Question about 2000 Ford Ranger SuperCab

1 Answer

Idles high while driving - 2000 Ford Ranger SuperCab

Posted by on

  • yadayada
    yadayada May 11, 2010

    does it idle down when u disconnect the idle speed control valve? it is round and near the throttle cable on the engine.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Could this be the fan clutch making it seem to idle high? Does it calm down after a short distance of driving? Watch RPM gauge to see if it is actually high revving or just noise?

Posted on Feb 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 1992 Ford Explorer idle too fast?


Idle adjustment procedure - Ford Explorer and Ranger Forums ...

www.explorerforum.com > ... > Under the Hood
Mar 25, 2015 - 19 posts - ‎11 authors Idle adjustment procedure Under the Hood. ... Below are the stock idle speeds (RPM) for my 2000 SOHC V6 with strategy CDE4. ..... when you apply the throttle or it could be too much base timing causing a huge misfire. High Idle Blues 1994 4.0
19 posts
Dec 8, 2009
HIGH IDLE in Park!!!
7 posts
Nov 28, 2003
High idle in park 1,500rpm and 900rpm stopped in drive ...
10 posts
Nov 12, 2003
High Idle Problem .. 95, 4.0L, OHV
19 posts
Apr 30, 2003
More results from www.explorerforum.com

Nov 02, 2015 | Ford Cars & Trucks

1 Answer

High idle


It's probably one of two things , a vacum leak or a bad ground.

Dec 23, 2012 | 1989 Chevrolet C2500

1 Answer

My car slams when put into drive. is it the idle


Yes, sounds like the idle speed is too high. If you keep driving like that, you will fry the torque converter / turbine. Since idle is computer controlled, you will have to take it for service tune up. There is one possibility that the rich, high rpm idle used for cold start is not disengaging properly after the engine warms up. Air conditioning will raise the idle speed by a couple hundred rpm, so avoid using it until you have the problem fixed. BTW.....warm engine rpm in idle, and neutral should be around 700-800. Anything over 900-1100 will result in a hard shift into 1st gear and dragging at stop lights.

Feb 16, 2010 | 2002 Chevrolet Malibu

1 Answer

High idle


sounds like you have a vacuum leak somewhere

Jan 03, 2010 | 1983 Mercedes-Benz 300-Class

2 Answers

Jaguar xj6 4.0 1990. showing fault code fuel 14, fail 14. what does this code mean ?


2 airflow sensor out of operating range 3 coolant temp sensor out of operating range 4 oxy sensor indicates full rich 5 throttle potentiometer/airflow sensor... (low throttle pot signal with high airflow sensor signal) 6 throttle pot/airflow sensor...... (high throttle pot signal with low airflow sensor signal) 7 throttle pot...idle fuel adjustment failure(idle speed??) 8 intake air temp sensor...open or shorted circuit to sensor 11 Throttle pot at idle: Throttle pot idle trim out of normal range 12 Airflow meter: MAF signal out of range 14 Coolant thermistor: Resistance out of range or static during engine warm up 16 Air thermistor: Resistance out of range 17 Throttle pot: Out of range 18 Throttle pot/Airflow: Low throttle pot signal at high airflow 19 Throttle pot/Airflow: High throttle pot signal at low airflow 22 Fuel pump drive: ECU output to fuel pump relay 23 Fuel supply: Engine running too rich 24 Ignition Drive: ECU output to ignition Amp 26 Air leak: Engine running too lean 29 ECU self check 33 Injector Drive: ECU output to injectors 34 Injector: Looks for Injector dribble 37 EGR Drive: ECU output to EGR switching valve 39 EGR check sensor: EGR not working (normally pipe blocked) 44 Lambda (O2) sensor: Poor mixture control rich or weak (or misfire) 46 Idle speed Control valve: ECU output to Coil AB 47 Idle speed Control valve: ECU output to Coil CD 48 Idle Speed Control Valve: Stepper motor grossly out of position 66 Air pump: ECU output to air pump relay 68 Road speed sensor: Seen speed < 5km/h at high engine airflow 69 Drive/Neutral switch: Seen cranking in "D" or high airflow in "N" 89 Purge Valve drive: ECU output to purge valve
this is all I could find

Nov 09, 2009 | 1990 Jaguar XJ6

1 Answer

Bronco idles to fast and now will not shift to drive


well the fast idle is most likely caused by a leaking upper intake runner base gasket, this high idle may be related to the trans no engaging, fix the idle problem by remove the upper intake runners and installing a new base gasket and keep your fingers crossed

Sep 18, 2009 | 1989 Ford F 150

1 Answer

92 honda accord surges or idles high


Have you install a timing belt recently? If you get it off a tooth it will idle high and surge

Aug 21, 2009 | 1998 Honda Civic

1 Answer

My 1997 chevy lumina is throttling too high to drive


CHECK TO MAKE SURE THROTTLE LINKAGE IS NOT STICKING.ALSO LOOK AT THE THROTTLE BODY GASKET.IF ITS LEAKING OR BROKEN IT WILL CAUSE HIGH IDLE SPEED.IF ALL LOOKS GOOD.SCAN IT.CHECK FOR IDLE SPEED CONTROL FAULT.IF IDLE SPEED CONTROL GO BAD IT CAUSES HIGH IDLE SPEED.

Aug 18, 2009 | Chevrolet Lumina Cars & Trucks

Not finding what you are looking for?
2000 Ford Ranger SuperCab Logo

Related Topics:

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...