Question about 1992 Pontiac Grand Am

Open Question

Location of '92 grand am water pump

Car is leaking water trying to locate the water pump

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: car won,t fire,fuel pump location 2004 grand am

inside the gas tank

Posted on Dec 25, 2008

txkjun
  • 409 Answers

SOURCE: car stopped,,cranks but won,t fire,,2004

Did you check the ignition system for spark? The fuel pump is in the gas tank. There should be a test port on your fuel rail that looks like a tire valve with a cap on it. Have someone crank the car while you depress the schrader valve and see if you get fuel. Do that first then get back to me.

Posted on Dec 25, 2008

Bat1956
  • 585 Answers

SOURCE: need location of fuel pump on 2002 grand am

Remove the back seat, there should be a cover to remove allowing easy access to the pump.

Posted on May 15, 2009

  • 491 Answers

SOURCE: fuel pump location 2001 pontiac grand am

The fuel pump is in the fuel tank.Sit in the car.....turn on the ignition switch to run.....listen very closely to the rear of the car...or have someone kneel down by the back wheel.....you should hear a "prime cycle"......the pump running for 2 or 3 seconds if the key was off for 15 seconds before trying this.If you hear silence you most likely need a fuel pump.Before pulling the tank down....check for power on the gray wire at the fuel tank connector just ahead of the rear axle under the car.Check for power with a test light that will last for 2 to 3 seconds as you turn on the key to run.Power means you really most likely need a pump.No power means you may need a fuse or a fuel pump relay.

Posted on Aug 11, 2009

johnjohn2
  • 5763 Answers

SOURCE: Locate the power steering pump and lines

heres a couple of picture diagrams to help you, the most common area for a leak on these is the cooler line, this is the return line in which it is snaked in a s type shape to cool the power steering oil, these cooler line rots and leaks, so take a look at this first, its located at the bootm of the frame on the left side under the engine,hope this helps.

Posted on Apr 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yellow fluid leaking onto serpentine belt


yellow fluid is most likely anti freeze. check the radiator hoses but because of the location, my guess is that it is the water pump leaking. make sure you change the tension pulleys when you change the pump.

May 03, 2014 | Dodge Grand Caravan Cars & Trucks

1 Answer

Searching for a diagram of the 2006 Dodge Grand Caravan engine indicating where the water pump is located on the engine.


If it is a 3.0 the water pump is located under the timing belt cover, which is probably why you can't locate it. WARNING If this is the case be very careful. Although the water pump has a "weep hole" because of the pumps location, it is VERY difficult to locate or even notice a water leak. If you have water pump issues, it is very easy to overheat these engines to to the point of serious damage. Please get back to me with your engine size so that I can be more specific. Hope this helps! Dano

Jun 30, 2011 | Dodge Caravan Cars & Trucks

1 Answer

Need to replace my water pump do you have a diagram


5.3L Grand Prix Engine
  1. Place a drain pan underneath the radiator. When the engine is cool, drain the cooling system from the radiator into the pan.
  2. Remove the battery from the engine along with its tray.
  3. Take the drive belt out of the engine.
  4. Loosen and remove the three bolts to the water pump and remove the pump, throwing away the gasket.
  5. Clean the gasket mating surfaces and install the new water pump with a new gasket, tightening the bolts to 89 inch pounds (10 Nm).
  6. Reinstall the drive belt and the battery with the battery tray.
  7. Refill the engine's cooling system with coolant. Start the car and check for leaks when the engine reaches normal operating temperature.
3.5L Grand Prix Engine
  1. Partially drain the coolant from the cooling system.
  2. Disconnect the surge tank outlet hose and remove the drive belt.
  3. Remove the idler pulley and the water pump pulley, making sure to note the locations of the bolts as you remove them as they are various lengths.
  4. Loosen and remove the bolts to the water pump, also taking note at their locations, and remove the pump.
  5. Install the new water pump with a new gasket, tightening the bolts to 124 inch pounds (14 Nm).
  6. Reattach the water pump pulley, tightening the bolts to 106 inch pounds (12 Nm).
  7. Reinstall the idler pulley, tightening the bolts to 37 foot pounds (50 Nm) and install the surge tank hose and drive belt.
  8. Refill the engine's cooling system with coolant.
  9. Start the car and check for leaks when the engine reaches normal operating temperature.
3.4L and 3.1L Grand Prix Engines

  1. Place a drain pan underneath the radiator. When the engine is cool, drain the cooling system from the radiator into the pan.
  2. Disconnect the negative battery cable.
  3. Remove the accessory drive belt guard and the accessory drive belt.
  4. Loosen and remove the water pump pulley bolts and remove the water pump pulley.
  5. Remove the water pump bolts and remove the water pump.
  6. Install the new water pump along with a new gasket, tightening the bolts to 89 inch pounds (10 Nm).
  7. Reinstall the water pump pulley and tighten the bolts to 18 foot pounds (25 Nm).
  8. Reattach the accessory drive belt with the drive belt guard.
  9. Refill the engine's cooling system with coolant.
  10. Start the car and check for leaks when the engine reaches normal operating temperature.

Dec 31, 2009 | 1999 Pontiac Grand Prix

2 Answers

Have an antifreeze leak


The water pump is located on the passenger side of the vehicle, directly inboard of the strut tower. If you look at the serpentine belt it is the more central of the pulleys.
Good luck, let me know.
Regards,

May 17, 2009 | 1997 Pontiac Grand Prix

1 Answer

1. My grand prix gtp has problems with leaking on the passenger side. I cannot locate the leak. 2. My engine runs too hot when ideling. I changed the thermostat but this did not help. I need your assi


Make sure your cooling fans are coming on when the temp heats up. Are you talking about a leak inside the car or outside? Inside is usaully a drain tube for the A/C stopped up. Outside, look for a water pump or intake gasket.

May 12, 2009 | 1997 Pontiac Grand Prix

2 Answers

Water leak


sounds like the water pump they leak from the bottom of the pump

Dec 29, 2008 | 1993 Jeep Grand Cherokee

1 Answer

2000 jeep grand cherokee is leaking antifreeze


Have a shop pressure test the cooling system, this will make the leak easier to locate, if I have to guess I would go with a leaking water pump.

Dec 26, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1992 Pontiac Grand Am Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...