Question about Mitsubishi Cars & Trucks

Open Question

How far can a Mitsubishi Challenger travel when fuel light is flashing?

Stuck on unknown road and fuel light is flashing. HOW FAR HAVE i GOT TO FIND A SERVICE STATION PLEASE

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

66 chrgr
  • 1011 Answers

SOURCE: Wipers on 2000 Jeep Cherokee travel too far

hello, this sounds like your wiper transmission got out of alignment possibly due to ice on windsheild.don't really know.short of replacing you could loosen the nut under the cover and move wiper arm back possibly.

Posted on Jan 26, 2009

  • 1 Answer

SOURCE: idle speed problem

I ve had a 97 Mitsubishi Legnum and it wasn't idelling at all.(so in trafic brake and accelarator pretty dangerous) The idelling motor was buggered. Replaced with a 2nd hand idelling motor. Still doesn't idle perfectly. But works OK. It wasn't idleling well in temperaturers below 0. but after a while will be fine now.
Mitusubishis are known for their idelling motor problems. Good luck...

Posted on Jul 03, 2009

  • 10 Answers

SOURCE: flashing light on my dashboard for air conditioner and blower

Possible Solution 1 - Check your fuses2 - You can try disconnecting the battery for about 5 minutes to reset the onboard computer (Body Control Module BCM) which controls the items you mention. 3 - If that does not work, you can then try disconnecting (with battery disconnected for at least 30 mins to disarm airbag) and reattaching the wire connector to the BCM in case it has developed a bad connection - This is located under the dashboard on the drivers side. Should be a big square or rectangle connector with lots of wires and a bolt going through it. Unscrew the bolt and disconnect the connector from the BCM then reattach and screw the bolt back in.
The Body Control Module (BCM) supplies vehicle occupants with visual and audible information and controls various vehicle functions, To provide and receive information, the module is interfaced to the vehicle's serial bus communications network, the Chrysler Collision Detection (CCD) bus. This network consists of the powertrain control module (PCM), the Transmission Control Module (TCM) , the electro/mechanical instrument cluster (MIC) , the Airbag Control Module (ACM) , the Compass/mini-trip module and the Controller Antilock brake Module (CAB). The BCM is operational when battery power is supplied to the module. Ignition switch power is needed for ignition switch functions.
The BCM provides the following features: • Automatic door locks • Battery protection • Chimes • Compass/mini-trip support • Courtesy lamps • BCM diagnostic support • Door lock inhibit • Headlamp time delay • Ignition key lamp • Illuminated entry • Instrument panel dimming • Mechanical instrument cluster support • Power door locks (with/without remote keyless entry) • Sliding door memory lock • Vehicle Theft Security system (VTSS) • Windshield wipers / washers (front and rear)
http://autorepair.about.com/library/a/1c/bl546c.htm

Posted on Aug 13, 2009

  • 100 Answers

SOURCE: security light on.locked on radio

Go to carhelpsite.com it is free as long as you click on 2 of the ads at the website then your questions will be answered by an ASE certified mechanic,you don't have to buy or fill out anything on the ads,so help keep the site free.

Posted on Apr 13, 2010

SOURCE: When I turn on the windshield wipers they travel too far.

The wipers are not installed correctly. Remove and reposition the wiper arms ,so they do not hit the side of the outside window pillar,when set to high speed.

Posted on Apr 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many more miles can I drive when indicator starts flashing?


One bar flashing fuel light ' PriusChat

priuschat.com > Prius > Gen 3 Prius Fuel Economy
Apr 12, 2012 - So my fuel light started blinking after 480 miles. How much more can I drive it? The display ... That's when I start to look for a station. ..... Why are so manypeople concerned with driving past the blinking light & tempting fate? How far do you go when the fuel gauge blinks?
Feb 7, 2013
how much fuel left in PriusC tank when it shows empty (the last ...
May 17, 2012
How much do I have *really* left to drive?
Apr 2, 2012
When Gas light comes on, how many miles (approx) can you get ...
Jun 7, 2006
More results from priuschat.com

How long and far can you drive in an average car once the ...

https://www.quora.com/How-long-and-far-can-you-drive-in-an-aver... QuoraHow long and far can you drive in an average car once the fuel gauge reaches E? ... Edit: On a manual transmission, you can "mooch" a few more miles by very ... and or the gauge needle touches the "E" indicator line and your distance to travel ... If cars ran out at E, there would be many more cars on the side of the road.

