Question about Cars & Trucks

1 Answer

2006 Hyundai Tycson GL Headlight Problems

Bought two new headlight assemblys off of Amozon, installed them, replaced light blubs, low beam isn't very bright. High beam indicator works on high and dims alittle but doesn't go completely out on low beam. Replaced turn signal and headlight switch today, no difference. Checked head light plug with volt meter, 3 prongs were 12 volt on hight beam on low beam one prong goes to 6 volt and the other two stay at 12 volts.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 344 Answers

Could be a defective headlight relay, Located in the fuse block in engine compartment,

Posted on Nov 29, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

thutson66
  • 96 Answers

SOURCE: Left low beam is dim

The mechanic didn't hook up the ground wire. The system is using the other light as it's ground and when this happens it causes the other light to go out.

Check the ground wires

Posted on Aug 24, 2008

66 chrgr
  • 1011 Answers

SOURCE: Right side headlight (low beam) dead

clearly volts without amps. pinch wire bad socket or multifunction switch under cover on steering column.

Posted on Jan 25, 2009

emissionwiz
  • 75822 Answers

SOURCE: one headlight brighter than other on low beam

This is caused by a dirty/corroded headlight ground to the sheet metal of the car, the ground is usually near the headlight

Posted on Feb 25, 2009

  • 205 Answers

SOURCE: i have no high beam headlights just low beam with

Check Hi beam bulbs they may both be burnt out, and check both fuse boxes. Headlights are offen on separate fuses Left/right so you don't end up with no lights at all

Posted on Apr 06, 2009

  • 496 Answers

SOURCE: High beam headlights quit working. Bulbs are OK.

When you checked the bulb plug and got 12 volts, did you meter ground some where else on the car? If so, you might check ground also at the plug.

Posted on Aug 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

6 Answers

No headlights for my 2002 hyundai accent GL.


Check the bulbs could be blown low beam

Jan 03, 2015 | 2002 Hyundai Accent

3 Answers

I have a 2007 Chrysler sebring and drivers low beams will not work.


try the fuses or wire fuse links , the only other thing in the circuit is the wires broken or the light low switch is bad

Nov 08, 2014 | 2007 Chrysler Sebring Sedan

1 Answer

CHANGED HEADLIGHT ASSEMBLY ON 2002 JEEP LIBERTY ONLY HIGH BEAM LIGHT COME ON


Try flicking the mulit-function switch high beam on and off. There has been known problems with this switch, but mostly the first place to start is with some new light bulbs.
Or possibly your low beam filaments are burnt out. You have to replace the bulbs. Each bulb has a lowbeam and a high beam filament.

Apr 10, 2013 | Jeep Liberty Cars & Trucks

1 Answer

Lights will not turn on


HEADLIGHTS NOT WORKING


It can be faulty headlight switch or issue with its wiring. Or its faulty head light fuse.


==========

To troubleshoot the issue i suggest you few help links with appropriate solution. So you can follow the test and confirm what exact problem is there in your case of headlights not working:-----

Click the link below: -----


All headlights not working?

http://repairhelpcenter.blogspot.com/2012/01/all-headlights-not-working.html

----------

Working of Headlight switch?
------------
Both headlight bulbs blow together?

------------
Car headlight bulbs don't last long?

---------------

2007 Dodge Caliber: Low Beam Headlight Not working

http://technoanswers.blogspot.in/2012/06/2007-dodge-caliber-low-beam-headlight.html

----------

2003 Toyota Camry: Headlights Work Intermittently?

http://technoanswers.blogspot.in/2012/04/2003-toyota-camry-headlights-work.html

----------

Chevy Tahoe: Low Beam Lamps are not working?

http://technoanswers.blogspot.in/2012/04/chevy-tahoe-low-beam-lamps-are-not.html

----------

2001 Chevrolet Tahoe: Headlights not coming ON?

http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-headlights-not.html

--------

2004 Dodge Ram: High Beam Light is DIM?

http://technoanswers.blogspot.in/2012/04/2004-dodge-ram-high-beam-light-is-dim.html

----------

2001 Chevrolet Tahoe: Both Low Beam Lamps Not Working?

http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-both-low-beam.html

------------

Low beam headlights Modification?

http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html

---------
How to Replace a Headlight

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight.html

------------
How to Replace a Headlight Bulb


http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-headlight-bulb.html

-----------
How to Replace a Headlight Switch

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-headlight-switch.html

----------
How to Replace a Headlight Assembly

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight-assembly.html


How to Replace a Park Light Assembly

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-park-light-assembly.html

-----------

Low beam headlights Modification?

http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html

----------

Headlight Assembly Removal On Honda Accord

http://technoanswers.blogspot.in/2012/06/headlight-assembly-removal-on-honda.html

---------------

Honda Headlight Assembly Removal
http://schematicsdiagram.blogspot.in/2012/06/honda-headlight-assembly-removal.html

-----------

How to Replace a Headlight Door

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight-door.html

----------

How to replace HID headlight bulbs for lexus 400h?

http://schematicsdiagram.blogspot.com/2012/01/how-to-replace-hid-headlight-bulbs-for.html

----------------

These will help.

