Question about 1995 Toyota Camry

1 Answer

Turn signals are not working after changing fuse

Switch to a 10 amp worked but blew out again

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

One of the indicator wiring harnesses is shorting to the car body .take each globe holder out and check the wires are not traped etc check tow plug if u have one.

Posted on Dec 02, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: no brake lights, fuses keep blowing and wont shift out of park

I would look for a wiring short in the trunk at the taillamp area, or, inspect the sockets for the taillamp bulbs for corrosion. In any case, you have a short circuit in the trunk area, also check the wire that comes from the body & goes up the trunk hinge on the driver side; that wire may be chafed, and it may be shorting out. Hope this helps; please get back to me if you need any further assistance.

Posted on Nov 04, 2008

  • 566 Answers

SOURCE: turning signal and 4-way hazard flasher not working

the actual hazard lights switch is also a relay and linked to signals left/right try checking this out ?

Posted on Nov 27, 2008

  • 3 Answers

SOURCE: 1992 toyota 4runner

what is the black lose wire hanging lose in back i think the drivers side in the back compartments

Posted on Jan 19, 2009

  • 4 Answers

SOURCE: cig lighter fuse blew. renewed but cig lighter and remote key not

you probably didnt change the right fuse and had another one blown at the same time you also could have a primary fuse under the hood that blew. once fixed dont use pump again. not same amps drawn

Posted on May 06, 2009

roniecon
  • 6826 Answers

SOURCE: When I turn on my A/C the fuse blows out. What's the solution?

blower motor bad or ac clutch bad,,check blower resister as well,it is in the blower box ,blower motor is the most comon to do this

Posted on Jul 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why aren't hazard lights or brake lights working?


Brake lights /rear hazard lights not working - Ford Truck ...

www.ford-trucks.com > ... > 1967 - 1972 F-100 & Larger F-Series Trucks
Jul 9, 2010 - After checking the brake lights I tried the emergency flashers and found that they are working in the front but not in the back. I do have rear turn ... 1995 F350 Brake Lights / Turn Signals not working
Jul 9, 2012
Turn Signals and Brake Lights Do Not Work
Mar 10, 2012
Turn Signal, Brake Lights, & Rear Hazard not working
Aug 3, 2010
Rear Turn Signals, Hazards and Brake Lights not working....
Aug 29, 200

Sep 30, 2015 | Cars & Trucks

1 Answer

1998 plymouth breeze hazard flasher fuse keeps blowing


check the hazard switch pull the switch and put a volt meter on the connections with wiring connected to switch if it don't respond or just gives you a L.O your switch is bad and shorting out could happen just from being used a lot or something internal broke switch for that shouldn't be all but 50$ or just go to a parts/scrap yard

Jan 22, 2014 | 1998 Plymouth Breeze

1 Answer

Turn signal & hazard light switch


does all else work? car run and drive and head lamps work at same time, yes,then you blew the turn/haz fuse in the fuse box.
the operators guide answsers were those are. read it.

Dec 21, 2013 | 1988 Honda Prelude

1 Answer

My 1997 buick lesabre keeps blowing fuses. first it blew the turn signal fuse which is a 20 amp replaced it with a 20 and it blew when i turned on the signal. put in a 25 to see if it would work and it...


I strongly suggest your first priority will be to discover why your tail lights are seemingly consuming many times more current than they should. A 30 amp fuse has less resistance than a 10 amp though the difference is hardly measurable.

I suspect when that is sorted out the other faults could disappear without further effort.

It is time to find a circuit diagram and to trace the tail light wiring from the supply to the lamps in order to discover what went wrong.

Mar 08, 2017 | Cars & Trucks

1 Answer

The left turn signal stopped working, then the right. Now the blower and the abs light is on. I changed the turn signal switch/hazzerd/wipers. And the 10 amp fuse keeps blowing. Marked turn/bu/abs


20amp turn on four ways and parking lights go around replace any bad bulbs turn of for ways tern key on tern right tern on go around se if blinking tern on left and se if not chang flash thears 2 flashers switch the tow to se witch is bade.chek fuse for the right amp look inside fuse cover for right amp

Jan 26, 2010 | 2000 Dodge Caravan

1 Answer

The turn signals do not work on 2000 nissan exterra.Fuse was blown. Replaced and blew again after a few seconds.


1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

Jun 11, 2009 | 2000 Nissan Xterra

3 Answers

1995 Nissan Pickup, Blown turn signal fuse


you might need a Turn Signal Column Switch, I have a 1993 Nissan Pickup and my fuse blew all the time. I dexed that problem i have some wires in the back of the truck that was rubbing on the frame. Now my running lights are not working and when i turn on my head light one will come on so i will have to turn on and off about 10 times then both of them will come on, so my turn signal switch is bad.
s.gif

Oct 22, 2008 | 1995 Nissan Pickup

1 Answer

Passat Indicators Blowing Fuses 2005 model


It sure sounds like a short in the left signal circuit. I can't say where the wires are routed but you may have one with failed insulation or pinched under some hardware.
You could avoid repeated fuse replacement if you buy a cheap digital multimeter from Radio Shack (if you are in the US) or alternately, from an auto parts store. One adequate for this would be under $20 US. Some have a continuity checker that sounds a 'chime' that stops when the resistance level rises a bit. Since the meter could be damaged if the short clears, it would be smart to disconnect the negative side (ground) of the battery. Putting the probes across the fuse contact will simulate the fuse for this checking but it will not let your signals function. I would punch the probes into the fuse holder, put on the left turn signal and start removing bulbs and checking the routing of the wiring. When the chime stops, you have found the culprit. 

Sep 19, 2008 | 1999 Volkswagen Passat

1 Answer

Turn signals wont work but flashers do


Hi.
On your 98 Dakota.
Is equipaded with a single Flasher.
If you replace all ready.
Check the FUSE # 10, 15 amp..
On the Fuse box. left side of Dash.
and the FUSE D 25, amp. On engine compartment Fuse box.
Check the proper funtion of the HAZARD switch.
Bacause if the Hazard switch is bad the turn signal don't will work. Match the OLD flasher with the New one.

If after of this still not work.
Remove the steering wheel cover, locate the Turn signal switch connector and with a TEST Light check power with the Key ON
12v. to the RED wire and PINK wire..
If you found 12v. check the connection with the switch.
If the connection is good. you will need to replace the turn signal switch.
But if you don't found 12v. You need to look a an open circuit.
And fix it..

I hope this help on your problem..
Thank you for use fixya...

Aug 31, 2008 | 1998 Dodge Dakota

Not finding what you are looking for?
1995 Toyota Camry Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...