Question about 2007 Dodge Sprinter
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Map sensor bad or vacuum &/or power to it missing. Map sensor located on intake manifold or firewall. It has a vacuum hose & electrical connector attached to it. To verify it is bad disconnect electrical connector to it while running. Idle should smooth out & run good. If so need to replace.
Posted on Jun 15, 2010
try turning the steering wheel in one direction while turning the key. this may require some force. if it doesnt work then try turning it the other way
Posted on Jul 11, 2010
This code pertains to the turbo housing resonator which makes the turbo quiet. Normally, the part is broken into to 2 parts which are glued together. This is the source of the problem, the glue usually fails and this affects the turbo pressure which is usually needed in going uphill. The part can be bought from the dealer or check your after market supplier of this turbo model. On some European cars, this P0299 fault code can also mean that the waste gate solenoid actuator is defective. As such, it could cause turbo inactivity causing the engine to loose power. To check, test the wirings of the turbo waste gate solenoid and the vacuum supply to the actuator. If OK, the most common fix is to replace the waste gate solenoid.
Turbo Boost Pressure:
The way turbo boost pressure works, if the turbine housing has small apertures (passage ways), it will make the turbo work at lower engine speeds. However, it can cause restriction to the exhaust gasses flow at higher engine RPM. If the compressor assembly is too big in relation to the turbine, it could cause stalling, but if it is too small, it could cause turbo over-speeding and will self destruct. In this sort of set-up, the system is controlled by the engine management system. Boost is generated by increase of exhaust pressure that is NOT going into the engine. Usually, this boost pressure is detected by an air flow sensor when a signal is then sent to the ECU (engine computer) which regulates boost pressure.
NOTE: In order to ensure that a high boost pressure is developed even at low engine speeds, the turbine and compressor sizes would have to be made smaller as much as possible.
In order for the wastegate to work, the compressor reference port must be hooked up to the compressor side of the turbo because the vacuum line attachment limits the set spring pressure. This in essence, will build unlimited boost pressure until your engine is destroyed.
Hope this explains.
Posted on Jul 29, 2010
Tips for a great answer:
Dec 10, 2010 | 2006 Dodge Sprinter
Sep 15, 2010 | 2005 Dodge Sprinter 3500 Standard Roof
Jul 11, 2010 | 2007 Dodge Sprinter
Sep 13, 2009 | 2007 Dodge Sprinter
Jul 07, 2009 | 2007 Dodge Sprinter
339 people viewed this question
Usually answered in minutes!