Question about 2009 Mitsubishi Outlander

Open Question

How to remove the door panel on a 2008 Misubishi Outlander

Posted by on

3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 209 Answers

SOURCE: lighter stopped working

have you check the fuse if it is ok try to check the line wire of it if it has a continuity use a tester to check it if it is ok try to check the lighter plug.

Posted on Apr 18, 2009

  • 5370 Answers

SOURCE: How do you remove inner

There are two panel screws plus one behind the latch handle.The screws and fasteners on the inner panel needs to removed, that with the help of the flatbed screw driver pry the inner panel off.-------
Click this link below for more details:--- -------- This should help.Thanks.Helpmech.

Posted on Sep 06, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Removing blend door actuator on 2008 kia sedona

Removal of this device is achieved by removing the interior door panel at the door which is affected. Remove arm rest and handles pull edges of door panel gently to release plastic snaps holding the door panel around its edges. If you know an upholstery shop, they can instruct you about removing door panels. Its involved job.

Oct 24, 2016 | 2008 Kia Sedona

1 Answer

Mitsubishi Outlander 2008 Cylinder 2 Misfire Detected want to know what can be causing this error was detected

did you check the plug and plug boot. how about a dirty injector or intermittent vacuum leak.

Jul 16, 2015 | 2008 Mitsubishi Outlander XLS

1 Answer

How to remove front door panel 2008 saturn aura

When you undo the screws, from about five points including the door opener, push the panel up to free from the glass hook.

Aug 26, 2014 | 2008 Saturn Aura XE

1 Answer

How do i pop the door panels off my 2003 mitsubishi outlander?

i am not familiar with this exact problem but most cars have a combination of screws and plastic push fasteners. look in the area of the door handle and see if there are screws usually they will be in the area where your hand grips the door. some times there are screws on the panel at the bottom of the door. i have found those screws by actually laying down and looking up at the bottom of the door panel. once you think you have removed all the screws try lifting up on the door panel. sometimes they have hooks on the back that will disengage as you lift the door panel. if the panel does not lift try using a wide putty knife around the edge of the door gently lifting with increasing pressure to remove teh push type fasteners. you can also get a special tool that is shaped like a spoon with a slot down the middle so you can lift on either side of the fastener. good luck hope this helps

Feb 22, 2011 | 2003 Mitsubishi Outlander

1 Answer

Location of Fuel Relays - Misubishi Galant

In my experience, the relay is situated behind the left hand kick panel inside the vehicle. It is usually called the circuit opening relay and can have 4 or 6 pins. The panel is the one which covers the left hand door hinges adjacent to the left foot of who ever is sitting in the left hand seat.
Some mitsubishi's have the relay mounted above the ECU, behind the glove box so check there too..

Dec 19, 2009 | 1990 Mitsubishi Galant

1 Answer

How to reset computer after oil change on 2008 outlander

How to reset computer after oil change on 2008 outlander

Dec 04, 2009 | Mitsubishi Outlander Cars & Trucks

1 Answer

Lighter stopped working

have you check the fuse if it is ok try to check the line wire of it if it has a continuity use a tester to check it if it is ok try to check the lighter plug.

Apr 18, 2009 | 2004 Mitsubishi Outlander

1 Answer

Driver's door won't open

The problem is the door latch, you can use sawsall to cut the door stricker off this way you can open the door and replace the latch

Jan 04, 2009 | 2003 Mitsubishi Outlander

Not finding what you are looking for?
2009 Mitsubishi Outlander Logo

Related Topics:

936 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides