Question about 1999 Jeep Grand Cherokee

1 Answer

I,m trying to change the bulb in the front headlight and can.t get the old lightbulb out.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

You have to remove the one screw that is holding it down , located on top of light assembly, ( for my 1998 it has only one screw!) then proceed to pull the assembly from the bottom pulling up , then just turn the round knob on the back of the assembly and remove defective bulb and replace with the new one . good luck !

Posted on Jan 11, 2009


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 150 Answers

SOURCE: changing headlight bulbs on a 1998 olds 88

Open the hood find where the light are,there is a black socket going to them turn to the left and pull out,do not touch the new bulb with your fingers or the oil from them will burn the bulb out.

Posted on Feb 16, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to change lightbulb can't get headlight off, have taken out 3 screws and pin

think all you need to do is turn the bulb counter clockwise and pull it out

Aug 29, 2015 | 2006 Buick Lucerne


How to change the headlight bulb

First open your hood
Then reach in behind the headlight, there will be either a black or a gray plastic ring.
Turn the ring counter-clockwise until it is loose. Then pull back out of the way.
Next, grab headlight bulb & socket; Turn counter-clockwise and pull out to remove.
Lastly, using a flat-tipped screwdriver, Gentlry pry up on the tab to remove harness from lightbulb.

Reverse procedure to install.

on Jan 16, 2010 | Pontiac Bonneville Cars & Trucks

1 Answer

After changing the headlight bulb the beam is shinning way to high and am not able to adjust it. Can anyone help ?

I have the feeling you mounted the lightbuld 180 degrees reversed.

The little mirror in the bulb is therefore illuminating the low part of the projector. Try to reverse the lightbulb rotating half its size clockwise after unplugging. It should work then.

Apr 01, 2015 | Cars & Trucks

1 Answer


I would suspect the bulb is at fault or the connector to the bulb, but you don't say the type of headlights you have so that handicaps my diagnosis. As for aftermarket so called high intensity bulbs I would stay away from them.

Sep 18, 2012 | 2000 Acura TL

1 Answer

How to replace front and rear lamps

take out the headlights look at the back there are round pieces of rubber take whichever one u need to change off then just twist the back of the bulb counterclockwise and it should pop right out

Nov 30, 2011 | 1998 Buick Regal

1 Answer

Trying to remove the lightbulb from a passat 2006 the front light (headlights)

Just take off the back cover of the light housing, unplug the bulb, undo any retaining clips (VW often uses a swing-latch style metal retainer), and grab the base of the bulb. Twist it to unlock, and it should come right out.

Dec 06, 2009 | 2006 Volkswagen Passat

3 Answers

How do i change the lightbulb in the headlight?

To change the low beam headlight on the 2001 Lesabre, the headlight assembly must first be removed from the car. It is really quite simple to do. There are two bolts on the top of the assembly that must be removed - that is all! The entire assembly comes out and gives easy access to the low beam bulb. Give it a 1/4 counterclockwise turn to remove it. Plus in the new one (#9006) and reverse the procedure.

Oct 30, 2009 | 2004 Buick LeSabre

2 Answers

Lightbulb driver side 2008gmc 3500 6.6l

how to change driver side headlight bulbs?

May 30, 2009 | 2008 GMC Sierra 3500HD 2WD

3 Answers

I cant seem to get lightbulb out

if it is on an 2001 eclipse there is a steel locking clip holding it, remove the boot then release the spring bar if you can't there is a screw holding it just remove the screw and wiggle the clip off

May 28, 2009 | 2001 Mitsubishi Eclipse

3 Answers

Audi A4 2003 Change RH frontIndicator bulb

I've just replaced mine so here goes. Undo the top two bolts first. Then remove the two screws above the radiator holding the air intake ducting in place and gently pull out the air intake pipe and move to the back of the engine, exposing the rear of the lightbulb housing. To the rear of the lightbulb housing is a bolt. You should only need to loosen the bolt and this will allow the lightbulb unit to be pulled forward clear of the car. On the back of the housing you will find a cover, remove the clip retaining the cover and fold it away, exposing the rear of the light bulb.

Aug 10, 2008 | 2003 Audi A4 Cabriolet

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides