Question about 1998 Dodge Durango

1 Answer

Where is the oil pump located on a dodge durango 1998 4x4

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 344 Answers

In the oil pan on the engine ,DAAAAA

Posted on Nov 29, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: 1999 Dodge durango

The fuel filter is part of the fuel pump module in the gas tank, the filter is attached to the top of the module and is replaceable, cost for the filter unit is $45.00, bad news you will need to drop the fuel tank to get to it.

Posted on Oct 21, 2008

66 chrgr
  • 1011 Answers

SOURCE: i have a 2000 dodge durango 360 that once it runs loses oil press

if there is no knocking noise then replace the oil sending switch this should fix your problem let me know

Posted on Feb 22, 2009

  • 245 Answers

SOURCE: location of speed sensor for a 2003 dodge durango

the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only

Posted on May 17, 2009

  • 13 Answers

SOURCE: Fuel filter location 1999 dodge durango

the fuel filter is located on the iner driver or pasenger side frame railing inbetween the front and rear doors. yes it has filter in the tank which is more comely know as the sock or straner. the filter will look like a metal canister .

Posted on Jul 29, 2009

  • 1 Answer

SOURCE: how do i change the oil pump on a 99 dodge durango

I'm looking at doing the same job; if you have 4WD, it's considerably more complicated than this. According to The Book, the front drive axle needs to be removed to allow the pan to come out. Get the repair manual if you intend to do this repair (or any repair on any car) yourself; @ $15, it's cheap.

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the thermostat located on a 2005 dodge durango?


2004 Dodge Durango Thermostat change - YouTube

? 4:04
https://www.youtube.com/watch?v=jjHJK2EtfUk
Jun 25, 2012 - Uploaded by GrindTimeAuto
Replacing the Thermostat on a 2005 Dodge Dakota - Duration: 3:41. by Clint Holland 3,104 views. 3:41. 2015 Dodge DurangoLimited Start Up ...

    Dodge Durango 4.7 coolant, thermostat, and auxiliary water ...

    ? 11:25
    https://www.youtube.com/watch?v=zAqU2rxxIlY
    Dec 5, 2010 - Uploaded by lenpenn
    Auxiliary Water Pump Replacement Coolant Drain and RefillThermostat and Lower Radiator Hose Replacement. images for Where is the thermostat located on a 2005 ...


Dec 26, 2015 | 2005 Dodge Durango

1 Answer

Where is oil filler cap on a non hemi 04 Durango?


    2004-2009 Dodge Durango DIY#1 Oil Change - YouTube

    ? 16:16
    www.youtube.com/watch?v=eUPxBpZ-gCA

    Apr 10, 2012 - Uploaded by lightdark101
    2004-2009 Dodge Durango DIY#1 Oil Change .... I have a 05Durango with the 4.7L, and for some reason its hard to take off the oil cap. images for 04 Durango oil cap location


Oct 29, 2015 | Cars & Trucks

1 Answer

Where is the location of the oil pump on a 2001 dodge durango,4.7 engine


It is in the front area of the engine, behind the timing cover and timing chain. You must remove the oil pan, timing cover, timing chain and tensioner to access it.

Oct 17, 2015 | Dodge Cars & Trucks

1 Answer

I have a 2005 Dodge Durango and the oil light comes on but only when I come to a stop but goes off ones I start moving again.


Check your oil level and change your oil pressure sensor. If good, your pressure is dropping at low rpm. Can be a bad gasket or oil pump. Check the oil for antifreeze and antifreeze for oil. If either looks like chocolate milk bad head gasket. If not your pump is bad

Mar 09, 2015 | 2005 Dodge Durango

1 Answer

How to replace oil pump un an a 2007 dodge durango 5.7 hemi motor


the oil pump is located inside the oil pan. removing the motor will be needed to do the job unless you got a new way to open the oil pan with everything in the way. if you have really low or no oil pressure. or after driving for a few miles the pressure drops a lot. the bearings could also be gone and that is going to need to be address with the motor out. other option is get a junkyard motor and replace it. but you never know what could be wrong with that motor. try to hear the engine run if possible

Feb 12, 2015 | 2007 Dodge Durango

1 Answer

Where is the oil sending switch located on a 2003 dodge durango 4.7


Oil Pressure Sensor

On the 3.7L and 4.7L engines, the oil pressure switch is located at right front of engine just above the oil filter. On the 5.7L engine, the oil pressure switch is located at right front of engine.


hope this helps you

Jan 15, 2011 | 2003 Dodge Durango

1 Answer

Finding


inside the engine take the oil pan off it is right there

Apr 23, 2010 | 1999 Dodge Durango

1 Answer

Im having a hard time getting the oil pan off of a 2003 Dodge Durango, 5.9 4wheel drive.


The frame is in the way and you have to lift the engine to remove the pan.
  1. Turn on the Durango and run it for at least 10 minutes, a few times around the block is best. This will get the engine oil up to temperature allowing it to drain better for you.Park the vehicle on a flat, stable surface that gives you enough room to move around under. Jack up the Durango following the directions provided with your jack and jack stands.Open the hood of the Durango and located the engine oil cap, found on the right side of the engine, towards the middle. Remove the cap by twisting it off and set aside, allowing ventilation and pressure release.Climb under the vehicle and located the oil pan. The oil pan is on the underside of the engine, between the car's tires. It is a rectangular shaped pan with a plug located on the end towards the back of the car.Place an oil drip pan under the oil pan and pull the plug by twisting it and pulling it. This will release all oil from the vehicle, draining it into the pan below. Allow the oil to drain until there is nothing left coming out.Use a wrench to loosen the bolts of the oil pan. There are a total of 17 of them located around the edge of the oil pan, connecting it to the frame of the engine. Store safely.Remove the oil pump pickup tube and oil pan gasket, which are connected to the oil pan. You will find these as soon as you drop the oil pan.
    to Replace the Oil Pan Gasket in a Dodge Durango
    1. Jack up the front of the Dodge Durango, and install a jack stand. Block the rear wheels. Remove the oil plug and let the oil drain into a pan, being sure to remove as much of the old oil as possible.Loosen the bolts holding the oil pan with a socket wrench, and remove the bolts with your fingers. Remove the oil filter, starter motor, cooler lines, oil level sensor, heated oxygen sensor connector and exhaust y-pipe, and then take off the oil pan.Scrape off the old gasket with a thin putty knife, being very careful not to scrape the surface. Be sure all of the old gasket is removed, then wipe the surface with solvent. Spread a bit of oil on the surface to promote adhesion, and apply the new gasket.Replace the oil pan, exhaust y-pipe, heated oxygen sensor connector, oil level sensor, cooler lines and starter motor, and install a new oil filter.Raise the vehicle slightly with the jack and slide out the jack stand before lowering the vehicle and removing the jacks.Fill the engine with the appropriate amount of oil. Check the level with the dipstick to be sure you have the right amount.
      this will help.thanks.

Feb 21, 2010 | 2003 Dodge Durango

1 Answer

Do you have to lift the motor out of a 1998 dodge durango to change the oil pump


if yo can get the oil pan off completely then you will be able replace the oil pump without lifting the motor. but if you can't you will have no choice but to lift the motor.

Dec 19, 2008 | 1998 Dodge Durango

Not finding what you are looking for?
1998 Dodge Durango Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...