Question about Hyundai Motor 2002 Elantra

Open Question

Where is the tcm located on a 2002 hyundai elantra

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: thermostat in a 1997 hyundai elantra

See exploded view
0d68e80.gif

REMOVAL
1. Drain the coolant down to thermostat level or below. 2. Remove the coolant outlet fitting and gasket. 3. Remove the thermostat

Posted on Jun 23, 2008

Ad
  • 1 Answer

SOURCE: location of oil filter on a 2008 hyundai elantra

It is located under the alternator. If you are looking down at the engine, it is to the far left. If you are under the car it is to the far right before the oil pan.

Posted on Feb 09, 2009

SOURCE: Elantra's thermostat

dear friend:please look were the engine and gearbox joins together there is a housing were the radiator hose fits from the radiator,remove that housing and you will find the thermostat,

Posted on Sep 23, 2009

  • 1 Answer

SOURCE: where is the oil pan on a hyundai elantra 2002 GT?

Rule of thumb; if you can't find the oil pan then you do NOT have the skill it takes to change the oil!

Posted on Oct 29, 2009

ghost45
  • 1280 Answers

SOURCE: 2002 hyundai elantra radio and dome light not working

Then 1, bulbs are burned out
OR 2, the wiring is faulty.

Posted on Nov 04, 2009

Testimonial: "thanx for the solution. took the car to a repair shop and was told that the wiring was faulty. had the car rewired."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the TCM located on a 2002 Hyundai Santa fe


TCM ( transmission control module) is normally located on or near the transmission
the location will be in photo form in the workshop manual any 2002 hyundai car available from any auto parts shop

Mar 07, 2017 | 2002 Hyundai Santa Fe

1 Answer

2002 hyundai elantra where is the connector located for code scannner?


it should be located under the dash on the drivers side of vehicle

Jan 06, 2013 | Hyundai Motor 2002 Elantra

1 Answer

What is meaning p1529 on my elantra


P1529 means the TCM (transmission control module) has requested that the ECM (engine control module) turn on the check engine lamp. All I can tell you based on this information is that the TCM has seen something abnormal. To find out what abnormal condition the TCM saw, you'd need to retrieve the DTCs (diagnostic trouble codes) from the TCM. The most frequent culprit is either the input or output speed sensor, but there's no way to know whether they may be the issue without the TCM DTCs

Mar 20, 2010 | 2004 Hyundai Elantra

1 Answer

2002 hyundai elantra gls windshild washer is not


Check the fuse box if not under the dash on the drivers side kick panel, then under the hood, look in the owners man for the location. With the key on, hold the washer switch on and have someone check for power to the pump motor located in the bottom of the washer fluid bottle if the fuse is good but not getting power to the pump then the wiper/washer switch is your most likely culprit..

Mar 20, 2010 | Hyundai Motor 2002 Elantra

1 Answer

Code p1613 on a 1998 hyundai elantra means what


P1613 trouble code. When you start the engine, the TCM (transmission control module) sends a test signal along the wire to the ECM (engine control module) it uses to request the check engine lamp. P1613 indicates that the test signal voltage is more than 120% of battery voltage.

I'd recommend clearing the code to see if it comes back. It's possible this was a one-time error. If it does come back, it'll be very difficult to diagnose. The problems could be:
1. Improper signal from TCM (defective TCM)
2. Improper signal measurement in ECM (defective ECM)
3. Irregular feedback from an actuator that causes bleed-over into this signal circuit in either the ECM or TCM.

The last case of this I recall was a defective TCM

Oct 30, 2009 | 2000 Hyundai Elantra

1 Answer

Troubleshooting codes P1529 and troubleshooting codes P0705 because check engine light was on


P0705 - Range switch signal incorrect P1529 - MIL on request (from TCM). P0705 tells you there's a problem with the transaxel range switch. Replace it.

Oct 08, 2009 | Hyundai Motor 2002 Elantra

1 Answer

6pin valve body trannny to 4pin using 6pin's TCM


First of all, which component(s) are you replacing? Only the valve body? If so, then there's something different about the one you took out compared to the one you're putting in - that can be dangerous! BEST SOLUTION: Replace/Install in the correct part at the beginning.

Apr 29, 2009 | 2000 Hyundai Elantra

1 Answer

Took transmission pan off and can't find filter


2002 Hyundai Elantra has 2 trans filters. One is inside the pan which is mounted vertically. The other is located on top of the transmission case.

Apr 22, 2009 | Hyundai Motor 2002 Elantra

Not finding what you are looking for?
Hyundai Motor 2002 Elantra Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...