Question about 2002 Oldsmobile Alero

1 Answer

2002 alero whats is the ets switch behind the shifter (towards the back seat

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 61 Answers

ETS stands for "Enhanced Traction Control." This switch enables you to turn it on and off.

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fold down rear seat in oldsmobile alero


LIFT THE REAR SEAT BOTTOM CUSHION UP SHARPLY AT THE TWO FRONT CORNERS UNTIL THE TWO CLIPS COME OUT OF THE BODY,THEN SLIDE THE SEAT CUSHION FORWARD AND OUT OT THE VECHICLE. AT EACH LOWER CORNER REMOVE THE NUTS SECURING THE TWO REAR SEAT BACK TABS WITH THE NUTS REMOVED PULL THE SEAT BACK FORWARD ENOUGH FOR THE TABS TO CLEAR THE STUDS THEN PULL THE SEAT BACK SHARPLY UP AND TOWARD THE INSTRUMENT PANEL TO DISENGAGE THE UPPER SEAT CLIPS FROM THE BODY.REMOVE THE SEAT BACK FROM THE VECHICLE.

May 28, 2011 | 1999 Oldsmobile Alero

1 Answer

I have a 2002 alero. Need to know where to plug in the radio antenna.


THE OLDSMOBILE ALERO DONT HAVE A EXTERNAL ANTENNA MAST. THE OLDS ALERO HAVE WIRE GRID ANTENNA INCORPORATED INTO THE DEFOGGER GRID IN THE REAR WINDOW.THE GRID ANTENNA HAVE A REAR WINDOW ANTENNA MODULE MOUNTED BEHIND TOP OF THE REAR SEAT BACK. THE RADIO ANTENNA CABLE GOES TO ANTENNA MODULE LOCATED TOP OF THE REAR SEAT BACK.

Jan 02, 2011 | 1999 Oldsmobile Alero

1 Answer

OLDSMOBILE ALERO 1999 MY KEYS ARE LOCKDED IN THE TRUNK...HOW DO YOU LIFT THE BACK SEAT


1) lift the back seat bottom cushion up sharply at the 2 front corners , until the 2 clips come out of the body, then slide it forward and out of the car

2) at the lower corner of the seat back remove the nuts securing the seat back tabs
3) With the nuts removed pull the seat back forward enough for the tabs to clear the studs , then pull the seat back sharply up and towards the instrument panel to disengage the upper seat clips from the body
4) remove seat

Jun 12, 2010 | 1999 Oldsmobile Alero

1 Answer

ETS malfunction


If the garage put a fuel pump in your fuel tank, and since then the gauge doesn't work, I would take it right back for that issue. The sending unit is what the fuel pump is attatched too, and controls the gauge.

Apr 10, 2010 | 2003 Oldsmobile Alero

2 Answers

Where is rhe air bag module on an Oldsmobile Alero?


Open the driver side door, Theres a fuse access there. Follow the Yellow-jacketed electrical line.

Mar 22, 2009 | 2002 Oldsmobile Alero

1 Answer

I cannot fold down seat


Try looking for a strap in your trunk it should be located at the upper inside of your trunk, there could be one or two straps, when you pull on these straps they act as a release lever for your rear seats, pull the straps toward you and push the seats forward from the trunk side.

Mar 11, 2009 | 2002 Oldsmobile Alero

1 Answer

Install back seat


Someone else had this problem and posted the solution online. I found it while planning to reupholster the drivers seat on my Olds Alero. Hope this helps, i've cut and pasted from wikianswers.... I had the same problem, hence my stumbling across this question this afternoon. i just spent a very frustrating hour working it out! first, to get an idea of how the black clips sit, place them in the rectangular gaps on either side at the front of the seat. the plastic clips sit in the rectangular hole, with the pointy ends facing up. the short one at the front. the short pointy end clips around the front edge of the rectangular hole. the longer pointy end that is now towards the rear of the car is meant to clip onto the wire that sticks out at the front of the seat. there is one on either side of the seat so it is easy to see them line up roughly. the pointy end doesnt clip around the u shaped bit that sticks out, but the striaght bit just behind that. now, if you can understand what i meant. it is time to install. take the plastic clip out of the rectangular hole. clip the long pointy end around the wire on the seat. lower it carefully into place. this is what i found the tricky bit. you can't see, so i lined it up by feel, and lowered it very carefully. then....... after trying many times to put in in place, a finally forced it in with brute stregnth and determination. you have to force it down towards the back of the car to make the clip latch into the rectangular hole. it took me ages to work out the frist one, then the second side only took a minute as i knew what to do. hope this was understandable and will help.

Mar 07, 2009 | 1999 Oldsmobile Alero

Not finding what you are looking for?
2002 Oldsmobile Alero Logo

Related Topics:

286 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...