Question about 2004 Honda Accord

Open Question

How to remove seat panel from back of my honda accord front seat

How do i remove rear panel from honda front seat

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 16 Answers

SOURCE: Seat adjustment forward and back stuck

the lever has a wire that connects to the other side of the seat track make sure that wire is still connected.

Posted on May 30, 2009

Ad
  • 41 Answers

SOURCE: Remove seat from second row in Honda Mini Van 2007

on the passenger side feel under the seat and there is a lever that pulls toward you as you stand at the sliding door.

First, raise the armrest, then lower the back all the way forward. Then remove the headrest sit it out of the way and while pulling the lever under the seat towards you, lift up the seat from the back so it tilts forward. When it is standing on its "nose" lift first one side shifting it either forward or backwards to clear the rod on which it is hooked. Do the same with the other side of the seat and then lift it out. Installation is the reverse of removal.

The other seat is much the same, though sometimes the lever is a little different but in the same place.

Good luck,
bob

Posted on Jun 09, 2009

  • 1986 Answers

SOURCE: Door panel removal from 2005 Honda Accord

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 89 Answers

SOURCE: 2003 Honda Accord sedan - passenger seat does not recline

You have to check the power to the recliner motor. If there is power, then replace the motor.

Posted on Sep 12, 2009

philschneide
  • 448 Answers

SOURCE: 1995 Honda Accord Car seat install problem

I can't be of much help, except to indicate what Honda says about the seats, and to give you a URL to look at:
Using a Seat Belt Locking Clip
Always use a seat belt locking clip when you secure a child seat to your car with a lap/shoulder belt. This helps prevent the seat from shifting position or overturning. A locking clip is usually included with the child seat. If you need a clip, contact the seat's manufacturer or a store that sells child restraints.
The URL will take you to a more complete reference to your car manual regarding child restraints.
https://techinfo.honda.com/rjanisis/pubs/om/AC9595/AC9595O00020A.pdf
Hope this helps you.

Posted on Nov 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 honda accord drivers power seat stuck in the down position.


Could be defective adjustment switches rather than motor

Oct 10, 2016 | 2004 Honda Accord

1 Answer

How do u remove the rear seat on 1196 honda accord?


The rear seat is four (4) pieces.
You will need two tools a 6mm and 8mm wrenches.
1.) Unbuckle the rear seat belts. 2.) Locate the bolt in the center part of the rear seat, between the cushion and the seat-back. Remove the bolt with a 6 mm socket wrench. 3.) Push down firmly on the front edge of the rear seat cushion and pull it toward you to unhook and remove the rear seat cushion. Push the seat belt stalks through the center holes and lift the cushion out of the Accord. 4.) Pull the lever on the side of the rear seat bolster to lower the rear seat-back, which must be in the down position to access its bolts. 5.) Slide the center seat belt toward the passenger side of the vehicle. Move the loop over the edge of the seat-back to prevent it from hindering removal. 6.) Remove the three bolts from the bottom edge of the rear seat-back, using an 8 mm socket wrench. One bolt is in the center; the other two bolts are on either side. 7.) Pull the rear seat-back out of the Accord. The remaining sections of the seat should be the two side bolsters. 8.) Remove the bolts from the bottom of the side bolsters with a 6 mm socket wrench. Push firmly against the first side bolster. Push it upward to slide it out of its mount. Repeat the process on the bolster on the other side to finish removing the Accord's rear seat.

This should take approximately 15-30 minutes depending hoe mechanically inclined a person is.

Sep 17, 2014 | 1996 Honda Accord

1 Answer

How to remove rear seat in 2008 accord ( the seat you sit on)


Most back seats have two hooks on either side of the seat. Pushing in quite hard on the front of the seat and lifting it up is the usual way to release them. Hope this helps.

Mar 19, 2011 | 2008 Honda Accord

2 Answers

Need to replace the fuel pump in a honda accord coupe 2000


What would you like to know before proceeding with this procedure???

