Question about Cars & Trucks

1 Answer

Tata safari dicore 2006 model the DTC is P0215 and the engine is not starting, after cranking and ignition on time the ( glow plug lamp, check engine lamp, and diesel filter lamp indicator are blinking,) and again ignition switch off and on the indicators is working normal and after cranking same ( glow plug lamp, check engine lamp, and diesel filter lamp indicator are blinking,) ! battery open circuit voltage is fine, and diesel filter is fine, please tell me the answer , where is the problem my customer is waiting for vehicle. pls give mew the answer thank u sir

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have problem with my tata safari 2006
Cranks but not start
Check engine light not displaying when ignition key turn on
What can I do ?

Posted on Dec 13, 2015

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 102 Answers

SOURCE: 2002 Jetta TDI check engine light

very common for the harness that plugs onto the glow plugs to have too much resistance it will still work but will set codes

Posted on Mar 23, 2009

  • 1 Answer

SOURCE: Jaguar glow plug problem

electronic EGR valve

Posted on May 18, 2009

motor1258
  • 6674 Answers

SOURCE: 1962 CHEVROLET TRUCK with points

If/How long will it crank over before it stops? Are you saying it will crank over, but very slow? Has it been sitting quite a while. Got good spark, and fuel?

Posted on Jan 01, 2010

  • 37 Answers

SOURCE: working on 2006 dodge sprinter

I did this exact thing.. I see your date of posting is a while ago, however let me know how you ended up.. If you leave the battery connected while installing the relay you can short it out causing the problem all over again.. also there is a couple points that run along that wiring harness that are known to rub through.. let me know how you did!

Posted on Feb 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tata sumo grand 2.2 dicore engine fault code p2147 why ani praplam


according to the vechcial code look into the fuel injection system for voltage problem

Dec 10, 2016 | Tata Cars & Trucks

1 Answer

2006 chevy silverado duramax hd 4WD has codes u1016 /c0035/co201/po673/675/677 but runs great


DTC P0671: Cylinder #1 Glow Plug Control Circuit
DTC P0672: Cylinder #2 Glow Plug Control Circuit
DTC P0673: Cylinder #3 Glow Plug Control Circuit
DTC P0674: Cylinder #4 Glow Plug Control Circuit
DTC P0675: Cylinder #5 Glow Plug Control Circuit
DTC P0676: Cylinder #6 Glow Plug Control Circuit
DTC P0677: Cylinder #7 Glow Plug Control Circuit
DTC P0678: Cylinder #8 Glow Plug Control Circuit

Circuit/System Description
The glow plug controller has the ability to perform internal checks, an open or a short to ground on each of the glow plug circuits. If the glow plug controller senses a problem in a glow plug circuit, the glow plug on the affected cylinder will be disabled and the glow plug controller will send an error message to the engine control module (ECM). If this condition exists, the DTC will set.
Conditions for Setting the DTC
The glow plug controller detects that the glow plug control circuit is open, shorted to ground, or has more than 1 ohm of resistance.

Circuit/System Verification
Verify that DTC P064C is not set.
If DTC P064C is set, refer to DTC P064C.
Ignition ON, engine OFF, observe the scan tool Glow Plug 1-Glow Plug 8 parameters. All 8 Glow Plug parameters should closely match each other.
Refer to Testing for Intermittent Conditions and Poor Connections if you cannot duplicate the conditions.
Engine running, observe the DTC information with a scan tool. DTCs P0671-P0678 should not set.
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

DTC C0035 Left Front Wheel Speed Sensor Circuit
DTC C0201 Antilock Brake System (ABS) Enable Relay Contact Circuit
The system relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids and to the ABS pump motor. When the relay contacts close, the EBCM monitors the voltage supplied to the valve solenoids and compares this voltage to monitored ignition voltage.

Jul 30, 2016 | Cars & Trucks

2 Answers

How to check a ignition coil pack to see if its good,


the coil does not crank the engine , the starter does that, sorry.
(if you ever had to hand or foot crank and engine , youd under stand that. (like motor cycles or boat engines, or per 30s cars.)

in fact will crank all day with no spark parts on car..

x2, the scan tool does tell you why there is NO STARTS, CRANKS OK. The pcm can detect, one missfire in 10 cmp;ckp signals.
  • CRANK FOR 5 SECONDS
  • release, key
  • scan tool has DTC errors?, read the believe them.
no engine stated of 4 or more,

U checked everything but spark,
why, check spark at all cylinders, all most fire or the engine will not run or stall.
That test be first, if not starting (AFTER SCAN TEST)

IF NO spark fuses are next , not last.
lets do no start fails tests. (cranks perfectly 200 to 300 rpm)
  1. : check fuses
  2. key on, CEL lamp must glow, if not , ECU fuse blown.
  3. crank with scan tool , see P03xx DTC errors, see RPM dead.?
  4. check for spark? got spark x4 or times number of cylinders?
  5. got spark try test fuel now, runs for 3 seconds?
  6. yes, runs on test fuel now means lost fueling
  7. no, dont run on test fuel, means, 1 to 5 done wrong above or engine compression bad.
  8. bad fueling, huge number of tests. check fuel pressure now.
confused, try a shop and watch them, learn.

Jan 12, 2015 | 2005 Suzuki Forenza

1 Answer

2006 deisel parthfinder starts and stops


then starts again, and repeats??? gee.? or wont"?
fuel filter dirty?
bad fuel?
is it cold?
are the glow plugs ok
are warning lamps going unheeded? is the check engine light on running. did you scan the pcm for dtc errors?

Jan 08, 2015 | Nissan Cars & Trucks

1 Answer

Tata safari 2.2dicor timing marks


I need help for tata bakkie dicor timing mark for head double cam ,diesel pump to crankshaft mark plz

Apr 09, 2014 | Cars & Trucks

1 Answer

In TATA Safari Dicor ,After starting My Car's Engine ,The Check Engine Indicator Blink's & the Vehicle Pickup Drop's When It get's On i just Wanted To Know weather it harm's my car's Engine much


That sounds like a problem that could become worse if ignored. It might also be a plugged fuel filter or bad O2 sensor. Get the codes checked and see whats needed to correct the problem.
Those are the two things i can possibly think may be wrong, wither something in the fuel system or a bad sensor.

Aug 12, 2013 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...