Question about 2008 Dodge Ram Pickup 2500

1 Answer

Where is the trailer light fuse on a 2008 3/4 ton ram p/u?

The lights just went out on my horse trailer and can't find the fuse.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 344 Answers

Check in the fuse block in the engine compartment, Or on the brake controller unit,

Posted on Nov 29, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 19 Answers

SOURCE: No dash lights or brake lights

dodge has problem with headlight switches burning up when towing ,drawing to much current through the switch
should have a relay for trailer markers and taillights

Posted on Feb 06, 2009

co7196
  • 3433 Answers

SOURCE: 2001 Dodge Ram 2500, no running lights on trailer

The truck is protecting itself from the load impose by the trailer.. Chk the plug on the truck for wire gauge size. Turn any electrical loads off on the trailer, any and all. If fuse still blows then the fuse is either underated or the trailer has a dead short. In fact turn trail main power panel of. All lights work you say. So ck the inverter for defect byturning off the inverter on one of the trailers.

Posted on May 28, 2009

greg_margo
  • 1959 Answers

SOURCE: 2000 Dodge Ram - No hazard flashers

Possibly blew out the hazard flasher unit. Check the flasher unit (usually there are 2, one for directionals and one for flashers).

Posted on Jul 07, 2009

pops296
  • 174 Answers

SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK

I have seen once before that the fuse box was bad on a 2003 Dodge 3500. I had power in and nothing out. We had to replace the box. Not cheap! Hope it is simple like a loose connection though. I think I had to pull the inner fender on the drivers side to access the bottom of the fuse box. Pain in the ****, but...

Posted on Oct 01, 2009

pops296
  • 174 Answers

SOURCE: 2003 dodge ram lights work on trailer but brake lights

try http://www.etrailer.com/faq-wiring.aspx. They have very good concise information that might help. Check wiring at each light. You can use the emergency flashers and a 12 volt test light to do this.
Make sure each light is grounded well. A loose ground will cause all sorts of problems. Hope this helps. Mike

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just bought a horse trailer and when I hook it up to my 2006 Silverado, the lights don't work. My trailer hitch and wiring system are new, and the previous trailer owner tested the lighting of


Some people wire trailer plugs differently. If the plug is not wired differently than yours, make sure the tow ball is clean. No rust. That's where the trailer gets its ground from. Usually they will work if thats the case, but not right. I can't remember what the wire colors are right now. Go to etrailer and look up the diagram.

Feb 05, 2013 | 2006 Chevrolet Silverado

1 Answer

2002 dodge ram 1500 brake and parking lots went out


Both. If the running lights ( marker, tail, clearence, or parking) and brake lights are out since the rain, a tail light assembly is broken and filling with water enough to create a short to ground. If there's no broken lens, whitch normally only blows the bulb. Then, the problem lyes in the trailer light harness. the brown wire (tail) & green wire (left turn/brake or yellow wire (right turn/brake) must be bare exsposed that shorts to ground when wet. all the trailer wires could be smashed together damaged the plastic coating on them. no problem till water shorts to ground. The white wire is the ground wire make its not able to touch the other 3 wires or bare & wet. Tape wires seperate then replace tail/mkr fuse and brake fuse. That should do it.

Jan 30, 2013 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

My horse trailer does not have lights, I think a fuse is out.


Have you tryed cleaning the plug both halfs with a contact cleaner?

Sep 24, 2012 | 2005 Ford F-150

1 Answer

Brake light fuse keeps blowing in my 1997 Suburban only when towing trailers.


If the fuse blows on different trailers then it's all down to the vehicle. You either have incorrect wiring on the vehicle, a short OR the fuse is not of a high enough value to cope with the additional brake lights? You could try removing all the trailer bulbs EXCEPT the brake lights - e.g. if it's trying to power up the indicators too? That would stop the fuse blowing...... OR remove the brake bulbs from the vehicle & see if it operates the trailer without blowing...... Check the total wattage of ALL the brake lamps & see if the fuse is actually of a high enough rating? Be aware though that increasing the value of the fuse could cause damage elsewhere! As a rough guide a 25 watt bulb will pull around 2 amps at 12 volts - so 4 bulbs may pull up to 8 amps & clearly blow a 5 amp fuse! If in doubt take it to an auto electrician...... The wiring needs to be correctly protected!

Apr 02, 2017 | Cars & Trucks

1 Answer

I have a 1988 GMC 3500 truck, all the lights and the radio stopped working when I hitched up my horse trailer. Same trailer works fine on my 99 dodge, same pulg to trailer. What happened?


You blew a fuse. Check the in cab and engine compartment fuse box and replace burnt fuses. It's possible that you have too many lights on the trailer. This would cause a multiple amp draw on the truck pulling more power than the typical 10-25amp fuse supplied for trailers.

Jan 03, 2011 | 1988 GMC C1500

1 Answer

On my horse trailer the brake, and signal lights work.But the park lights will not. Everything works fine on my 2005 F150.


You should have a separate trailer running light fuse in the under hood fuse box (check you manual).

Oct 25, 2009 | 2008 Ford F-350

4 Answers

Trailer lights


This is the tow vehicle end. The brown wire ( #6 terminal) is the one to concentrate on. It must have a bad connection either in plug at bumper or wherever mounted, or follow it back toward front of vehicle, and will likely have a connector just behind bumper area, or up near frame as well. Best thing is to use a test light ($5-$10) and probe toward front until you get power showing, then work back to plug to isolate. Begin by checking terminal at plug with blinker on, if no flashing of test light, find brown wire on back of plug & test there, and keep going toward front of truck, especially concentrate on connection areas. Understand? If not, get back to me538a5b8.gif

Aug 29, 2009 | 2004 Dodge Ram 1500

2 Answers

I have brake lights,signal lights,flashers but i Dont have night lights on the trailer connected to my trailblazer.What's Wrong?


I have a new F150 I have hooked up to my horse trailer. Running light work but when I turn on a turn signal this blows the fuse to my running lights, any ideas?

Aug 22, 2009 | 2005 Chevrolet TrailBlazer

Not finding what you are looking for?
2008 Dodge Ram Pickup 2500 Logo

489 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...