Question about Chrysler Sebring

Open Question

Starter motor fuse keeps blowing on peugot 307 sw 2006

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
redbeard00
  • 957 Answers

SOURCE: starter fuse keeps blowing

Sounds like a short in the system. you will need to inspect the wiring and posably, bench test the starter. Check the cables to the battery. Make sure the wires and the battery are in good shape.

Posted on May 13, 2009

Ad
jasperoni
  • 203 Answers

SOURCE: starter enabler fuse blows which means the starter motor does not work until fuse is changed

It is possible that the starer is pulling too much amperage- 1st thing you need to do is find out what if any other consumers are on that circuit, 2nd you need to find out how much amperage is being consumed by the starter. 3rd test you wires most likely if a wire problem it is the heavy hot wire on the starter or the back of the alternator has a loose retaining nut

Posted on Jun 01, 2009

  • 98 Answers

SOURCE: 1996 Dodge Stratus keeps blowing fuse to starter!

Need to look at symntec and see if there is a relay on the starter. Which there most likely is. and it is bad. Look at the fuse and see if there is another wire going from the fuse to a relay,if so replace that relay.

Posted on Jun 06, 2009

  • 205 Answers

SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"

usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Posted on Sep 04, 2009

  • 454 Answers

SOURCE: 2001 ford focus gnition fuse keeps blowing

Replace the wire. It is shorting to ground, causing the fuse to blow.

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

50A IGN Starter SW/ Starter fuse blows every time I start the vehicle


Run a jumper from the fuse connection to the starter

Nov 13, 2015 | 1998 Dodge Durango

1 Answer

I keep replacing fuse and as soon as I turn ingition fuse blows out


bart simson was touching electrical cable... ouch! ouch! ouch!...

check your wiring! most probably starter motor cable is lose or bridging. if these are correct - check starter motor itself.

fuse do not blow because did not like you - fuse blow because there is fault within installation...

Feb 14, 2015 | Cars & Trucks

1 Answer

Hi. Peugot 307 hdi sw (05). its running rough at idle, sounds a little rough when driving, power down, especially at low revs. Thanks


run the fault codes . Check injector for clean and operating correctly. Check fuel pressure at the injectors.

Jan 03, 2015 | Cars & Trucks

2 Answers

PEUGEOT 307 FUSE KEEPS BLOWING (abs faults, horn doesnt work)


i have a peugeot 307 number 8 fuse keeps blowing so i have to keep changing the 20 amp fuse please help me i am trying to find out what is causing this

Dec 07, 2012 | 2002 Peugeot 307

1 Answer

My car 307 sw 2006 1,6 starts only when the engien is cold. when i drive, for 10 min and try to start the engien again after a fool stop, it makes klicking sound when i try to start. and if i try to many...


It really sounds like the starter to me..Alot of time i have seen this happen simlpy because heat shield keeping exhaust heat away from starter is off..This would only be the case if your car is set up that way and on that model and make i dont know. Some times starters simply start to fail and this is one of the signs "starter gets hot and car wont start...might try replacing it would be my suggestion....hope this helps and good luck ....Please rate my post.......If you need more help fill free to contact me..

Aug 16, 2012 | 2006 Peugeot 307 1.6

1 Answer

Peugot 307 1.6 semi automatic keeps blowing F8 engine box fuse when I try and start the engine while it's still hot


Pull the fuel pump relay and see if the fuse still blows, if not then you have a shorted pump or wiring to it, the pump is the more common problem.

Jul 24, 2012 | Cars & Trucks

1 Answer

My peugeot 307 sw 2006 dual zone A/C is blowing hot air in one side while a/c is on


Have the blend doors that control air temperature checked for proper operation by a local shop, they may have a defective blend door actuator drive motor or the blend door may be stuck or the shaft broken that the door is attached to.

Jun 22, 2012 | Cars & Trucks

2 Answers

Peugot 306 indicator noise and wfront electric windows


hey kempster_rob the problem is in the wiring between the doors and the body, the wiring is short and is constructed wrong, so when you after 3000 openings and closings the wires brakes and either loose connection or makes shortcuts between the different cables causing fuse blows and disrupted working electrical system. Solution is to open the isolation around the cables and either repair them or displace them, its possible to buy a repair kit at the peugeot dealer

Jan 28, 2009 | 1989 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...