Question about Toyota Sequoia

Open Question

Noise when turning steering wheel on 2003 toyota sequoia

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 449 Answers

SOURCE: steering wheel hard to turn on my 1989 toyota camry

check power steering pump fluid level and belt.

Posted on Mar 03, 2009

  • 30 Answers

SOURCE: 2003 BMW 325i will start but making noise

It might be a faulty power steering pump. Try checking the level of the power steering fluid. It is probably best you have your power steering system checked by a mechanic.

Does the noise occur only when the vehicle is moving?

Try moving the steering wheel from side to side, while stationary (but don't do it too often, or you might damage something). If the noise is still present when the car is stationary, then it probably is the power steering system.

If the noise only occurs while the vehicle is moving, it could be a problem with the differential/final drive, or even wheel bearings.

Posted on Apr 21, 2009

  • 1071 Answers

SOURCE: 2003 Toyota Corolla whining noise when I turn

could be a strut bearing or power steering pump

Posted on Aug 18, 2009

  • 166 Answers

SOURCE: 2003 grand cherokee steering column noise

check the universal joint on the bottom of the steering collum, put one hand ether side of it an twist see if there is any play in it you can also see if it is stiff/seized these will both cause a noise

Posted on Oct 01, 2009

  • 1 Answer

SOURCE: when turning the steering wheel of my 2003 Saturn

mine did the same thing. Where the steering column goes through the firewall (floor) there is a rubber seal. That seal has gotten dry. Apply a small amount of lube where the shaft goes through and turn the steering wheel. This helped eliminate my squeal.

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is causing the front end noise while in a hard turn (left or right) on my 2004 Toyota Sequoia?


The power steering pump capacity on some motor vehicles is unable to sustain full flow for more than a few seconds which could account for the noise which is the pump 'cavitating'. You might check the power steering reservoir fluid level in any case and read your car handbook for any warnings. I once owned a Mitsubishi Magna which had this limitation.

Nov 13, 2014 | 2004 Toyota Sequoia

1 Answer

Ignition lock cylinder


Steering wheel lock pin is broken. Ignition area must be taken apart and pin replaced.

May 02, 2014 | Toyota Cars & Trucks

1 Answer

Key wont turn in my 2003 toyota sequoia


try turning the steering wheel at the same time My 07 tacoma does this too but not often

Aug 27, 2013 | 2003 Toyota Sequoia

1 Answer

I have a 2004 toyota sequoia and noticed yesterday that there was a tapping noise. Initially I thought it was a flat tire but all the tires are good. Not sure where to go from here...


check for a screw or nail stuck in your tire. other causes would be loose lug nuts, or noisey hub caps ( you probably dont have those ). you can roll down the windows and have a helper identify the location of the noise. roll down a safe street and put in neutral, turn key to off - for gods sake dont lock up the steering wheel!!!! try to pinpoint which corner of the car noise is coming from. A bad CV joint would make a tapping-clanking noise but mostly when turning.

Jan 06, 2011 | 2004 Toyota Sequoia

1 Answer

Roaring noise when braking - 2006 toyota sienna w/ 71,000 miles.


If roaring comes with trumbling in steering wheel, means you have problem with brake disk
if just noise with feeling of low brakingability: need to change brake pads

Oct 07, 2010 | 2002 Toyota Sequoia

1 Answer

2001 Sequoia, a clicking noise happens when I turn the steering wheel. What is problem?


see if you here the ckicking sound when you turn the wheel backing up if so it's your constant velocity joint.

Dec 29, 2009 | 2001 Toyota Sequoia

1 Answer

Trac light on 2002 toyota sequoia


You need to have the wheel speed sensors checked. If one is not reading the proper rPM of the wheels, it thinks that the other wheel is spinning, and the TRAC applies the brakes on that side.
A good tech with a good scan tool might be able to read the sensors, but, a Toyota tech is your best bet.

Sep 18, 2009 | 2003 Toyota Sequoia

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...