Question about 2008 Nissan Sentra
Could not find fuse for license plate lights
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the license plate because of its position gets a lot of dirt and water problems so i would go back and take another good look remove the bulbs again and see if you can clean the inside with a little sand paper or a little scrape with a small screwdriver then spray with a little sileacone oil replace bulbs.Then switch lights on they should be ok if not try moveing them slightly with your fingers they should light.please let me know how you get on.adrian
Posted on Feb 18, 2009
I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.
Posted on Feb 28, 2009
The licence plate lights are in the same line as your tail light wiring assembly. I assume your tail lights are working or you would have got a ticket for that. The wire is either cut, broken or unhooked from the tail light wires (which usually are brown). If you can not find the problem, you can always run a new wire to the tail light wire from your licence plate wire. Then they should work.
Your other problem is that the license plate ground is rusty & not grounding, which would also not let them work, so you should probably check that first. Rick
Posted on Apr 14, 2009
SOURCE: brake light, 2008 Nissan Sentra
Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.
Posted on Jun 21, 2009
Tips for a great answer:
Aug 21, 2016 | Ford Cars & Trucks
Jan 05, 2016 | Suzuki Cars & Trucks
Dec 16, 2015 | 2003 Chevrolet Impala
Dec 10, 2015 | Ford Cars & Trucks
Nov 27, 2014 | 2004 Toyota Tacoma
Apr 12, 2012 | 2007 Audi A4 Convertible
Feb 17, 2011 | 2004 Chevrolet Impala
Dec 05, 2009 | 2003 Toyota Matrix
May 23, 2009 | 2005 Chrysler 300
954 people viewed this question
Usually answered in minutes!