Question about 2007 Ford Expedition Eddie Bauer EL

Open Question

Code b2293 on ford expedition

Air bag light is on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
burzerko
  • 254 Answers

SOURCE: 2001 Ford Expedition XLT EB rear air bag suspension does not inflat

Sounds like the seals may have failed in the air shocks themselves. I also think you may have a bleeder valve problem. Follow the lines back and check the bleeder valve to see if it is leaking when you have someone else turn the vehicle on.

Posted on Jul 01, 2008

Ad
  • 373 Answers

SOURCE: air bag code

Hi, ON your 2002 ford taurus, The Flashing code 33 ( B 2292 )

This code refer to : Driver side seat belt pretentioner ( seat belt bucklet) problem.

Check the conecctions under the driver seat.
Repair as need, and recheck if thi code is present.

But if you had an accident on you taurus. You need to replace the Seat belt Pretentioner ( seat belt bucklet)

OK. I hope this information work for you.

Than's.

Posted on Jul 11, 2008

  • 142 Answers

SOURCE: Air Bag Code

Code 52 relates to low voltage detected in a capacitor inside the airbag module. 45 seconds after key on, this capacitor should have a voltage of around 23 volts.

This capacitor stores energy to deploy the airbag in the case of a collision.

Because your airbag light is on, your system is deactivated (cannot deploy)

In your case, the airbag computer detects less than 23 volts at that capacitor 45 seconds after key on, and disables the system.

There is a diagnostic procedure involved in fixing this problem, but usually means a bad airbag module (computer)

This should only be checked by a qualified technician, as airbag service can be dangerous and there are strict procedures to follow so the bags don't inflate suddenly and cause injury.

Posted on Aug 27, 2008

  • 15 Answers

SOURCE: air ride suspension 1997 ford expedition

If the compressor is working and actually pumping out air, might need to check your lines dont have a leak by disconnecting them from the bags. If pressured air is making it to the end of the line, then bags may need to be inspected and one or both replaced. However it is more likely that the lines are leaking or the compressor pump needs a service. Just a new set of rings in the unit. Good luck, hope it helps.

Posted on Dec 31, 2008

  • 4 Answers

SOURCE: 2007 FORD RANGER TROUBLE CODES #B2292, B2293

These 3 codes have to do with restraint system.
B2292 Seatbelt pretensioner fault.
B2293 Passenger front airbag fault.
B2691 Seatbelt buckle switch circuit fault Ft.driver side.

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is a b2293 code on 2003 mercury mountaineer


B2293

Pinpoint Test H: LFC 19 and 21/DTC B2293 - Restraint System Airbag Status
Normal Operation
The restraints control module (RCM) checks all of the front air bag circuits for faults. If the RCM detects one of the following faults on any of the front air bag circuits, it will store diagnostic trouble code (DTC) B2293 in memory and, depending on the fault, flash either lamp fault code (LFC) 19 or 21 (or higher priority code if one exists) on the air bag indicator.
Fault Conditions
The RCM monitors for the following fault conditions:
  • low resistance.
  • circuit open.
  • circuit short to voltage.
  • circuit short to ground.
Possible Causes
A driver air bag status fault can be caused by:
  • damaged wiring, terminals, or connectors.
  • a faulty clockspring.
  • a faulty driver air bag module.
  • RCM is faulted.
A passenger air bag status fault can be caused by:
  • damaged wiring, terminals, or connectors.
  • a faulty passenger air bag module.
  • RCM is faulted.
21 Restraint System - Air Bag Status (Passenger Front Air Bag Circuit Fault) Go To Pinpoint Test H .

Sep 06, 2016 | 2003 Mercury Mountaineer

1 Answer

I have a code B2293 and air bag light flashing 1-8 Can you help.


B2293 restraint airbags fault
18 right front/passenger frontal deployment loop (signal stage or stage 1 ) shorted to ground/ voltage out of range
Take vehicle to repair shop and have it repaired it will not protect you in a crash

May 21, 2016 | 2006 Mercury Grand Marquis

1 Answer

B2293 code on


it is your air bag control module .it is located inside just under the center console

Nov 29, 2012 | 2007 Ford Expedition Eddie Bauer EL

1 Answer

97 ford expedition air bag code flashes 2 1. What does that mean?


Code 21 is for the passenger side air bag circuit. Could be the air bag, the seat sensor, or a wiring problem.

Aug 06, 2012 | Ford Cars & Trucks

1 Answer

B2293 air bag


That might be a bad Drivers Side air bag Module you need to take into a Ford Approved Dealer , might be still under warranty

Sep 09, 2010 | 2006 Ford Escape

1 Answer

1997 Ford Expedition SRS causing 5 beeps


Until you get the trouble codes read there's no way to know what's causing the fault. So not, there's no easy fix without the codes

Jan 02, 2018 | 1997 Ford Expedition

1 Answer

Disarm and remove ford expedition air bags


Remove the negative cable from your car battery before replacing car air bags

Deactivate the air bag by removing the air bag fuses. Look in your car owners manual to locate the fuses

Unscrew steering column paneling and remove the airbag bolts on the back side of the steering wheel. Pull out the airbag until you see the back side and unplug the wires

Sep 24, 2009 | 2003 Ford Expedition

2 Answers

Airbag light flashing


Code 34:
Driver Side Air Bag Circuit Low Resistance or Shorted> Let us know if we can assist you further

Feb 28, 2009 | 2004 Ford Expedition

1 Answer

Have 2004 ford expedition, airbag light flashes 3 times pause 4 times. can someone help w/answers?


Airbag Error Code 34:
>>>Driver Side Air Bag Circuit Low Resistance or Shorted. Hope this helps

Feb 28, 2009 | 1999 Ford Expedition

Not finding what you are looking for?
2007 Ford Expedition Eddie Bauer EL Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5613 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...