Question about Cars & Trucks
The steel line that goes to both rear brakes is spewing out brake fluid. im thinking that if its blocked good and propper ill still have front brakes.
You will have frount breaks but not the best thing to do by blocking the rear off. You real should put a new line on and bleed the rear breaks. If for some unknow reason you got in an accident bad thing could come from blocking the break line.
Posted on Nov 29, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Front brakes if they are disc it is a caliper if they are drum you havve wheel cylinders. Call the parts store give them the year and they will get you the right part
Posted on Apr 07, 2009
do you have a self bleeder kit? first off, you have to bleed the master cyl back into its self and the combination valve before you go to the wheels. when you do that, I think you will find that you have air in the lines. disconnect both brake lines from the master cyl and put the bleeder kit fittings on the master cyl, then put the rubber tubing with the kit on the fittings and submerge it in the brake reservoir. make sure its full. then pump the pedal until you get a hard pedal. if that is the case, reconnect the lines to the master, then have an assistant pump up the brake pedal with the engine off, and bleed the combination valve which should be connected to the master by steel tubing. pump it up, then hold it down, and crack the fittings loose, one at a time until the pedal goes about half way down, but do not release the brake pedal until the line is tight again, otherwise you will **** air in the lines. after you do all that, go to the farthest caliper or wheel cylynder from the master and bleed that with the same technique,and dont release the pedal until you close the bleeder screw. unless you have a major prob, this will work.
Posted on Jul 20, 2009
They don't make diagrams for brake lines. The lines are sold in bulk. You need to measure and duplicate the bends in the orignal lines and cut/flare the lines yourself. You will need a tubing cutter, flare tool and tubing bender.
Posted on Feb 27, 2010
Tips for a great answer:
Nov 25, 2013 | 1997 Ford Expedition
Aug 14, 2012 | 1988 Mazda B2600 Cab Plus
Jan 03, 2011 | 1994 Ford Explorer Limited
Jul 10, 2010 | 1994 Ford F350 Crew Cab
May 27, 2010 | 2000 Ford Ranger SuperCab
Apr 14, 2010 | 1997 Chevrolet Cavalier
Oct 26, 2009 | 1985 Chevrolet Monte Carlo
Jul 09, 2008 | 1994 Chevrolet C/K 2500
Jul 18, 2018 | Ford Cars & Trucks
Jul 18, 2018 | Cars & Trucks
98 people viewed this question
Usually answered in minutes!