Thanks.

Nov 28, 2012 | 1986 GMC K1500

1 Answer

2006 Volkswagon Beetle, drivers side headlight, high beam not working


Instructions
    • Turn the headlight switch on and inspect the headlights. Make sure to check both low- and high-beam lights, and then note the position of the bulb in the headlight assembly. Low-beams are in the top cavity of the assembly and high-beams are in the lower cavity.
    • 2Turn off the headlight switch and then remove the keys from the ignition.
    • 3
    • Open the hood and locate the seam to the headlight assembly and the side fender. Locate the headlight assembly release lever and push in on it slightly to unlock it and then pull it all the way up until it stops.
    • 4Place a blanket or pillow on the ground in front of the headlight assembly. Push the assembly outward from behind with one hand while being ready to catch the assembly with the other. The New Beetles use an adhesive sealant to protect the back of the headlights from exposure to moisture, so you'll have to give the assembly a push from behind.
    • 5Pull the wire harness plugs off from both the high- and low-beam blades of the respective bulbs.
    • 6Place the assembly on the blanket or pillow. Release the wire clip to the faulty headlight and then remove the headlight bulb.
    • 7Open the package of the new H1 bulb replacement without touching the glass portion of the bulb with your bare skin. Oils in human skin will damage the bulb. Handle it only by the metal base of the bulb insert.
    • 8Insert the new bulb in the appropriate headlight-assembly cavity and reattach the bulb retaining clip to lock the bulb in place.
    • 9Lift the assembly up and plug the wire harness plugs back into the respective blades of the bulbs.
    • 10Push the headlight assembly into its cavity, but before locking it in place, check the lights by turning on the headlight switch.

Sep 17, 2012 | 2006 Volkswagen New Beetle

1 Answer

How do I remove halogen low beam head light to replace it?


Removal & Installation To Remove:
WARNING
The halogen fog light bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope.
NOTE: The headlight bulb should not be removed from the headlight assembly until just before a replacement bulb is installed. Removing the bulb for an extended period of time may affect headlight bulb performance. Contaminants may enter the headlight assembly where they can settle on the lens and reflector. Never turn on the headlights with the bulb removed.
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section. NOTE: Make sure that the headlight switch and the ignition switch are in the OFF position.
  2. Remove the pin-type retainers, screws and the air deflector from the radiator.
  3. Remove the three bolts and the headlight assembly.
  4. Disconnect the electrical connector.
  5. Remove the cover from the rear of the headlight assembly.
  6. If equipped with HID, release the spring tabs to remove the low beam bulb, otherwise disconnect the electrical connector and remove the bulb.
  7. Disconnect the electrical connector and remove the high beam bulb.
HID low beam headlight bulb lin_tc_0085.gif

Standard low beam headlight bulb lin_tc_0086.gif

High beam headlight bulb lin_tc_0087.gif

To Install:
  1. Place the headlight assembly in the proper position.
  2. Install the cover from the rear of the headlight assembly.
  3. Connect the electrical connector.
  4. Install the three bolts and the headlight assembly.
  5. Install the radiator air deflector.
prev.gif next.gif

Dec 18, 2010 | 2003 Lincoln Town Car

1 Answer

What is easiest way to change out headlight bulbs in 2004 Dodge Caravan


Open the hood. Discount the neg. battery cable.Theres 3 screws right on top of the light assembly. Remove these screws to remove the headlight. To remove the bulb from the headlight assembly rotate the blub retaining ring counterclockwise. don't touch the new blub when installing. Make sure all 3 tabs go into there slots on the retaining ring when installing the new blub

Jan 24, 2010 | 2004 Dodge Durango

1 Answer

2004 elantra - front parking light replacement


The little parking light (also known as a city light) is in a plastic connector below the low beam lamp that simply slides out of the headlight assembly.

Grasp the plastic connector and pull back away from the headlight assembly and you will be able to unplug the light from the connector for replacement.

Jan 10, 2010 | 2004 Hyundai Elantra

1 Answer

I need to change the low beam headlight bulb


  1. Remove headlight mounting bolts and nut
  2. Remove assembly
  3. Install headlight assembly (with new bulb)
  4. Replace/tighten headlight mounting bolts and nut
e2ac826.gif


Oct 30, 2009 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

585 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...