Question about Scion xA

Open Question

HOW CLEAN THROTTLE BODY ON SCION XA - xA Scion Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 53 Answers

SOURCE: How do I clean throttle body on 2003 Hyundai Elantra GLS?

what u do is go to your local auto supply store and buy throttlebody cleaner you remove the rubber hose from the throttle body with the engine off of course u open the throttle and spray cleaner in it then use a tooth brush inside it replace the hose done
except it will be hard to start the first time crank engine over with foot to the floor on the gas pedal do not pump it

Posted on Oct 19, 2008

  • 1 Answer

SOURCE: How to remove trim piece around radio in Scion XA?

http://www.installer.com/pdf/99-8209.pdf

Posted on Jun 14, 2009

  • 30 Answers

SOURCE: need to change spark plugs in my 2006 scion xa

try this article. Its pretty simple.

http://scionlife.com/forums/showthread.php?t=16364

Posted on Sep 25, 2009

bulldogchief
  • 388 Answers

SOURCE: what oil is used for an 06 scion xa?

Recommended oil is 5W30. You can go one step better by using a synthetic 5W30 oil. It may a bit more expensive than conventional oil but it will extend the life of your car's engine (as long as oil changes are done on a regular basis). Cheers!

Posted on Dec 17, 2009

Testimonial: "Great! Synthetic all the way "

kapishtech
  • 2272 Answers

SOURCE: How do you replace the

Remove the three bolts and two screws from the front of the lens. You will need a ten mm socket with and extension to reach the outside recessed bolt. The other two are located directly in front of the radiator area and are easily removed. You may need to remove one or two screws holding the rubber seal. That depends on your model and year. Head light unit now slides out forward and allows access to the bulb connections. You may have to wiggle it a bit to get it to move. ------------- More detailed procedure as follows:-- Open up the hood. Get the Phillips Screw Driver in Hand. There is 4 Tabs with screws in them that hold the xA's Headlight on. Take the Screw driver and remove all the screws from those 4 points. In order to remove the bottom screw, you will have to pull away the bumper Up then Out Slowly and Gently at these points. Then push the bumper down, very little, just enough to stick the Phillips screw driver in and remove the 4th screw. It is alot easier than it sounds. After you remove the screws, gently pull out the headlight, remove the bulbs, (which in turn frees the headlight) and finish removing the headlight. Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Posted on Aug 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to clean my 08 scion tc throttle body?


Buy a can of CRC Throttle Body Cleaner

Instructions are on the back

Google a picture of it (Location)

ALWAYS bolted to the intake manifold
Some times in ducting before it

Cleaning it, is just cosmetic, for the most part

Makes the inside look nice

50/50 it will fix anything

Aug 11, 2014 | 2008 Scion Tc

1 Answer

How to clean the Throttle body on a 2010 Scion xB


I have never cleaned mine, I have a k&n air filter

Jul 08, 2014 | 2010 Scion xB

1 Answer

2011 Scion xb with 2.4 liter 4 cylinder engine. Intermittently, once warm it has a rough/slow idle and wants to stall. Sets a "lean condition" error code. Dealer "thinks" it is mass air flow sensor but...


well the dealer of course wants to replace it, throttle body on car tube has a plug in and this reads the amount of air that comes from the filter, check first to see if the filter is dirty, i noticed that if this gets dirty it will affect how your car runs, when i changed out my maf sensor, when i took it off of the throttle body that my car would run very bad, after i changed out my filter to a better one that it would run better, also check that the clamps are tight arounf the body if it is not i can cause it to run bad, hope this helps.

Sep 17, 2013 | 2006 Scion xA

1 Answer

Changed the battery in a scion xa and the alarm keeps going off when the battery is connected back


Scion XA PDF Manuals online Download Links at Scion ...

scionmanuals.com/scion-xa-pdf-manuals-online-download-links/
Here at Scion XA PDF Manuals online Download Links page,intended to offer Scion XA Owners available Electrical ... Scion XA 2004,2005,2006,2007,2008:

How To Replace Scion XA Key Fob Battery 2004 - 2006 ...

? 1:45
www.youtube.com/watch?v=1AWHK_flb9s
Aug 4, 2014 - Uploaded by Keyless Entry Remote Inc
This video will show you how to replace a key fob battery for a 2004 2005 & 2006 Scion XA.

Jan 21, 2013 | 2005 Scion xA

1 Answer

What coolant to use on xa scion 05


Toyota super long life coolant or a Ethylene Glycol based -non silicate,non nitrite,and non borate with long life hybrid organic acid technology

Oct 30, 2012 | 2005 Scion xA

1 Answer

What 16" tire size won't rub on scion xa


the correct size of tire is listed on the drivers side door frame

Oct 15, 2012 | 2005 Scion xA

1 Answer

DO I HAVE IAT INTAKE AIR SENSOR ON MY SCION XA 05'


Your intake air temperature sensor is part of the MAF (mass airflow sensor) and located right off the air filter housing in the large tube going to the throttle body.Its held on with 2 screws and has a 5 wire electrical plug going to it.

Apr 12, 2009 | 2005 Scion xA

1 Answer

IAT location on my Scion XA


Your intake air temperature sensor is part of the MAF (mass airflow sensor) and located right off the air filter housing in the large tube going to the throttle body.Its held on with 2 screws and has a 5 wire electrical plug going to it.

Jan 16, 2009 | 2006 Scion xA

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Brad Brown

Level 3 Expert

15451 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...