Question about 2002 Ford Mustang

2 Answers

Gear shaft stuck in park 2002 mustang convetable

Posted by on

  • batistei Apr 20, 2009

    I have the same issue can anyone send me a picture of where this aninterlocker is. My gear shifter is stuck.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had this problem as well. I had to fix the brake switch so that the car would sense that I was depressing the brake.

Posted on Jun 26, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 46 Answers

There is aninterlocker on the shifter that will not let you shift unless you push the break sometimes these get out of alignment it will be near the gear shifter or on the steering colum in the drivers compartment. hope this helps you

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shift lever blocked in position D ?


Could be the park neutral switch. It senses that foot is on the brake pedal so shifter can be moved.

Jun 19, 2014 | 2003 Ford Mustang

1 Answer

My gear shaft is stuck in park


It could be either the brake switch above your brake pedal, or one of 4 fuses feeding that circuit. Consult your user manual or check out the following link: 04 G35 stuck in park G35Driver

May 29, 2014 | 2005 Infiniti G35

2 Answers

2003 chevy suburban 4wd 1500 lt shifts slow to 2nd gear and vibrates between 65 and 70 mph


Sounds to me that you need your trans fluid changed and filter. When you do change it use a quart of Lucas transmission conditioner to it. Also check and see if you may have a bad univercel, It will also make it vibrate at faster speeds or your drive shaft may need to be rebalanced.

Nov 25, 2012 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

2002 ford mustang gear shift stuck in park


sounds to be a stuck shift cable

Nov 06, 2012 | 2008 Dodge Avenger

1 Answer

My 02 mustang is stuck in park and i have no brake lights


All indications of a bad neutral safety switch. It's a safety feature designed to prevent you from shifting from Park without your foot being on the brake. If the switch is bad, the car can't sense your foot on the brake to allow you to shift it from Park.

Apr 03, 2012 | 2002 Ford Mustang

1 Answer

Stuck release cable on 2002 nissan sentra


For nissan not coming out of park mode,check the help links provided.Click the link below and go through the troubleshooting procedure :----2002 Nissan sentra will not go out of park mode? http://technoanswers.blogspot.in/2012/02/2002-nissan-sentra-will-not-go-out-of.html----------- Nissan Sentra stuck in park? http://technoanswers.blogspot.in/2012/02/nissan-sentra-stuck-in-park.html
----------This will help.Thanks.

Feb 17, 2012 | 1995 Nissan Maxima

1 Answer

My 98 ford mustang is stuck in park


check fuses for brake shift solenoid. the brake pedal position switch is a fuse under the hood. inside the passenger compartment, check every fuse. that's a start for not having more information.

Dec 08, 2011 | 1998 Ford Mustang

1 Answer

My 2002 kia sedona is stuck in park. The gear


shifter cable either broke or came disconnected

Jul 23, 2010 | 2002 Kia Sedona

1 Answer

My 2002 Saturn Vue stuck in a gear


IF IT STUCK IN PARK.CHECK BRAKE LIGHT SWITCH FUSE AND THE BRAKE TRANSMISSION SHIFT INTERLOCK SOLENOID FUSE.AND PARK NEUTRAL SAFETY BACK UP SWITCH FUSE.IF ANY OF THESE 3.IF FUSE IS BLOWN OR ANY IS FAULTY.YOU WONT BE ABLE TO MOVE CAR OUT OF GEAR.ANOTHER THING MAKE SURE YOUR BATTERY HAS 12.5 VOLTS.

Jan 18, 2010 | 2002 Saturn VUE

1 Answer

Rear Axel Seal


Wheel, brakes etc that are in way of pulling axle out have to come off. Drain rear end fluid, remove rear housing cover, remove bolt that holds pin in differential, remove differential pin, push in slightly on axle to remove "U" clip that holds shaft in, then slide shaft out. replace seal. Reverse procedure for re-install & fill with gear lube. If any questions, get back to us.

Apr 16, 2009 | 2002 Ford Mustang

Not finding what you are looking for?
2002 Ford Mustang Logo

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...