Question about Ford Escape
Sounds like leaky valve cover gasket,oil is running into dwell.or plug is loose or wrong size,thread wise...
Posted on Nov 29, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
to reset the oil monitoring system to 100% , press SET control to access the system check functions , press and release the SET control to display OIL CHNG XXX% HOLD SET NEW , press and hold the SET control for 2 seconds to display OIL CHANGE SET TO 100% , oil life is now reset . thank you !
Posted on Dec 30, 2008
depends where the oil came from.of it has leaked down from a valve cover gasket,that is not hard to fix.if it a leaking valve seal that is expensive and if the head gasket is leaking,expensive.look at the outside edge of the valve cover,and check the edge for oil.if there is alot of oil,by the time the plug is unscrewed oil can go inside.the oil would burn off,so if there is oil inside it is dripping down probably from a valve seal.take off the valve cover and inspect the seals they are probably no good.there are 2 seal sets,one is in the valve cover,and that results in oil on the outside of the plug,and the actual valve seal which results in oil in the inside of the engine.
Posted on Jul 13, 2009
I would replace the spark plug cable as well. It is quite easy the damage old plug wires when removing them to change the spark plugs. A good way to check this is to pull off a spark plug wire (one at a time), then start your car. If it became worse then move to the next wire until you find one that is causing the miss. Make sure you shut the vehicle off before touching the wires. Then switch it out with one of the other wires. Make sure you change it at the coil as well. Now recheck for the miss. If it moved then it's the wire. If not the you might need to recheck that plug gap and also inspect the inside of the distributor cap. You may need to replace that as well.
Plugs, Wires, Cap and Rotor should really all be replaced at the same time.
Posted on Aug 18, 2009
Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.
Posted on Feb 03, 2010
Tips for a great answer:
Dec 26, 2013 | 2008 Ford Escape
Sep 26, 2013 | 2001 Ford Escape
Sep 19, 2013 | 2008 Ford Escape
Jan 05, 2011 | 2002 Ford Escape
Jan 08, 2010 | 2008 Ford Escape Hybrid
Dec 30, 2008 | 2008 Ford Escape
231 people viewed this question
Usually answered in minutes!