Jan 23, 2010 | 2000 Honda Accord

1 Answer

Is there a rear seat release on a 94 accord


I believe this procedure applies to your 94 Accord:
With your hands, press down on the seat cushion where it meets the seat back. Locate the retaining bolt(s). Some models retain the seat with one bolt in the center; others use two, evenly spaced left and right.
Remove the retaining bolt(s).
Lift the back (toward the rear of the car) of the seat bottom upwards while rotating it toward the front of the car.
Disconnect the hooks at the front edge (during the rolling motion) of the seat and remove the seat bottom.
Remove the carpet (in the luggage compartment) from the rear of the seat backs.
Remove the seat back mounting bolts from the luggage compartment side.
Lift out the seat back.
If the rear side bolsters or pads are to be removed, remove the lower mounting bolt, then push upward to free the hooks.
Hope this helps you.

Dec 21, 2009 | 1994 Honda Accord

1 Answer

How do you remove the rear seat of 2004 honda accord


Release the two latches at the front of the seat cushion (pull back on the latches to release the front of the cushion).

Remove the seat cushion bolt and remove the cushion (it’s roughly in the center. You have to insert a socket extension between the back and bottom seat cushions to take it out, after you find it by pressuring the bottom cushion and looking back in there).

Remove the bolts (each side) securing the seat side bolsters (they are easy to see once the bottom cushion is removed), then remove the side bolters (gently release the clips that hold them in).

Pull the seat forward, then remove the fasteners securing the seat hinge (seat pivot bracket) and remove the seat backs.

Hope this helps you.

Dec 10, 2009 | 2004 Honda Accord

1 Answer

Remove backseat of honda accord 1991


With your hands, press down on the seat cushion where it meets the seat back. Locate the retaining bolt(s). Some models retain the seat with one bolt in the center; others use two, evenly spaced left and right.
Remove the retaining bolt(s).
Life the back (toward the rear of the car) of the seat bottom upwards while rotating it toward the front of the car.
Disconnect the hooks at the front edge (during the rolling motion) of the seat and remove the seat bottom.
Remove the carpet (in the luggage compartment) from the rear of the seat backs.
Remove the seat back mounting bolts from the luggage compartment side.
Lift out the seat back.
If the rear side bolsters or pads are to be removed, remove the lower mounting bolt, then push upward to free the hooks.
Hope this helps you.

Oct 17, 2009 | 1991 Honda Accord

1 Answer

Remove rear passnger rear door panel 1991 honda


As I remember, you need to remove the front seat belt mount, & completely remove the back seats, in order to remove the rear door cards, without breaking them.
Have fun;)

Jul 17, 2009 | 1991 Honda Accord

1 Answer

Seat stuck


Most of the time its the little worm gear that went bad not the switch (the gear is slipping on the fixed bracket) I pushed back on the seat real hard and hit the switch and Mine went back finally, the track/motor assembly will have to be replaced(250 from Ford) Very Common problem . ----------------------- to remove the seat  First disconnect the connectors under the seat. Remove the 3 bolts (Front Left, Front Right, Rear Right). Remove the nut from the Left Rear. Lift seat up and out. 

thanks.

Apr 01, 2009 | 1993 Honda Accord

1 Answer

Honda Accord brake light removal


It's a lot of work for just cleaning.
Fold the rear seat down and remove the two 12mm bolts on the bottom corners of the seat back, pull the seat out.
Between the seat bottom and the carpet you will find two tabs you need to pull and then pull the seat bottom up and out of the car.
Remove the two 10mm bolts securing the seat bolsters to the area the seat bottom was covering. Pull the seat bolsters up and out of the car.
Pop the "C" pillar trim off of the car (above the parcel shelf and beside the rear glass) (side airbag vehicles have a slightly different procedure.)
Pull up on the parcel shelf carefully and evenly. Remove clean and put everything back together.

Aug 16, 2008 | 2005 Honda Accord

Not finding what you are looking for?
2004 Honda Accord Logo

Related Topics:

229 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...