Question about Toyota Tacoma

Open Question

2003 toyota tacoma has idle problems

It will crank thenit idles up to 2300 rpms

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

JMMARRERO59
  • 77 Answers

SOURCE: 2003 Toyota 4runner dies/won't start

CHECK FUSE FOR START ASSIST RELAY

Posted on Dec 24, 2008

  • 1 Answer

SOURCE: 1990 Toyota Celica GTS. Idle races too high

sound very much like a vacuum leak.... also maybe your timing is off? possibly advanced? try retarding it with the distributor if thats the case...

Posted on Feb 01, 2009

  • 1861 Answers

SOURCE: 1995 toyota pickup, surging at around 2000 rpms

Is the check engine light on?

A major cause of surging is either air leaks between the air flow meter and the engine intake manifold, or a bad or mis-adjusted throttle position sensor.

Posted on Feb 25, 2009

  • 2 Answers

SOURCE: 1991 Toyota 4x4 22re .On cold start the idle

put a jumper wire between the bottom two pins in the plug for the throttle position sensor, if it idles down you need to replace the idle throttle position sensor

Posted on Apr 09, 2009

  • 1 Answer

SOURCE: 2003 parking bulb toyota tacoma

OK, I just fixed mine. The unit pulls out. You have to get a screwdiriver, wrap it with a cloth so it doesn't scratch the paint, then gently wedge the entire unit out. When it pops out, you'll see the clips that keep it in place. You might think its breaking when you pull it out, but trust me this is how you do. Just be gentle with it. After you get the unit out, simply take the socket out and replace the bulb. I did it in five minutes.

Posted on Nov 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 tacoma has a light ticking that gets louder with higher rpms


could be anything from lifters to injectors I would have this inspected do you change you oil after 3000 miles?

Sep 17, 2012 | 1997 Toyota Tacoma

1 Answer

Continue misfiring


Vac leak including the intake manifold or faulty injector ?

Jun 30, 2012 | 2003 Toyota Tacoma

1 Answer

The 1984 Toyota 4x4 pickup truck will not idle


On a 1984 Toyota I would look for a screw to set the low speed idle on the carburetor, if so equipped. Turn the screw until the RPMs are reasonable.

If you can maintain a smooth idle by adjusting the screw your home free.

If not, then there could be other problems with your vehicle's emission, ignition, comprression, or fuel.

Jul 07, 2010 | 1984 Toyota Pickup Deluxe

1 Answer

I have a 1996 tacoma, have had a problem with a


Tap on the mass air flow,and see if it changes idle,if it does,it is the problem,If the throttle position has to be tapped on,then it could be defective,change it out for a new one.

Apr 28, 2010 | 1997 Toyota Tacoma

1 Answer

My toyota randomly will rev up the rpms to about


your idle position sensor could be bad. if it reads incorrectly, then it can randomly adjust to a higher idle like when you cold crank and let it warm up.

Mar 23, 2010 | 1994 Toyota Pickup

2 Answers

Engine will idle too low and at times will stall with AC on when coming to a stop. Lately it idled too high @ 2300 RPM is there an adjustment. To get it to idle down I removed the rubber stop behind the...


Often a sign of a thermostat that's duff. Usually will also show on bad economy.

Sometimes can also happen if your battery is nearly dead, as it can put load on the engine.

Mar 10, 2010 | 1998 Toyota Corolla

1 Answer

I replaced the oxygen sensor on 2004 Toyota Sienna; now it idles too fast. Part was difficult to remove. Could I have damaged something getting the part out? Where is adjustment for idle speed?


idle speed adjustment is most probably not the problem, what most likley happened is you loosened a vacuum line in the process of removing the o2 sensor. try listening for a hissing sound. or spraying around with some carb cleaner to find the location.

Oct 30, 2009 | 2003 Toyota Tacoma

1 Answer

Engine rpms drop very low when AC is on


make sure your engine idle speed correct.air conditioner compressor will take power from engine.the engine has to be fine tune.your engine idle to low have the idle speed control checked.

Jun 06, 2009 | 2003 Toyota Camry

1 Answer

1999 toyota tacoma 4x4 rough idle after engine is warm


I have same problem on 2003 toyota tacoma 2.7L EXACT SAME CODES

Oct 24, 2008 | 1997 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...