Question about Cars & Trucks
Can anyne tell me how to sort my heaters out in a 2001 vanette cargo as i cant demist the screen as the fans not working not sure which is the fuse for the heater can anyone help thanks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Heater motor is prone to water damage when the small drain scuttle drain gets blocked (usually by leaves).
If the passenger footwell carpet is damp, that's probably the problem.
Worth checking regularly anyway, and/or remove the small cover over the drain which is part of the problem.
Remove the heater assembly (located over passenger footwell) and replace is the easy answer.
It is possible, depending on ability, to strip and repair.
New from Europarts around £130, used around £60.
Posted on Nov 19, 2008
hedgehog is a final stage unit located on passenger side deep behind the radio. Replace my batt before fiding the post. did my self and part cost about 70.00 bucks but area is very tight. The fuses 75 and 76 are located behind the glove box and very difficult to get to and see. I am trying to find the solution to that as we speak.
Posted on Jan 18, 2009
Go to your idrive., climate the vent settings. you will see a person along with vent areas on the side.
If this persons color is blue it blows cold air so turn the dial for vent closest to that person until the
color changes red then hot air comes out on the vents for driver and passenger. Then let me know.
2006 BMW 530i sport
Posted on Feb 01, 2009
If the engine compartment fuse #105 is OK, next 2 items are :
1. Blower motor relay. This is in the same fuse block as the flasher, under the dash, about in line with the steering wheel column. It should have a cover on it, so it will be black, and hard to see.
When you pull it, you can bypass the control panel operation of it, by jumpering the normally open contacts ( show below with the red line )
If this does not work, the next thing to check is the blower motor resistor, mounted in the blower duct on the passenger side :
The right hand side of the picture, is the passenger side kick panel where the fuel inertia switch is at. The wiring pigtail shown goes to the blower motor resistor, which is towards the left / driver's side.
The resistor usually goes out, with only the high speed part working, but you could have a case where all are out ( seen it happen before ).
The black wire in this harness should go directly to ground ( check with a meter to the ground lugs behind the passenger side kick panel ).
A loose / missing ground to the blower motor resistor will also give the same symptoms of a blown resistor pack.
Posted on Nov 30, 2009
Tips for a great answer:
Jul 07, 2016 | Nissan Cars & Trucks
Nov 28, 2013 | Cars & Trucks
Nov 07, 2013 | Cars & Trucks
Nov 28, 2011 | 2001 Nissan Sentra
Jan 01, 2011 | 2001 BMW 5 Series
Dec 15, 2009 | 2001 Hyundai Accent
Nov 30, 2009 | 1997 Nissan Sentra
May 29, 2009 | 2006 Nissan Versa
124 people viewed this question
Usually answered in minutes!