Question about Peugeot Cars & Trucks

1 Answer

Horn stopped working on car n key fobs struggling to work

206

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Try changing battery of key fob

Posted on Nov 28, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: porsche key fob

If the key had gone faulty, the key code must be re programmed on the vehicle computer. This can be done only using a PIWIS tool, available at the dealer or at a qualified Porche garage.
Try also the following reset:
turn ignition on,
turn off.
remove the transponder from the column
push any button on the fob within 6 seconds.
This procedure will reset the key synchronizing again with the vehicle computer.

Posted on Sep 13, 2008

  • 1 Answer

SOURCE: Key fob on my audi a3 1998 has stopped working

You need to get the key re-programmed by Audi. Same thing happened with my A4.

Posted on Nov 23, 2008

  • 1 Answer

SOURCE: Key fob on my audi a3 1998 has stopped working

the problem is inside the key fob if there is no response from the key fob at all then a new one will be needed. the problem is in side there is a mini circuit board in which all the sensors for that specific car are soldered on they can break very easly.

Posted on Jan 11, 2009

  • 11 Answers

SOURCE: horn on my 1999 saturn wont work.

have you checked the relay yet? see if its clicking whjle someone pushes the horn. its probally in the fuse box under the hood.

Posted on Mar 10, 2009

  • 32 Answers

SOURCE: Key fob stopped working the door locks. I changed

the circuit boards on those factory remotes, sometime break where the battery is clipped in, check to make sure the solder is holding the clip properly and it is not loose, also they remote may need to be programmed to the vehcile with a scan tool, usually only found at GM, Also the rubber part of the remote on the inside where the pad touchs the circuit board, uses a small screwdriver and touch the exposed circuit, if the remote locks the doors, try putting in tiny peice of alumumn tape of the inside pad, the connectiveness of the rubber wears off. If not try above or dealer.

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I start the car and put it into drive the horn goes on, when I shut the car off the horn sounds! wont go off until I disconnect the battery


You could pull the horn fuse, that should kill it. The horn fuse is hot all the time. Two possibilities, one is security system, the other is problem with horn switch or wiring in the steering column.
The horn switch is ground for the control side of horn relay. Part of key fob security horn beep, is also a ground wire. In the diagram, you can see the two wires, The one for fob, take it loose, see if that stops the horn sounding by accident. Don't leave any live wires hanging loose, use electrical tape or something to insulate. I don't know if taking that one wire loose will cause any problems or not, I guess you can try it and see?
Of course, you still want the horn switch to work normally.
26194649-r04ygfu41agzwd0alecunp5o-5-0.jpg

May 14, 2016 | 1999 Oldsmobile Cutlass

1 Answer

My 3 door peugeot 206 will lock ok with the key fob but will not unlock with the key fob, help!


Sounds like the unlock button on your key fob is the problem, try your spare key fob, if you don't have a spare fob, it's time to get a new one.

Dec 06, 2015 | 2004 Peugeot 206

1 Answer

How to turn off the pro alarm


I would start by replacing the FOB. Sounds to like the electronics inside it are bad. The only reason the horns would go off is if you hit the panic button. There is a slight chance the receiver is bad. But Fobs are cheaper to replace than the receivers. If you have two FOBs and they both react the same, then replace the receiver. Or just ditch the system. The keys (in the door locks) should still activate the alarm system.

Aug 07, 2014 | 2011 Chevrolet Silverado 1500

1 Answer

Horn stopped working n key fobs struggling to open car


Check battery on key fob. Also you can usually take the key fob to a parts store and have it checked to see if it is transmitting a signal. Hope this helps.

Nov 28, 2012 | Cars & Trucks

1 Answer

Crimestopper SP501 car alarm/remote starter will not respond. The 2 way one doesn't work, the sidekick does.


You need to program your crimestopper sp-501 key fobs, you need to program both the 2-way and the 1-way key fobs, during the same key fob program session. First find your valet button/switch, when you have found it, turn your ignition on and press the valet button four times, if you have a toggle type switch for a valet switch, toggle it up and down four times, when its in remote key fob program mode, it will honk your horn 4-times followed by 4-parking light flashes. Once your have done this press the lock button on the 2-way key fob, horn will honk and the 2-way will sing a little song to confirm programed, then press the lock button on the 1-way key fob the horn honk will be your confirm programed. turn ignition off this will exit you from program mode. then shut all doors and test key fobs for operation functions....hope this helps you out

Dec 03, 2011 | 2006 Hyundai Sonata

1 Answer

Key fob for my peugeot 206


Yes you can have multiple key fobs for one vehicle. They will need to be programmed. Some cars require that you program all key fobs at the same time and can only be done through a dealer scanner and some will have instructions in the owner's handbook.

May 16, 2010 | 1999 Oldsmobile Intrigue

1 Answer

Kia Rio 1.5 diesel Factory alarm,car horn honking,side indicators flashing,unable to start the car. When I arm the car with the fob and unlock the door with the key then open the door the horn starts...


The fob is infamous for its battery life. It gets drained so quickly that there happens to be a little later when the fob is very close to the door lock, ignition & unnecessary triggers the alarm due to low reception as the battery of the fobs discharges very fast, depending on the model, which has a certain virtual sheild(STARTRECK type) which is triggered by the fobs strength of the signal(radi waves).

Why not try a new set of batteries for your fob?? .................................sodeep

Oct 25, 2009 | 2003 Kia Rio

1 Answer

2001 TA WS6 - Horn and key fob not working


Horn problem is either bad horns or failed clockspring behind steering wheel which is the connection for the airbag and horn buttons.

Mar 29, 2009 | 2001 Pontiac Firebird

1 Answer

Horn on my 1999 saturn wont work.


have you checked the relay yet? see if its clicking whjle someone pushes the horn. its probally in the fuse box under the hood.

Mar 10, 2009 | Saturn SC1 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...