Question about 2007 Volkswagen Phaeton
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: How do I remove the door panel?
the door handle pops off with a small screwdriver....the part on the door panel where you grab to pull it shut....then there are 2 screws behind there and 3 screws on the bottom....the door lifts off.
Posted on Oct 28, 2008
There should be six or seven allen wrench screws around the edge of the door panels. Loosening these releases the retaining clips inside. You will then want to remove the manual window crank if you have one by laying two fingers flat on the door panel and pushing the ring around the base of the crank sideways. You might have to rotate around this as it only pushes one way. Next you will have to remove the two large golden screws directly under the door panels handle. If you have rear door panel speakers you will have to politely pry off the speaker grill with a flat blade screwdriver and remove the speakers four screws and the wire clip from behind the speaker. You will also have to unscrew the door lock post. Then you should be able to lift the door panel up to release the top lip of it from the door.
Posted on Dec 29, 2008
SOURCE: door panel
here is a diagram of how to unistall your door panel. please do not forget to rate and comment about your experience with fixya today.
Driver's Side Door
NOTE This procedure is for models with power windows. If equipped with manual windows, refer to the procedure for the Passenger Side Door Panel.
NOTE Do not grasp in grip depression when pulling off grip recess, as there is a strut secured to door trim underneath.
Insert a suitable prytool in lower partition between the panel (1) and grip recess (2)
Unclip the grip recess (2) upward out of door trim. Do NOT reach into grip depression while doing so, to prevent damage to brace (1). Then , press the locking lug against the connector (3 – arrow) and pull it off
Unfasten the 7 bolts (arrows). Use pliers to unclip the door trim (1) at the sides, then lift the trim up out of the window recess
Unclip the cable guide (1) using a prytool (2), pull out the bracket (3) in the direction of the arrow, then unhook the cable hook (4)
View of the driver’s side door panel—with power windows
Pull off the window recess seal (1) from door trim and insert in window recess
Posted on Apr 16, 2009
your negative battery cable. Locate and remove the screws that hold your
interior door handles in place (they may be hidden by snap in, or snap on
clips). Remove the interior door handles, then disconnect the wire clips to the
switches. Your panel is held in place by snap in clips; use a small pry bar to
pull them from the door (try to get as close to, or directly under the clips to
prevent them from tearing out of the door panel). Once the clips are pulled,
pull the panel upward to remove it from the door.
Install in reverse.
If you don't have power windows you will have to remove the manual window crank. It is held in place by a clip on the back side of the base. To remove the clip, you will need a small hook (kind of like a knitting needle). Put the hook in behind the base, and grab the clip and pull it off. To replace it, slide the clip back on the window crank, and snap it back on the door.
Posted on May 31, 2009
Tips for a great answer:
Nov 07, 2013 | Volkswagen Fox Cars & Trucks
Nov 07, 2013 | 2004 Volkswagen Phaeton
Sep 28, 2012 | 2004 Volkswagen Phaeton
Nov 27, 2011 | 2004 Volkswagen Phaeton
Apr 21, 2011 | 2005 Volkswagen Phaeton
Jan 21, 2011 | 2004 Volkswagen Phaeton
Aug 28, 2009 | 2007 Volkswagen Phaeton
378 people viewed this question
Usually answered in minutes!