Question about Honda CRX

Open Question

89 honda crx si wont start from the ignition switch

Car will not start with ignition switch but can push the car and start it and it runs fine and all lights and all work too

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: replaced ignition and steering wheel now car wont start -security light on

Hi......
On your Buick 94.
The problem is the ANTI THEFT SYSTEM..
If you have replaced the ignition switch.
If you are using a NEW KEY, the car won't start.
Because in the OLD KEY, is there a Resistence with a number of ohm's
The computer need the resistence to activate the the signals to operate the vehicle.
OK.. with the New Key and Old Key you can go to any Aloha Smith and they will remove the Chip from the Old Key to the New Key.
And the car must start and running.

But if you are using the Same Key that you have before the repair made.
I recomend to check the 2 Orange wires from the Ignition lock Cylinder to the steering column lower connectors.

Ok I hope this work for your problem.
Any moree info, I will glad to help you.
I'm a Mechanic and have all the repair information for all the cars.

Thank you for use fixya...

Posted on Sep 11, 2008

Ad
  • 365 Answers

SOURCE: honda crx

try to use the site www.autoshop101.com.i think they can provide you a good solution than i could provide.thank you

Posted on Dec 18, 2008

  • 3 Answers

SOURCE: Just installd newaltenator in 89 honda crx now no power no lights

MAke sure you are on a negative ground.

Posted on Jul 01, 2009

YellowNo5
  • 268 Answers

SOURCE: How do you install adjustable lowering coilover

NOT NECESSARILY IN ORDER: Remove the 2 nuts from the top of your shock tower under the hood - remove the pivot bolt at the bottom of your shock fork - remove the upper control arm ball joint nut - remove the lower control arm ball joint nut - bang on the thick metal near the ball joints with a hammer (not hitting the rubber or the ball joint's bolts - remove the tie rod ball joint nut and do the same with the hammer - pull the shock and spring assembly out - You might need a spring compressor to take out the stock spring safely - remove the nut on top of the shock - It's recommended that you replace your shocks now - install the new springs according to the directions with the package - get a camber correction kit for your car - put it back together and immediately go pay for an alignment. Good luck.

Posted on Oct 03, 2009

  • 1 Answer

SOURCE: wont rev over 3000 rpms in any gear

Try disconect the battery from the car. Wait a minute and reconnect. This should reset the computer. This happened
to my moms Honda FR-V. The mechanic had seen it before.
Its worth a try.

Posted on Oct 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1989 Honda crx si surges on the rpms. It will go from about 1800- 900 rpms and back again. What's wrong?


It's called hunting. You need to clean out the EAVC unit in the intake manifold. Take off the air filter and housing, run carb cleaner through the intake for 20 minutes or so.

Next bleed the radiator by taking the rad cap off and start the car, let the fan kick in twice (about 20 mins again) and the air bubbles will have been forced out.

Take the car for a spin and the vote for me when it's fixed :)

May 14, 2010 | 1989 Honda CRX

2 Answers

1990 crx base model honda civic want start


I would suggest an ignition module. If it is a rough idle at startup I would check the throttle position sensor. You can check that by starting the car and unplugging the TPS. If the car runs differently then chances are it is working fine.

Dec 04, 2009 | 1990 Honda CRX

1 Answer

1991 honda crx starter want engage. Starter turns over, but wont start by turning the key.


check the wire going to the clutch or tranny switch for power from the ignition switch if there is no power there the ignition switch needs replace

Jul 19, 2009 | 1991 Honda CRX

1 Answer

Wont rev over 3000 rpms in any gear


Try disconect the battery from the car. Wait a minute and reconnect. This should reset the computer. This happened
to my moms Honda FR-V. The mechanic had seen it before.
Its worth a try.

May 07, 2009 | 1991 Honda CRX

2 Answers

89 crx has power but wont start.


replace the ignition control module,I recommend a new one,if you order a rebuilt dist.it comes with a used one that only passed cold temp bench test they usually have problems once the car warms up. so get a new one!good luch let me know if you need more info have a good day DB

Feb 14, 2009 | 1989 Honda CRX

3 Answers

89 crx starts intermittendly


ignition module /coil igniter

Sep 25, 2008 | 1989 Honda CRX

1 Answer

89 crx


Just Take out all the fuses and replace them with the right size amperage on that fuse....

Aug 20, 2008 | 1989 Honda CRX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...