Question about Cars & Trucks

2 Answers

When I start my 2000 ford econoline van it makes a noisy like something is loose and is jingling around, any solutions to the problem ??

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 344 Answers

It getting close to christmas,LOL: The lord only no what it is, With out seeing the vehicle,

Posted on Nov 29, 2012

Ad

V6 or V8?

Maybe worn timing chain guides

That is not good ---too much work to
go after that job

Only a thought

Posted on Nov 29, 2012

  • Robert beck Nov 29, 2012

    V8 and it's only got 115,000 miles

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

samson-1
  • 153 Answers

SOURCE: freeze plugs ford econoline 150

The freeze plugs can be fixed with the engine in the veicle. There are some rubber plugs available that have a bolt thru the middle. Pry out failed plug, push in rubber replacement, tighten bolt to expand rubber. Fixed.

Posted on Oct 25, 2008

emissionwiz
  • 76630 Answers

SOURCE: Why won't my 1992 Ford Econoline van start

I suspect the fuel pump has stopped working, check the fuel pressure or listen to the noise it makes by taking off the gas cap and listening for a humming noise when the key is turned on, this will stop after a few seconds.

Posted on Nov 07, 2008

greg_margo
  • 1959 Answers

SOURCE: My air bag light on my 2000 Ford Econoline van

Seems to be a very common problem with Ford. The wiring harness beneath the drivers seat contains the sensors for the airbag system. Go under the drivers seat and secure all the wires and clips. This makes most error lights for the airbags go away. Hope this helps and good luck!

Posted on May 02, 2009

emissionwiz
  • 76630 Answers

SOURCE: where is the speed sensor on a 1995 Ford econoline van

the sensor is located on the driver side of the transmission case

Posted on Jun 19, 2009

  • 67 Answers

SOURCE: my 1994 ford econoline van is not shifting gears

Hello.
This a repair for a transmission shop. Sounds like the pumps are bad inside the transmission. Thats the worst option I have.
It also can be a poor shift linkage adjustment. And the last solution can be the speed module that tell the transmission when to shift.
Goodluck! I hope this helps!

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 e150 ford van had a intermitting start problem, but now won't start at all, it cranks over fine but won't hit. it has 105000 miles on it. any suggestions?


my 1989 ford econoline van 5.0 liter electronin ignition was going down the road and it quit now it will not start

Feb 17, 2011 | 1989 Ford Econoline

1 Answer

2001 e150 van ,at idle in drive trans has raddle,like metal objects banging around inside somewhere.sound dissapears at cruse.have any ideas what this could be.is this a serious problem? thank you...


coud be the shroud on the muffler under the van or loose muffler hangers .........
but could be anything loose under or if inside check mouldings seats dog house console dash .....

Oct 21, 2010 | 2001 Ford Econoline

1 Answer

I recently replaced my starter on my 1996 Ford E150 Econoline. I am not sure if I wired it wrong, now when I start the van it makes a loud noise, like something is hitting something else. I move the wire...


sounds like your starter gear may be hitting the flexiplate but that should not effect the trans.
There may be a safety lock on your gearshift under the console that is faulty, it should disengage when the ignition key is turned on, my brother in law had this problem with his new car, I removed it all together as it was more trouble than it was worth

Jun 10, 2010 | 1996 Ford Econoline

1 Answer

Engine cuts out during heavy rains. This started


I HAD THE SAME PROBLEM BUT WITH AN ASTRO VAN. THE PROBLEM WAS WATER WAS GETTING INTO THE FUEL PUMP CONNECTOR UNDERNEATH THE VAN, NEXT TO THE FUEL TANK.THIS WAS CAUSING A SHORT, NOT BAD ENOUGH TO BLOW THE FUSE, BUT ENOUGH TO CAUSE THE PUMP TO SHUT DOWN. BEST WAY TO DUPLICATE THE PROBLEM IS TO FIND THE CONNECTOR AND SPRAY IT WITH WATER WHILE THE VAN IS RUNNING. ALSO DO A WIGGLE TEST, THIS IS DONE BY GRABBING THE HARNESS TO THE PUMP AND MOVING IT AROUND, IF YOU HAVE A LOOSE CONNECTOR OR A BAD WIRE THE VAN SHOULD SHUT OFF.

Jun 07, 2010 | 2000 Ford Econoline

1 Answer

HOW TO INSTALL SERPENTINE BELT ON 87 FORD VAN


For the 1987 Ford Econoline Van:
Size Engine??
Engine Options (AC/No AC)??

Click on the following direct, Free Link. It has the Serpentine Belt Diagram for your 1987 Ford Econoline Van depending on your size Engine and Engine Options.

Let me know if this helped....

http://www.2carpros.com/car_repair_information/year/1987/make/ford/model/econoline/1987_ford_econoline_drive_belt_routing_diagram.htm

Apr 14, 2010 | 1987 Ford Econoline

1 Answer

Ford econoline van leaking unknown fluid HELP!!!!!!


check your enging fluids could be brake fluid or power steering fluid. the wheelechair lift is most likley electric and does not require fluid of any kind

Feb 05, 2010 | 2000 Dodge Caravan

1 Answer

How am I able to test an Idle Air Control Valve for a 2000 Ford Econoline Universal Van E-150 5.4L?


if you go to the trouble to remove it id suggest installing a new one if the van is idling incorrectly or abnormally high it may be faulty

Jan 19, 2010 | 2000 Ford Econoline

1 Answer

I have a 1983 ford econoline van. Do you have a diagram of how the water pump is mounted onto the engine


Short of buying a haynes or chilton manual. the basic instructions are, remove anything that is in your way. fan, fan shroud and brackets. Buy the new pump before starting and place it flat on a piece of cardboard. Use a magic marker and trace it's outline and punch holes through all bolt holes. As you remove bolts from pump, put each through it's corresponding hole. Make sure you make note of any spacers and bracket locations. Once the pump is off make sure that you remove every bit of old gasket material before putting pump back on. Generally it's best to use silicone sealer on at least the pump surface and place the gasket on the pump, waiting 'till its nearly dry before installing (keeps it from moving around while you are working) I also put a thin film of silicone on engine side of gasket just before putting it on. When replacing bolts, snug them finger tight only 'till they are all in. any bolts that will be covered by a bracket need to be tightened first before installing bracket. If you took good notes, the job should not be too difficult.
Only change your pump for the right reasons: If the pump is leaking or the shaft bearing is loose and or the bearing is noisy. Changing the pump for any other reason is a waste of time and money.
replacing a pump that is not leaking will not cure an overheat problem.
good luck....any problems, just ask.

Sep 01, 2009 | 1983 Ford Econoline

1 Answer

Why won't my 1992 Ford Econoline van start


I suspect the fuel pump has stopped working, check the fuel pressure or listen to the noise it makes by taking off the gas cap and listening for a humming noise when the key is turned on, this will stop after a few seconds.

Nov 07, 2008 | 1992 Ford Econoline

1 Answer

Power problem on 92 econoline 5.8L van


Verify the vacuum hose to the sensor has vaccuum to it,while engine running. Do a scan on the computer and post the codes....

Jul 19, 2008 | 1992 Ford Econoline

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...