Question about 2001 Audi allroad
Could be horn (high or low tone?) could be fuse if both arent working or clock spring.
I’m happy to assist further over the phone at https://www.6ya.com/expert/howard_977676954994c5b2
Posted on May 31, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: p0431 code on audi allroad 02
Typcally caused by one of the front oxygen sensors or a bad ground associated with these sensors.Replace both front sensors with direct fit type NOT universal, because there may be a cracked wire and the universal sensor does not contain the complete wire harness. Direct fits, are about $20 more than universal fit type.
The O2 sensors have integrated heating elements that bring them up to the proper operating temperature. Code P0431 indicates that the O2 sensor on your driver side catalytic converter is not reaching the proper operating range. The O2 sensors are usually in the $150 range online.
Posted on Jun 30, 2010
Not 100% sure on yours but normally you'll either have a couple of bolts way down under seat cushion at front, near floor, or in some cases, you have to push seat cushion back toward rear window, hard & lift, to pop it out of notched catch under it.
Posted on Mar 14, 2009
SOURCE: Audi A6 Allroad
jack the car up saftely then take the wheels off .. then you will see the brake calipier turn the wheel towards you so the calipier is facing you . at the bottom of the calp you will see a small bolt at bottom undo this and lift prize the calp up then remove 1 pad the inside on where the piston is then put calp back down and put the bolt back in just to hold it in place then when you have done this put a large stronge screw driver in via hole in front to push the piston all the way back but make sure you do the evenly and piston goes in straight or it will get stuck same with all types of brakes. once you have done this reopen calp and take the other pad out clean all area with a wire brush and replace the new pads in place,, and retighten bolt etc , before you start the other side please make sure you pump brake peddle until it goes hard again. then do same to over side ,
hope this is a great help matdav69
Posted on Apr 07, 2009
Google this "User manual download for Audi allroad" and a whole list of sites come up all with free downloadable manuals.
Hope this helps!
Posted on Oct 09, 2009
Tips for a great answer:
Dec 15, 2013 | Audi AllRoad Cars & Trucks
Dec 04, 2012 | 2002 Audi allroad
Jun 28, 2012 | Cars & Trucks
Jun 04, 2012 | 2001 Audi allroad
Feb 09, 2012 | 2001 Audi allroad
Dec 14, 2009 | 2001 Audi allroad
Oct 09, 2009 | 2001 Audi allroad
Mar 14, 2009 | 2001 Audi allroad
Nov 21, 2008 | 2002 Audi allroad
124 people viewed this question
Usually answered in minutes!