Question about 1990 Oldsmobile Eighty Eight

2 Answers

My blinker stays on when i meke a left turn

Wont shut off by itself

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

You will have to Disassemble the Sterring Column and Remove the Sterring Wheel. There is a Unit that the Blinker Handle is Attached to that needs to be Replaced. Not an Easy Job.

Posted on Jan 10, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 114 Answers

The problem with the blinker staying on is most likely the cancel spring. In the steering column you have two cancel springs, one for the right turn signal and one for the left turn signal. your left turn cancel spring is probably broken. to replace this spring requires removing the steering wheel and components. on some models you have to replace the whole turn signal module cause it's all one piece. Check with your local dealer or parts store to see which one you have. Hope this helps you out.

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 neon left turn signal will not work when the headlights are on and the interior left arrow light stays on


sounds like you have water in youre light socket. or the wrong bulb is installed.or a blown bulb.

Mar 29, 2013 | 1999 Plymouth Neon

1 Answer

Turn signals blin continually


There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike

Jan 16, 2012 | 1995 Cadillac DeVille

1 Answer

Blinker issues


These are two seperate issues:

the light staying on solid green indicates a bulb blown at either the front or rear, this could also be a bad ground connection but usually is a bulb issue. If you replace the bulb, be sure to use bulb grease to seal our moisture.

As far as the signal arm returning to neutral and cancelling the signal, that is controlled by a part within the steering wheel itself, and could just be worn. It's a Plastic/Nylon piece that pushes the signal arm manually when you turn the steering wheel sufficiently. That would be a dealer part, or something purchased from a salvage vehicle.

good luck

Mar 12, 2010 | 1997 Buick LeSabre

1 Answer

My blinkers wont work but the hazards work. No fuses burnt out.


That would most likely be the switch itself. Fairly common

Aug 28, 2009 | 1998 Mitsubishi Montero Sport

1 Answer

Blinkers will not work when headlights are on.


you have a left side turn signal out in the front or back replace bulb the reason why your bilnkers wont blink is because your flasher relay is bad the relay will be located n the fuse panel under the drivers dash any auto parts store should have the light and the relay in stock replace both of those and youll be in buisness

Jul 02, 2009 | 1992 Chevrolet S-10

1 Answer

Left turn blinker will not stay engaged


OH the joy of owning a PUSH sorry porsh lol
Well yes id beleive that price!
try wreckers for parts or some of the porche forums on the net as they may have parts listed for sale
good luck
Cheers Rob

Jun 02, 2009 | 1999 Porsche 911 Carrera

1 Answer

Blinker wont turn off after turn


Turn signal switch is broken or defective.

Apr 25, 2009 | 2001 Volvo S40

Not finding what you are looking for?
1990 Oldsmobile Eighty Eight Logo

Related Topics:

555 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...