Question about 2001 Chevrolet Blazer

1 Answer

I have a 1996 chevy blazer that the starter is turning even after it is cranked but the starter is good

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 195 Answers

Hello; The most probable cause is a shorted solenoid. This is where the wires to the starter connect. Make sure that te wires from the battery do not touch the ignition switch wire.
Thanks;
Rich
RPM Northwest

Posted on Jan 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Won't start


first you should make sure the fuelpump is working properly.you will hear a slight buzz when turning key on without cranking.if not its defective... happened to me with my 1996 blazer...if its good then check fuelfilter

Feb 28, 2016 | 2000 Chevrolet Blazer

1 Answer

I have a 96 Chevy Blazer 4 door I've change the ignition switch starter all that good old stuff if I turn the key and jumper by the starter it will run I have liked it just no crank no start


1989 Chevy blazer 4.3 won't start..I have ... - CarGurus

www.cargurus.com > Questions > Chevrolet > BlazerCarGurusJan 30, 2013 - 96 Chevy S10 Blazer with 4.3 L engine vortex will turn over but won'tstart. ... i a 93 k5 blazer 5.7tbi in cold weather it will not start, if i hook jumper ... was told it just needed a Fuel pump, I replaced the Fuel pump, and the Filter, ...

Oct 12, 2015 | Cars & Trucks

1 Answer

I have a 1996 Chevy Suburban 1500. No crank or any noise or sound when trying to start. Battery is good, even tried jumping to make sure. Could this be the starter? If so, where is it located?


The starter is next to the side of the lower engine block where the engine and trans meet(I believe on the passenger side on GM V8s)You should get 12 volts on the small(purple?) wire of the solenoid when the key is turned to "start".If you don't get 12 volts when the key is turned,it could be the switch on the shifter(usually referred to as the PRNDL switch)IF you get 12 volts at the solenoid when you turn the key,replace the starter(my Chevy work truck has gone through 6 starters(ONE A YEAR)since I've had it!)

Jan 07, 2012 | 1996 Chevrolet Suburban

1 Answer

No start 1996 chevy Blazer


Timing chain. It's probably broke!

Dec 21, 2011 | 1996 Chevrolet Blazer

1 Answer

My chevy blazer is turning over but it won't start even when I put gas in the carberator.


You don't have a carberator on it, it's fuel injected. Id try spraying carb cleaner in the throttle while you have someone turn it over. If it fires up for a few seconds then dies then you might have a fuel pump problem or fuel filter clogged. If it still doesnt fire up then check if you have spark, if no spark see if your crank sensor is good and if your coil is getting power. If your coil is not getting power you might have a crank sensor problem. Try this and let me know if it helps.

Feb 03, 2011 | 1996 Chevrolet Blazer

1 Answer

A new starter was installed in our '96 Chevy Blazer but there is no power going to the starter. I was told to look for an inline fuse for the solenoid/thermal wiring? The starter clicks and there is...


hello ase tech here. so your starter clicks when you try to start the car correct. the first thing i would check would be the ground at the battery is it tight. next i would check to see if you can hand turn the motor over, by attacting a socket that fits the crank bolt and turn by hand if ok i would take the starter back where you bought it and request a new one.

Sep 06, 2010 | 1996 Chevrolet Blazer

2 Answers

1999 Chevy Blazer Engine will not crank over. All


try turning the key over to the start position. then take a long screwdriver and touch it across the terminals on the starter. this should start your vehicle. if the sarter doesnt turn when you do this,then you have the starter locked up,and yo will have to take it off and install some shims under the bolts.if the starter is trying to turn and the lywheel isnt urning...then you have a locked up engine.

Apr 26, 2010 | 1999 Chevrolet Blazer

1 Answer

2000 Chevy Blazer won't turn over


Check this out ( and dont laugh even though I know ya want to ) Make sure ya terminals are clean on the Batt .. esp the + Side.. MAke sure its charged.. Then after all that. Get one of ya buddies that ya hate to crawl underneath and tap the starter with a hammer as you turn the key.. If it cranks,, go buy a starter.. Hope this helps.. Thank you

Mar 11, 2009 | 2000 Chevrolet Blazer

1 Answer

How do you remove the starter from a 1996 chevy 4WD blazer?


NO, it's kind of tight, but it's not that bad. You do need to remove the torque converter cover, and slide/rotate it as much to the driver's side of the vehicle as possible.

Jan 21, 2009 | 1996 Chevrolet Blazer

2 Answers

1999 Chevy Blazer 4WD wont start


Sounds like the bendix is stuck in the starter. When this happens, the starter energizes and turns, but the gear does not kick out to make contact with the flywheel. Have someone tap on the starter while cranking the engine.

Dec 25, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
2001 Chevrolet Blazer Logo

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...