Question about 2008 Jeep Patriot

Open Question

2009 Jeep Patriot P0420 - 2008 Jeep Patriot

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 295 Answers

SOURCE: remove car stereo in a 2009 jeep patriot

Turn the key on applie E-brake move the shifter to the lowest postion to be able to remove the center bezel. with a small plastic pry tool pry the gray bezel out. Caution use caution don't pull the bezel out all the way u can break the A/C control lines. turn the bezel to the side so you can remove the radio. 4 philips head srew hold the radio in. remove the radio and disconnect electral connecter. hope this helps..

Posted on Jul 09, 2009

Ad
  • 811 Answers

SOURCE: I have a 2009 Jeep Patriot and the horn is not

see if horn has adjustment, screw

Posted on Sep 12, 2009

  • 6982 Answers

SOURCE: amateur radio installation in 2009 jeep patriot

To run any wire through the firewall, find a spot that is both reachable and unobstructed on both sides of the wall. I generally use a very short bit so after penetrating, it does not accidentally plunge into other wiring or components, or I use a collar over the bit (a small piece of tubing, leaving only 1/4" of bit exposed) I sometimes also "cheat" by poking a hole in the rubber boot where the steering column goes through.
Whenever passing a wire through sheet metal you must install a grommet. (if none are available, you can make one by using a piece of rubber tubing or the cut off end of an old tire valve.)
When tapping power from the battery, you will need to use a relay and switch attached to the "accessory on" side of the ignition switch, to prevent whatever you are installing from remaining on after the vehicle has been turned off. Use fuses in all new power sources as well to protect the vehicle and your new install from damage.
In creating a new circuit, you have the opportunity to use shielded wire, which will prevent stray electrical "noise" in your set" not a bad idea to do that.
good luck

Posted on Oct 18, 2009

oldmanewtoys
  • 414 Answers

SOURCE: Remove & replace window cranks---- Jeep patriot 2009

you need to use a window crank removing tool and remove handle. Make sure window is all the way up before reinstalling handle on splines.

Posted on Mar 05, 2010

airjer995
  • 5332 Answers

SOURCE: 2009 jeep patriot, my esp,

What did the dealer tell you the problem was?

Posted on Sep 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I can't get my 2009 Jeep Patriot hood open. The cable works, but the safety latch under the hood is either seized or frozen. How do I release it?


Try applying penetrating oil (WD 40) to the latch. Have somebody pull the cable open while you shake the hood by trying to move it up and down.

Mar 15, 2017 | 2009 Jeep Patriot

1 Answer

Where is the interior fuse box in the 2009 jeep patriot?


open glove box, read oper guide.
under hood.
the guide tells what/s on all car made. a fact.

posted this answer over 100 times,, ever like search
most jeeps over 2007 have no cab box called JB.
has totally integrated power module under hood
RTm


http://owners.mopar.ca/en/manuals/2009/2009_Caliber_Patriot_and_Compass.pdf

Jan 28, 2017 | 2009 Jeep Patriot

1 Answer

Belt routing diagram for 2009 jeep patriot 2.0


accessory belt.?
did you even open hood and look first, most have a sticker there
in plain site showing just that.....

2.0L
read the oper guide , nop , not there, that leaves only one place
not above.
the FSM
the factory service manual. bingo, buy the FSM, and be ready.

36ddee64-8c71-41b6-878b-b9c587aabfd9.jpg

Oct 16, 2014 | 2009 Jeep Patriot

1 Answer

Jeep patriot no heat


fan blows?
engine reaches and holds 180F or more , normal engine temp?
(use a IR pyro gun to measure it)
ever go a cooling system flush, if not the heater core could be packed full of junk.
id the dampers fail , its not in heat mode.
check the dampers after checking engine heat.

it only takes 2 things to make any water to air heat exchanger to work.
hot water
and actual air flow.

check for hot water first (engine coolant)

Feb 05, 2014 | 2009 Jeep Patriot

1 Answer

2009 jeep patriot 2.4 heater not blowing hot


Go To your local Firestone store located on 1802 state st. Erie,PA

Dec 11, 2013 | 2009 Jeep Patriot 2.4

1 Answer

2009 jeep patriot transmission problems


google jeep patriot forums join one or more and post there

Feb 06, 2013 | 2009 Jeep Patriot

1 Answer

Drive belt jeep patriot 2009, diagram?


Go to this site and go through the menu of your vehicle to the last page and there look for a link to "Routing" that will be a picture of your belt's routing around the pulleys. Dayco hope this helps FixYa up.

Sep 07, 2011 | 2009 Jeep Patriot

1 Answer

Remove & replace window cranks---- Jeep patriot 2009


you need to use a window crank removing tool and remove handle. Make sure window is all the way up before reinstalling handle on splines.

Mar 05, 2010 | 2009 Jeep Patriot

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...