Question about Cars & Trucks
Check Fuel Pressure with a gauge at the motor
If it is not leaking & press is within spec your okey, then
remove the vacuum hose, if it has one & you should see
a higher pump pressure
May also be able to see press with professional sacn tool
Posted on Nov 28, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
2000 maxima is filled with R134, not freon. You don't need retro fit kit. Get couple of cans of R134 and pump it into the low side valve /small fiting, while A/C compressor is engaged. If your compressor is not coming on, jump the low side pressure switch to make the compressor come on and than the R134 will get sucked in to your system through the low side line. The proper way to do this is to put a/c system under vaccum for 15 minutes at least and watch for leak/gauges coming/loosing vaccum. Than pump R134 into the HIGH side valve with engine OFF.
Posted on Jul 17, 2008
SOURCE: starter 2000 maxima se
Firts disconnect battery. Remoce air filter box. You will see the starter right under neith the air box. You will see a rubber bute. Under the boot is a 12mm wrench size nut. Remove nut. There is a single wire connector. Unplug connector. There are 2 bolts holding the starter to the trans. One of them is pretty big.(19mm socket size ?) and the other is smaller. Remove them both and the starter will come out. Reverse install procedure. Good luck
Posted on Jul 19, 2008
SOURCE: fuel problem
I had the same problem with my 99 Subaru Forester and it was caused by oil leaking and getting into the spark plugs. We only needed to remove & clean one of the plugs and then we were running smoothly again. Very well could not be what your problem is but it's worth a shot mentioning.
Posted on Feb 28, 2009
yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,
Posted on Apr 19, 2009
There are two speed sensors one is called a revolution sensor that is located on the case of the transmission. You can take the driver side wheel off and see the sensor on the top of the case of the transmission. A 10mm bolt is holding it in. Easy fix
Posted on Jun 17, 2010
Tips for a great answer:
Feb 13, 2016 | 2000 Nissan Maxima
Feb 26, 2015 | 2000 Nissan Maxima
Apr 03, 2013 | 2000 Nissan Maxima
either the crank sensor, tune up, or a transmission sensor are bad
Sep 11, 2012 | 2000 Nissan Maxima
Jun 12, 2012 | 2000 Nissan Maxima
Mar 14, 2012 | 1998 Nissan Maxima
Mar 15, 2011 | 2004 Nissan Maxima
Jun 14, 2010 | 2000 Nissan Maxima
Aug 20, 2009 | 2002 Nissan Maxima
May 23, 2009 | 2002 Nissan Maxima
Jul 18, 2018 | Cars & Trucks
91 people viewed this question
Usually answered in minutes!