you turn off your trac light ?
usaly an ABS light and engine light come on when a wheel speed sensor is falty. you can fiz this your self. message me if you want to do this your self.

May 29, 2009 | 2003 Ford Windstar

Not finding what you are looking for?
1997 Ford Expedition Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...