Question about 1995 Toyota 4Runner

1 Answer

I am having problem figuring out what went wrong with my 95 4runner. i was driving and my vehicle shut off and the engine light came on. i had found the thick black and red wire that splits to the igniter 201 and im pretty sure the noise capacitor, aswell as the black and blue wire that goes to the ignitor 201 had fell down and rubbed on a belt witch partally shredded them. i tapped the wires up and replaced the AM2 30A fuse that had fried. the engine sounds like it is about to start but just wont. Any ideas or tricks or if you know what is going on please help! thanks!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 22,114 Answers

Without having my head under the bonnet to see the problem i couldnt advise ,please ask a local mechanic to have a look and no doubt he will have it running in a matter of minutes

Posted on Nov 29, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 154 Answers

SOURCE: WIRING DIAGRAM TO FIT FACTORY ELECTRIC WINDOWS TO AE92 COROLLA

Well black wire should be your earth wire. But are you going from window motor to car or from car to window motor?

Posted on Jul 28, 2008

  • 1 Answer

SOURCE: Cranks but wont start

Did you check the coil?
It's a $45 to $46 item any more and your getting ripped off.
It's behind the dis-cap .
You need to remove the whole distributer and unscrew it from the bottom 4 phillip head screws hold it in not a big deal! Just remember to put the distributer back the same way it went in and DON'T CRANK THE ENGINE WITH THE DISTRIBER OUT!!! I like to take a picture of the distuber with the cap off before I remove it so I will remiber how it was before I took it out and I can put it back in the same way.Also mark the flang of the distuber and the engine block with a marker so you won't mess up the timing.Take your time not a big deal and don't pay ths silly internet site the $ for the solition!!!!!

Posted on Sep 16, 2008

  • 1 Answer

SOURCE: 93 corolla 1.8 No start Blown ignition fuse

I had a prolem like this one time a while back. what i did was got the wiring diagram and checked everything that was running through that 30 amp fuse. on the one i was working on it ended up being an injector wire pinched under the valve cover and it didnt short out till the car was driven til it warmed up and expanded after the valve cover gasket was changed. hope this helps!

Posted on Jun 27, 2009

alicantecoli
  • 22114 Answers

SOURCE: Hello, We have a 2006 Sienna. When the ignition

its all electronic and fortune to fix ,cut the solonoid feed wire from the loom the thin one that makes the solonoid click on ,not the big heavy wire and fit another relay using this wire thats wired through the ignition switch so when the ignition is turned off it will isolate the original feed wire to the original solonoid

Posted on Apr 25, 2010

  • 462 Answers

SOURCE: I have a 94 Toyota Corolla 1.8. Engine wont start.

Check HALL sensor , it's probably inside the distributor , another name for it is a camshaft position sensor.

Posted on Jul 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Cadillac DeVille (has 110,000 miles on it) suddenly dies while driving. Starts and idles fine, but shuts off after driving only 1-2 blocks. What's wrong and how do we fix it?


There are many things that can contribute to this problem. It sounds like it may be ignition related. Possibly an ignition control module or ignition coil. The check engine light coming on while driving is the key to finding the problem. The light comes on when the computer finds a problem and will then store it in its memory. Have the codes checked for what the computer has found to be at fault and with a little diagnostics, should lead you to the problem

Jan 06, 2016 | 1991 Cadillac DeVille

2 Answers

2005 Suz. Swift The engine light blinks when I am driving, then my car will sputter, and stall completely. I usually can shut the car off and turn it back on and it will run. What's wrong? Thanks!


blinking check engine light means -requires immediate attention the computer found a problem with vehicle that can cause damage if continued to run or drive --some codes will shut down vehicle to a limp mode or the problem can cause shut down ----have code read most auto stores offer this for free the code will give you a start point towards repairing your vehicle

Aug 28, 2015 | Cars & Trucks

1 Answer

Engine shuts off after driving 45 min when parking in reverse.But 15 min before this engine and slippery road icon comes on.2 hrs later car starts and drives normal then shuts off again 45 min later.


most commonly found problem relates to an electronic component heating up and shutting down. Have you checked to confirm there is fuel pressure when the vehicle shuts off. Is the check engine light on. Have you checked codes ? I suggest hooking up a fuel pressure gauge and letting vehicle run till it shuts off while monitoring the fuel pressure. If you loose fuel pressure, next step is to confirm there power going to the pump, if there is power going to the pump with no fuel pressure replace pump. Another suggestion would be to check for spark when vehicle stops running to eliminate an ignition problem. good luck

Aug 17, 2015 | 2008 Toyota Highlander

1 Answer

Chrysler 300m oil light came on while driving and the engine then shut down. the oil light is still on the dash and the car wont start. turns over fine just dont run


Are you SURE that it was Oil Light then Engine Shut off? There is not a ENGINE SHUT OFF if the light comes on that I am aware of and I have worked on quite a few 300's.

I would be trying to start the vehicle by:
Verify Fuel Pressure
Spray Starting Fluid in the Intake and see if it starts then
Are you sure there is Spark?
CRANKSHAFT SENSOR went bad

Feb 13, 2014 | 2000 Chrysler 300M

1 Answer

Engine cooliant light keeps coming on and the engine keeps overheating. what is wrong?


to start with engine coolant is low like the light is telling you.correct that first then figure out why it went low. by the way..... you say it keeps comming on so.....I have to say.....if you keep driving it the way it is it will cost u dearly...that is if its not already too late

Aug 26, 2013 | 2001 Oldsmobile Aurora

1 Answer

For about 4 months now my 2007 sebring shuts off for no reason after driving on the highway. The oil light comes on and the car shuts off with the key still in the ignition and the car still in drive. I...


Anytime the oil light goes on, I would think that the pressure has dropped, assuming the oil sending unit is working properly.

How long ago was the engine oil changed?
I had a low oil pressure signal in a 1997 Cadillac Deville LImousine which went away after I had the engine oil changed.

Sometimes, the wrong viscosity or oil break down can cause the oil pump not to generate enough pressure for the oil pressure light to go on.

I looked at the Recalls for the 2.7L engine and couldn't find anything regarding engine oil pressure light going on mistakenly, but this doesn't mean that it's not a problem on your vehicle. There are 2 other sized engines for this vehicle.

So, what's the engine size for this Chrysler Sebring?
Does the engine smoke at all after all of this?

Sep 02, 2010 | 2007 Chrysler Sebring Sedan

1 Answer

Intermittent Problem


Not sure if my situation helps or not, but here you go.....

I have a 2006 H3 that has 21,000 miles, last week my husband was driving and lost power, service engine came on, and it kept flashing stabilization problem. Called roadside assistance and had it towed to the dealership. Dealership said it was a dead battery and replaced it. Took the vehicle home and didn't drive for a couple of days. Drove again a couple of days later with no problems. 2 days later tried to start and vehicle had no power could not start at all. Called road side assistance and had it again towed to dealership. Dealership told us the main computer was bad and had to be replaced. We were told it is NOT a common problem, heres hoping we don't have any other issues with the vehicle.

Jun 18, 2008 | 2006 Hummer H3

Not finding what you are looking for?
1995 Toyota 4Runner Logo

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...