Question about 2003 GMC Sierra 1500
Have to diagnose a fault in that system
Tough to do without manuals to learn the system
If you have a motor on the tranfer case check that out
May find something on You Tube
Get to the site the put in your yr,veh & question
Posted on Nov 29, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
it seems you have a short in either one of the lights or interlock. all are connected to the same fuse. trace the wiring from the fuse box back to the component. Using a test light test in between the wires. check for any obvious breaks in the wiring.
Posted on Dec 06, 2008
I have found that when you are going to engauge 4x4 high, it is best to only be going about 3 miles an hour. Not faster, not stopped. It likes some movement to help it mesh. I've had perfect shifts since I started this. Hope it helps. Wade.
Posted on Jan 27, 2009
its a long process,you need a steering wheel puller, once its off take the hazard button assembly out, take the turn signal loose, pull old ignition out, carefully install new one, and reverse procedure and always if u get confused i would highly recomend
a chiltons manual they explain things great
Posted on Feb 16, 2009
take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!
Posted on Mar 15, 2009
the encoder motor sensor is inside the encoder motor. the encoder is located at the transfer case. Remove the encoder and by part number 88962315 this is the sensor. you will have to retime the motor after
hope this helps
Posted on May 06, 2009
Tips for a great answer:
Jun 24, 2012 | 1998 GMC Sierra
Jan 10, 2011 | 1997 GMC Sierra
Oct 28, 2009 | GMC Sierra 1500 Cars & Trucks
Oct 17, 2009 | 1997 GMC Sierra
Oct 11, 2009 | GMC Sierra 2500 Cars & Trucks
Nov 15, 2008 | 1999 GMC Sierra
238 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: