Question about 2007 Volvo S80 V8 Sedan

Open Question

2007 VOLVO S80 SAYS BULB FAILURE LOW BEAM

I keep getting Bulb Failure Low Beam. What does this mean?

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
c17hydro
  • 2984 Answers

SOURCE: 98 volvo S70 low beam bulb replaced still no light

Easiest way would be to go back to where you bought it and make sure the bulb is installed that you bought....and show them. Ask if you can get a new bulb and change it in front of him. Call the dealership and talk to parts, ask if, indeed the hi and lo are interchangeable.

Posted on Mar 12, 2009

Ad
  • 140 Answers

SOURCE: how do you resolve low beam bulb failure?

I CHECKED THIS ISSUE OUT FOR YOU. ALL YOU ARE REQUIRE TO DO IS REPLACE THE LOW BEAM.. GO TO ANY ADVANCED ATUO PARTS STORE AND PICK UP FOR ABOUT$13.. WHEN INSTALLING THE NEW LOW BEAM USE A RAG, OR CLOTH TO HANG ON THE GLASS OF THE NEW BULB..YOU CANT USE YOUR FINGERS TO PUT THE NEW BULB IN, THE OILS OFF OF YOUR FINGER TIP WILL MESS WITH THE LIFE OF THE NEW LOW BEAM... SHOULD BE A VERY SIMPLE TASK.. GOOD LUCK KEITH...

Posted on Mar 12, 2009

  • 1 Answer

SOURCE: how do you replace the low beam bulb on a volvo 2006 S-80

using a mirrow and light you can see a spring clip after removing the power plug, lkoosen the clip from post on top then it will swing down allowing the bub to be removed. to instal reverse thew procedure.

Posted on Jan 30, 2010

  • 179 Answers

SOURCE: I have a Volvo S80 1999 and the low beam passenger

relay ?

Posted on Apr 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does it mean when left low beam failure message on saab 93 2004


low light bulb not working (your dim lights not your bright)

Aug 26, 2014 | 2004 Saab 9-3

1 Answer

2001 grand caravan low beam light not working. i chang bulb already i check fuse already.


Hi Every single time I have had a failure of low beam in a headlight without failure of high beam, it has been because the lamp bulb or halogen lamp module has reached the end of its serviceable life, not because of any wiring problems. Low beam burns out first because it is on the most. If low beam is lost simultaneously in both headlights, I would check fuse first, then the headlight switch. If low beam is lost on one side only, it is almost always going to be due to the bulb or lamp module needing to be replaced. In that case, replace them in both headlights because the other one will be going kaput in short order, as well.Also if you already replaced the fuse and bulb check the headlight dimmer control switch.
Thanks for using Fixya.

Mar 14, 2011 | 2001 Dodge Grand Caravan

1 Answer

LOW BEAM OUT


Hi and welcome to FixYa!

If the low beam is out then the problem can be on the bulb itself or the bulb connector. If the connector is worn out it tends to loose and may result to light failure. There can be no high or no low. Do check the bulbs too for if the bulb is faulty, it will surely require replacement.

Hope this helps and thank you for using FixYa! Have a good one!

Mar 12, 2011 | Chevrolet Lumina Cars & Trucks

1 Answer

I only have high beam headlights. I have replaced the light bulbs and checked the fuses. All the other lights work.


about troubleshooting your headlights on your vehicle. I would isolate the wire that comes from the headlight switch to the headlamp bulbs for low beam and check to see if there is a short in the wire. You can find this wire by using a test light turn on the key and get a good ground with the test light poke the wire and see if the test light illuminates with the headlight switch on. ---- Also check the wires, and check the fuse for your low beams. could of blown a fuse on your lows, but your highs will still work.
Every single time I have had a failure of low beam in a headlight without failure of high beam, it has been because the lamp bulb or halogen lamp module has reached the end of its serviceable life, not because of any wiring problems. Low beam burns out first because it is on the most. If low beam is lost simultaneously in both headlights, I would check fuse first, then the headlight switch. If low beam is lost on one side only, it is almost always going to be due to the bulb or lamp module needing to be replaced. In that case, replace them in both headlights because the other one will be going kaput in short order, as well.
There is something to check. Does the low beam relay click when you turnt he low beams on?
if it does not click then
Then find the BCM at the base of the steering column. In there find the grey connector and in there, find the pink/white wire in terminal A4. Use a wire to jump that wire to ground. IF the low beams come on, then it is likely the BCM is bad.
Also check a bad wire between the fuse block and the BCM. before replacing the BCM . Start under the fuse block. This is the fuse block under the hood.
This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya

Mar 18, 2010 | 2004 Chevrolet Cavalier

1 Answer

How to replace the high beam bulb on a 98 GMC Suburban. What needs to be removed to get to it?