Blinking Fuel Bar = how much more gas? Your opinion - Hyundai


Dec 10, 2015 | Cars & Trucks

1 Answer

How do i change the fuel filter off a challenger 98


there is a special tool that slides up the pipe.

Aug 26, 2014 | 1997 Mitsubishi Pajero

1 Answer

My mitsubishi challenger keeps dying when i go up the hill or downhill. i've changed the fuel pump but the problem is the same. sometimes its difficult to start the engine..


Check the condition and/or operation of the following:

1) Spark plugs, coils and leads.
2) Air filter
3) Fuel filter.

Please report back if no findings.

Nov 13, 2012 | Mitsubishi Cars & Trucks

1 Answer

Sump oil leak


Better off replacing the sump gasket and sump plug washer before travelling. Working in public health I have seen many motor cycle accidents caused by oil patches on roads esspecially after rain.

Jun 30, 2012 | 2002 Toyota Camry

1 Answer

Overdrive light on end of shift lever is flashing steadily wihile driving, only on backroads so far....owners manual says to have it serviced...change fluid or what?? 2003 e350 5.4l 12 passenger.


There is an electrical problem with the transmission. Stuck actuator or something. Get it checked, might be a $200-300 fix, that would cause a transmission failure down the road. It might even be the overdrive switch on the shifter.

Jan 20, 2011 | 2000 Ford Econoline

1 Answer

The fuel gauge is stuck on empty what can be done to fix the issue?


If the gauge is stuck on empty there is a good chance that the float came off of the sending unit inside the tank. If you have a trip meter on your car you can use that as a gas gauge, just remember to zero it each time you fill the tank. I don't know how far your car will travel on a tank of gas but, I would think you should be able to go 200 to 300 miles. Carry a gallon of gas in the trunk too, you may have to experiment a little.

Jan 23, 2010 | Mitsubishi Galant Cars & Trucks

1 Answer

4wd light keeps flashing on 2003 mitsubishi challenger


Hi Adstew,
the front diff has a sensor telling the control unit it when it is engaged (or not). It probably is, and it won't disengage. or the sensor is stuck. The selector lever tells the control unit you want 2WD but the sensor thinks the front axle is engaged. So it flashes.
When shifting to 2WD, normally the front axle will come free after a load change or a bit of turning the steering from side to side, but it sometimes happens that it gets stuck. You can find out:
lift the car free off ground, then select drive forward in 2WD. If the front wheels do not turn, then the sensor may be faulty or stuck. if the front wheels turn in 2WD mode, the diff is stuck and the sensor tells you so. Same or similar problem can happen with the center diff, by the way, on pajero/montero, etc.
regards
Winfried, the perfessa

Jan 18, 2010 | 2003 Mitsubishi Outlander

1 Answer

Check light


the check engine light should come on when the knock sensor light comes on. try a higher octane fuel, or try fuel with no ethenol in it. most fuel companies have begun adding ethenol, which causes a light spark knock in some cars, octane level is too low.

Oct 29, 2009 | Cars & Trucks

1 Answer

Mitsubishi challenger 04/05 wont start, has been


I would guess there is more than a single problem with your car. While sensors and worn spark plugs and other possible problems would cause bad starting and running, such things would rarely stop an engine. To stop an engine it mostly needs a fuel system failure, the loss of signal from cam/crank sensors or a failure of the supply to the computer or a failure of the computer itself, though immobiliser problems should not be ruled out.

It probably should be taken to the shop but please read the towing instructions in the vehicle handbook to avoid possible damage to the transmission.

Jun 09, 2017 | Mitsubishi Montero Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...