Question about Cars & Trucks

Open Question

Handbrake adjustment on honda frv - Cars & Trucks

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 21 Answers

SOURCE: How to dismount the horn on a Honda FRV?

the horn located if front of the radiator behind the front bumper. if you have any questions, email me at thadoggma420@hotmail.com

Sam

Posted on Jan 22, 2009

Ad
  • 53 Answers

SOURCE: My 92 Honda Civic Handbrake cable broke one

um might work but not for a very long time

Posted on Jul 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda Jazz 2007 1.4 rear pads and discs replaced no hold on handbrake still. Adjusted handbrake but still nothing could this mean I need new calibers? Thanks for the previous answers but there is no


Callipers are what hold the pads and the cylinders on the car. They have nothing to do with your problem. However they are attached by 2 bolts that are fixed to the axle housing mount. These bolts will rust up and not allow the callipers to move and centralize on the disc rotor. If you look at the callipers you will see 2 bolts that have what looks like a rubber seal under the head These are the bolts . Although you have adjusted the hand brake, if you have shoes inside the hub of the disc rotor they will have to be adjusted first and not just the lever.

Jan 14, 2015 | Honda Cars & Trucks

1 Answer

How do i tighten handbrake on honda crv 2007


yoiu dont touch the cable ,you remove the rear disks and adjust the shoes which are inside the the brake disk,check the type of system first though as it may have the handbrake on the caliper and if this type adjusting the cable will not work anyway as it will not pass the annual mechanical inspection on handbrake efficiency if the knife edge lever points are worn inside the caliper

Jun 15, 2012 | 2007 Honda CR-V

1 Answer

How do I get to the parking brake adjusting nut under the center console of a 2001 honda accord LX


If handbrake has excessive travel and the brake pedal is low then you havent set the rear brakes up properly ,if a drum then you clean the lip on the edge of the drum so it has a bevel then you manually adjust the auto adjuster till the drum just slides over then tap outer edge of drum wth a small hammer to level the shoes and then see if you can then adjust the auto adjuster up a bit more .Also when taking the drum off again make sure that the handbrake mechanism lever is right back ,Now if you adjust the brakes on the handbrake cable then it will be out of square and will not work on a brake roller tester ,and the footbrake will still feel spongey then you get a inspection failure for excessive pedal travel and low handbrake efficiency ,this model of car should be able to lock the rear brakes up at 30mph when jerking the handbrake up hard and it shouldnt have more than 3 clicks when done correctly

Apr 15, 2012 | Honda Cars & Trucks

2 Answers

How to adjust handbrake


Do check the rear brakes but below is some help as far as adjusting the cable the proper way. Per specs after all is done your parking brake should be correct as you pull up the lever after 4 - 8 clicks. Hope this helps....

1_24_2012_10_54_13_am.jpg1_24_2012_10_54_32_am.jpg1_24_2012_10_55_39_am.jpg1_24_2012_10_55_55_am.jpg

Jan 24, 2012 | 1997 Honda Accord

1 Answer

My 92 Honda Civic Handbrake cable broke one


um might work but not for a very long time

Jul 18, 2009 | 2002 Toyota MR2 Spyder

2 Answers

Rear brake caliper on honda civic 5 door


not adjusted correctly , sould be able to adjustswitch under hand brake boot

Jun 08, 2009 | 1995 Honda Civic

1 Answer

Handbrake adjustment


look under car where cable from lever attaches to split plate to operate cables for each wheel. there is a spring loaded rod there that can be adjusted with 2 wrenches. one to hold the rod and the other to move adjustment nut assembly. chris

May 10, 2009 | 1995 Honda Civic

1 Answer

How do i adjust the hand brake on my 2002 honda civic after replacing the rear drum brakes?


Do not adjust the handbrake, it is not necessary. You can adjust the new brake shoes for a better brake pedal and this will also take care of the hand brake. This will have to be done with wheels off and lugs reinstalled to keep the brake drums in place. Sometimes the adjuster is difficult to reach and do not over tighten. When the rear brakes are properly adjusted you should have 3 to 4 clicks on the handbrake.

May 03, 2009 | Honda Civic Cars & Trucks

1 Answer

Handbrake adjustment


remove the boot or console around it and there should be a long bolt with a nut on it just thread the bolt forward or back to the needed adjustment.

Mar 24, 2009 | 1997 Honda Prelude

1 Answer

How to dismount the horn on a Honda FRV?


the horn located if front of the radiator behind the front bumper. if you have any questions, email me at thadoggma420@hotmail.com

Sam

Jan 18, 2009 | 2007 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

595 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...