Question about 2007 Dodge Charger SE

Open Question

Recirculation door on 2007 charger - 2007 Dodge Charger SE

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace an air inlet actuator on 2007 Pontiac Vibe 1.8 Liter Engine


Recirculation Control The recirculation control determines the air intake through the recirculation actuator. When the recirculation switch is pressed, a signal is sent from the switch to the recirculation actuator through the recirculation signal circuit. When the actuator receives the signal, the actuator moves into the recirculation mode. This circulates air from inside the vehicle instead of fresh air from the outside. Recirculation is available in any mode and can be selected with the blower motor in either the ON or OFF position.
Air Inlet Valve Actuator Replacement
Removal Procedure
  1. Remove the Instrument Panel (IP) compartment. Refer to Instrument Panel Compartment Replacement .
remove the glove box
Remove the connector (2). Remove the two screws (1) and the air inlet actuator (3) from the HVAC module.

Apr 18, 2016 | Pontiac Cars & Trucks

1 Answer

How to replace a side mirror on a 2007 charger


how do you change side rear view mirror on drivers door

Jul 05, 2012 | 2007 Dodge Charger SE

1 Answer

Front blower for caravan 2007


are you needing to replace it? if so it is located pn the right side of the vehicle under the dash. the recirculation door actuator is at the bottom of the blower motor housing.

May 23, 2012 | 2007 Chrysler Town & Country LX New Cars

1 Answer

Heat control problem-air will not go to the floor. Your feet get cold and your head gets hot!


Your truck has an electric motor that runs the mode door.It is a pretty common problem that goes wrong.There are three motors under the dash one runs the recirculation/fresh air door,one runs the blend door (hot/cold) and one that runs the mode door that is the most likely cause of your problem.let me know if this helps or you need more info.

Feb 07, 2010 | 2007 Dodge Ram Truck

1 Answer

Not hot air whn control is moved to hot


PLEASE DON'T FORGET TO RATE!

Removal & Installation
  1. Disconnect the negative battery cable.
  2. Lower the glove compartment door to provide access to the recirculation duct assembly.
  3. Disconnect the vacuum hose from the end of the vacuum motor and the motor arm retainer from the door crank arm.
  4. Remove the two nuts retaining the vacuum motor to the recirculation duct, then remove the motor.
To install:
  1. Position the vacuum motor to the fresh air/recirculate door crank arm, position the motor to the recirculation duct and install the two retaining nuts.
  2. Install the retainer on the door crank arm.
  3. Connect the white vacuum hose to the vacuum motor, connect the negative battery cable, then check the operation of the vacuum motor.
  4. Close the glove compartment door.

Oct 25, 2009 | 1994 Ford Taurus

2 Answers

When i press the ac button it blinks three times but does not turn on. 2007 Tahoe LT


If your vehicle is equipped with automatic climate control, this should help.

Recirculation Operation
The HVAC control module controls the air intake through the recirculation actuator. The recirculation switch closes the recirculation door in order to circulate the air within the vehicle. The outside air switch opens the recirculation door in order to route outside air into the vehicle. Regardless of the blower motor switch position, recirculation is available only in the panel and bi-level mode switch positions. Including the OFF position. The mode switch must be placed in either the panel or bi-level position before the blower motor switch is placed in the OFF position. In order to reduce windshield fogging, outside air is circulated when the mode switch is in the defrost or defog positions. If the recirculation switch is pressed into the ON position when the mode switch is in an unavailable mode position, then the recirculation switch LED will flash 3 times. If the HVAC control module detects a fault with the recirc door the HVAC control module will try to drive the actuator for a predetermined amount of time, to outside air, which is the defaulted position for the recirculation actuator

Oct 17, 2009 | 2007 Chevrolet Tahoe

1 Answer

2007 F-150 Supercrew Lariat Cabin Air Filter


According to the shop manual you do not have one.
Air Distribution and Filtering adobe.gif Printable View (79 KB) NOTE: The air distribution system of this vehicle cannot be equipped with a cabin air filter.
There are 2 sources of air available to the air distribution system:
  • Outside air
  • Recirculated air
Recirculated air is automatically used when the electronic manual temperature control mode selector is set in the MAX A/C or OFF modes and can be selected in any mode other than MAX A/C, OFF or DEFROST by selecting the RECIRC button. Recirculated air is available in all modes except DEFROST. If the vehicle is equipped with an electronic automatic temperature control (EATC) system, recirculated air is used in OFF and is available in all modes except DEFROST. RECIRC mode is a timed function in FLOOR and FLOOR/DEFROST.
Air distribution within the vehicle is determined by the electronic manual temperature control (EMTC) function selector switch position, or is controlled by the EATC system in the AUTOMATIC mode. The air distribution mode on EATC vehicles may be overridden by the driver if desired. Air distribution doors are used to direct airflow within the heater core and evaporator core housing and the plenum chamber. An electronic mode door actuator is used to position these air distribution doors. One air inlet mode door is used to switch between FRESH or RECIRC air inlet. An electric actuator is used to position the air inlet mode door.
Air enters the passenger compartment from the:
  • instrument panel A/C registers.
  • heater outlet floor ducts.
  • windshield defroster duct.
  • side window demisters.
  • center flow-through console (if equipped).
Passenger compartment air is exhausted from the vehicle through open windows or body air vents.

Mar 08, 2009 | 2007 Ford F-150 Harley Davidson

2 Answers

Dodge 2007 charger the passenger speaker in the front is not work


when mine stopped working,the right speaker, i removed the door panels then swapped the speakers. and still the right speaker didnt work. so i got a radio from a junkyard and installed it. and now all speakers work fine.

Feb 28, 2009 | 2007 Dodge Charger SRT8 Sedan

1 Answer

Ac not blowing correctly


these truck are notorious for breaking recir and blend doors. if its reci break it out pull it out and if its blend the dash has to be removed

Jul 25, 2008 | 2007 Dodge Ram Truck

Not finding what you are looking for?
2007 Dodge Charger SE Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...