Headlamp Bulb: Service and Repair
REMOVAL PROCEDURE
1. Make sure the headlamp switch is in the OFF position.
CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments.
To help avoid personal injury:
- Turn off the lamp switch and allow the bulb to cool before changing the bulb. Leave the lamp switch off until the bulb change is
complete
- Always wear eye protection when changing a halogen bulb.
- Handle the bulb only by its base. Avoid touching the glass.
- Do not drop or scratch the bulb.
- Keep dirt and moisture off the bulb.
- Place the used bulb in the new bulb's carton and dispose of it properly.
- Keep halogen bulbs out of the reach of children
NOTE
: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause
the bulb to explode when the bulb is turned on. It either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and
wipe the bulb dry.
2. Remove the bulbs from the headlamp capsules by reaching from the engine compartment and by twisting the bulb counterclockwise.
3. Remove the 2 long screws from the top of the radiator support.
4. Pull forward the headlamp assembly (3).
5. Disconnect the electrical connector (2) from the burned out bulb assembly (1).
INSTALLATION PROCEDURE
IMPORTANT
:
- Replace a high beam bulb with another high beam bulb. The high beam bulb has a red gasket.
- Replace a low beam bulb with another low beam bulb. The low beam bulb has a gray tip and a yellow gasket at the base.
1. Install the new bulb assembly (1) into the headlamp assembly (3).
Twist clockwise the bulb assembly.
2. Seat the bulb assembly with the connector facing down.
3. Connect the electrical connector (2) to the bulb assembly.
4. Install the headlamp assembly.
5. Install the 2 long screws through the top of the radiator support.
6. Tighten the screws.

Oct 30, 2009 | 1998 GMC Suburban

3 Answers

Bulb failure, position light


Bulb failure, position light means you have a burned out light bulb somewhere. I had the same problem on my 2002 s60. It looked like all the lights were working but I found out that there are several bulbs in the tail lights, so even though the tail lights were working there was in fact a burned out bulb. Look at the bulbs a bit closer and you will probably find one thats bad.

Oct 06, 2009 | 2006 Volvo S60

1 Answer

Low beam light does not work only high beam works


double check the bulb. swap the two bulbs if it's only one side of low beams are out (to see if it's the bulb). also take a look at the wiring itself, including where the bulb plugs in, for corrosion or breakage.
if your serious about keeping this Z at stock shape, restoring it, or just keeping it running, you can get goodies for it at blackdragonauto.com

Jun 17, 2009 | 1984 Nissan 300ZX

2 Answers

Low beams do not work, replaced turn signal switch but still no low beams. High beams work but no low. Please Help


its probally the bulb........alot of car headlights are DUAL element meaning one bulb has 2 little elements inside one for low beam one for high beam...............Most times the low beam burns out because its used more.....get it one bulb gives both high and low beams.......REPLACE bulb......if you don't know what kind go to auto part store, tell them the make of your car and they will give you the right one .....

May 09, 2009 | 1997 Ford Explorer AWD

1 Answer

How do you resolve low beam bulb failure?


I CHECKED THIS ISSUE OUT FOR YOU. ALL YOU ARE REQUIRE TO DO IS REPLACE THE LOW BEAM.. GO TO ANY ADVANCED ATUO PARTS STORE AND PICK UP FOR ABOUT$13.. WHEN INSTALLING THE NEW LOW BEAM USE A RAG, OR CLOTH TO HANG ON THE GLASS OF THE NEW BULB..YOU CANT USE YOUR FINGERS TO PUT THE NEW BULB IN, THE OILS OFF OF YOUR FINGER TIP WILL MESS WITH THE LIFE OF THE NEW LOW BEAM... SHOULD BE A VERY SIMPLE TASK.. GOOD LUCK KEITH...

Mar 12, 2009 | 2003 Volvo S80

Not finding what you are looking for?
2007 Volvo S80 V8 Sedan Logo

Related Topics:

265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...