Question about Cars & Trucks

1 Answer

1965 cadillac 429 cu in. Crank case tube under intake disconnected.

Engine stalls when put in to gear.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 344 Answers

Connect it back up, DAAAAAAAAAAAA

Posted on Nov 29, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
tripletauto
  • 1450 Answers

SOURCE: Air conditioner blows through defrost vents

LOOK AT THE WHITE PLASTIC HOSE GOING TO THE RECIRC VACUUM ACTUATOR UNDER HOOD. THIS IS ON TOP OF A/C BOX BY RIGHT SIDE OF FIRE WALL YOU WILL FIND THIS HOSE IS STARTING TO COME APART REPAIR HOSE AND PROBLEM FIXED.

Posted on Sep 13, 2008

  • 508 Answers

SOURCE: no fuel to engine. f250 460 cu engine. stalled on street

Check to make sure the fuel pump is working. On the fuel rail there is a test port that you can connect a mechanical gage too. Also there is a fuel cut out switch under the dash closer to the floor that has a reset button on it. If you hit a very hard bump it can trigger the cut out switch. It is designed so that upon impact in a collision it cuts the fuel supply to the engine to prevent an engine fire from leaking fuel. Sometimes these switches go bad, But, try the reset first and be sure to check that the fuel pump is working.

Posted on Feb 07, 2009

polarcycle
  • 1392 Answers

SOURCE: Basic wiring for 429 engine

You will need to get some kind of ignition system first. I would recommend getting an MSD. It will come with wiring instructions, and it will be all you need to run the motor.

Posted on Aug 14, 2009

jigsaw_9077
  • 308 Answers

SOURCE: engine stalls when put in gear

when An engine stalls while driving . like when you place the gear on mostly on drive. The fuel pump has a problem and need a checking .you can do to take it to the dealer for repair or just do it by your self to save time .Prepare the tools or equipment in servicing the fuel pump.So that fuel pump will operate properly.Locate the fuel pump.Disconnect the fuel line from the fuel pump.remove the fuel pump from the engine.Dis-assemble the fuel pump.Check diaphram for defects.Replace defective parts.Assemble and install the fuel pump.After checking the fuel pump then adjust the Idle into high until the car can when put into gear.If the owner can't do it then he is advice to go to the dealer or to the car shop mechanic to let them do the job.

Posted on Oct 23, 2009

  • 31 Answers

SOURCE: check engine code-P1340 just had work done on

If the codes were on before the work was done then the shop never cleared the codes. If after the work was done the codes came on then could have a plug undone or a vaccume line off

Posted on Nov 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mitsubishi montero Sport 2003 ,erased p0136 code and now vehicle stalls when put in gear so what could be the problem


If you disconnected the battery you have lost what we call "learned Idle", read below on problem and solution.

Here are the most common causes of idle surge, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Jul 20, 2017 | Mitsubishi Cars & Trucks

1 Answer

What is the points setting for a 1967 Cadillac Coupe De Ville


The ignition points in GM Delco distributors are adjustable while the vehicle is running. Although I have not found any specific point gap stated for your 429 ci engine, the instructions say to turn the adjusting screw clockwise until the engine starts to misfire, then back out a half turn (footnote 5). The most accurate way to set the point gap is to use a dwell meter to set the dwell angle at 30. I recall mine was fairly inexpensive (about 35 years ago), but I don't know if they are even available these days.


1965 75 Cadillac Tune up Specifications

Mar 01, 2015 | 1967 Cadillac DeVille

1 Answer

My 1994 5-speed manual Pathfinder sputters and jerks when it's cold


Here are the common cause of surges, stalls at stops, slow idle speed, erratic idle, it is in most cases the idle speed control air-bypass valve and/or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving

Mar 22, 2014 | Nissan Pathfinder Cars & Trucks

2 Answers

Only wants to stay running at high rpm' s put in gear it dies .smells like its getting to much gas,


try to choke air at carburetor a little bit until it stall if rpm go up or running better then you have a vacuum leak ,or carburetor rebuild
hope it helps

Mar 22, 2014 | 1979 Chevrolet Camaro

1 Answer

1965 Cadillac crank case tube under intake


will not make any difference on a vehicle of this age other than a horrid smell when stationary of hot acrid oil fumes

Nov 29, 2012 | Cars & Trucks

1 Answer

Engine rough idles and hesitate on take off after engine has reached normal operating temp.


Check all the vacuum hoses to the large black intake tube.the crank case breather tube used to come off, causing rough idle, stalling and hesitation.

Oct 02, 2009 | 1992 Ford Ranger

2 Answers

I can't locate the starter relay for cadillac deville 2002


The starter relay is on the drivers side of the engine compartment behind the air filter housing under the fuse box cover

May 18, 2009 | 2002 Cadillac Eldorado

1 Answer

When i start my 1997 Geo Metro, it often sputters


Try this
Here are the most common causes of surges, stalls at stops, low erratic idle speed, rough idle and engine hesitation, it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Apr 03, 2009 | 1997 Geo Metro

1 Answer

Catera stalls @ an idle some times but will restart


Here are the most common causes of surges, stalls at stops, low erratic idle speed, rough idle and engine hesitation, it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Mar 27, 2009 | 2000 Cadillac Catera

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...