Question about 2005 Nissan Murano SE

Open Question

HOW TO REPLACE TAILGATE LOCK ON A 2005 NISSAN MURANO

TAILGATE WILL NOT OPEN

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: program garage door opener on 2005 nissan murano

All the info should be in the manual

Posted on Jun 24, 2009

Ad

SOURCE: nissan murano 2005 sl keyless entry remote programing

Close all vehicle doors, LOCK doors using drivers side switch.

Insert key all the way into the ignition, (do not turn) remove key.

Repeat this step 5 times. (6 total)

Hazards should flash to indicate program mode.

Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.

*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press any button on remote, hazards should flash. Repeat step as necessary.

Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.

Source

Posted on Aug 06, 2008

  • 1 Answer

SOURCE: 2005 nissan murano sl, with rattling sound when accelerating

I recently experienced the same symptom with my '05 Murano and it was not a fuel problem. The dealer listed the cause as dry axle splines and replaced both front drive shaft assy's. Note that this was done as warranty with no cost incurred by me.

Posted on Jun 18, 2009

  • 3 Answers

SOURCE: Replace rear wiper on 2005 Murano

You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.

The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:

88b7c7f.jpg

moz-screenshot-61.jpg9b7da18.jpg








Posted on Jun 29, 2009

  • 1 Answer

SOURCE: How to Remove Car Radio from Nissan Murano

If you disconnect one of the battery cables for about 30 sec and reconnect it, that will reset the CD player. Then you can put in the key and see if can eject the offending CD. My bet is that it won't. I own a 2006 with a failing CD (getting it replaced on warranty next week). The CD player in these cars is a real stinker. Nissan should be ashamed.

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Murano back doors will not lock or open at times with or without the the remote


I would think the door lock actuator motors are sticking, they are very lightly built little toys.

Sep 12, 2016 | 2005 Nissan Murano

2 Answers

I have a nissan murano 2005 with the code p1701 and a p0340 how can i use them to repair these codes


Nissan Murano P0340 2005 Nissan Murano - Camshaft Position Sensor Circuit
Possible causes- Faulty Camshaft Position Sensor-
Camshaft Position Sensor harness is open or shorted- Camshaft Position Sensor circuit poor electrical connection- Faulty starter motor- Starting system circuit-
Dead (Weak) battery
P1701- Fuel trim

I would suggest replacing the camshaft position sensor. When the sensor fails it can cause changes in fuel system that the computer can detect. So I suspect once the camshaft sensor ivreplaced that the P1701 code will be gone.
Cam Position Sensor Replacement Nissan Murano 3 5L

Sep 20, 2015 | Nissan Cars & Trucks

1 Answer

TAILGATE WONT OPEN


see if it has child proof locks????

Dec 02, 2013 | 2007 Nissan Murano SE

1 Answer

2007 Murano tailgate black rubber release button is tacky. I get black rubber all over my hand when I touch it. What is the part number for this?


Sorry, no solution, but the same problem. I am wondering if the switch cover has fallen away? Are there any solutions out there?

Aug 16, 2012 | 2007 Nissan Murano SE

1 Answer

Passenger door and liftgate do not open with remote control or door panel control both start at the same time nissan murano 2005 s model


Liftgate is connected to front RH's door actuator thru back door's "opener switch". Replacing the passenger's door lock actuator will solve the problem.

Jul 25, 2010 | 2007 Nissan Murano SE

2 Answers

2003 Nissan Murano Driver door won't lock or unlock with keyfob


The key fob is the remote. But the remote type that works like a key. The remotes that you just need to carry on you to start the car or truck. That is a Key Fob.

Thanks Jay!

Jul 30, 2009 | 2005 Nissan Murano

1 Answer

My 2005 Nissan Murano seems to be possessed. The


Replace the remote battery first, then the remote.

Jul 03, 2009 | 2005 Nissan Murano

Not finding what you are looking for?
2005 Nissan Murano SE Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...