Question about 2008 Ford Escape

Open Question

How to remove the dash board on a 2008 ford escape

To get to the blower resiter

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 110 Answers

SOURCE: removable of heater switch ford focus 1999 1.6

you need a flat head screw driver and prise it out

Posted on Nov 16, 2008

Ad
  • 84 Answers

SOURCE: ABS & traction control just went out on 2008 Ford Escape.

Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.

Posted on Feb 03, 2010

Coleman37
  • 337 Answers

SOURCE: 2008 Ford Escape Horn Fuse keeps blowing after

I would trace the wire from the horn and see if it was inadvertently damaged when the alternator was installed. If you have a voltmeter, you can remove the horn fuse and check to see if there is continuity between the horn (non hot side) of the fuse and the car body. This would indicate a short in the wire running from the fuse box to the horn. You can also look around the alternator mounting area to see if any wires are being pinched. Hope this helps. Good luck!

Posted on Mar 10, 2010

  • 70 Answers

SOURCE: cruise control ford escape 2002. ford escape

If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.

Posted on May 29, 2010

  • 49 Answers

SOURCE: an orange wrench symbol has

Doing some checking this is an issue with the HV battery and its normal operating temperature range where the temperature range is exceeded or an issue with the HVBT climate control system having a failure. You will need to take this to the dealer and have them run codes and to look at the temperature blend door actuator as well.

Posted on Jun 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No heat but blower works 2008 ford escape


The inlet pipe for the heater matrix has a temperature control valve usually under the windscreen known to sieze up try that first

Nov 23, 2015 | 2008 Ford Escape

1 Answer

Dome lights on my 2008 Ford Escape


many cars have switches on the dome lights, to not come on to come on, or to come on with only dash lights brightness knob , check the setting of yours

Mar 11, 2013 | 2008 Ford Escape

1 Answer

2008 FORD ESCAPE NOT GETTING HEAT BUT BLOWER IS WORKING


A possible cause is your heater core or an incorrect thermostat.

Feb 14, 2012 | 2008 Ford Escape

1 Answer

2008 Ford Escape heater blower no longer runs in position 1. Works great in positions 2 thru 4.


It could be the blower resistor. While I'm not familiar with the 2008 Escape, most resistors are located near the blower motor under the dash on the passenger side. It'll have a plug with several wires, and usually 2 screws holding it in.

Aug 07, 2011 | 2008 Ford Escape

3 Answers

An orange wrench symbol has appeared on my dash board. What does this mean? I have a 2008 Ford escape hybrid, 16,000 miles.


Doing some checking this is an issue with the HV battery and its normal operating temperature range where the temperature range is exceeded or an issue with the HVBT climate control system having a failure. You will need to take this to the dealer and have them run codes and to look at the temperature blend door actuator as well.

Jun 05, 2011 | 2008 Ford Escape Hybrid

1 Answer

2008 ford escape. The climate control fan runs only on speed selection no. 4. Does not work in speed selection no. 1, 2, and 3.


the problem is most likely is the blower motor resister.the info on the 08 this still limited. but i found this.


sgm1115_68.pngsgm1115_69.png

May 04, 2011 | 2008 Ford Escape

1 Answer

2008 Ford Escape Horn fuse keeps blowing after replacing alternator. Horn sounds once then the fuse blows. Also radio and song info that displays in the dash console with the compass does not work... The...


I would trace the wire from the horn and see if it was inadvertently damaged when the alternator was installed. If you have a voltmeter, you can remove the horn fuse and check to see if there is continuity between the horn (non hot side) of the fuse and the car body. This would indicate a short in the wire running from the fuse box to the horn. You can also look around the alternator mounting area to see if any wires are being pinched. Hope this helps. Good luck!

Mar 10, 2010 | 2008 Ford Escape

Not finding what you are looking for?
2008 Ford Escape Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...