Question about 1989 Dodge Daytona

2 Answers

89 dodge daytona cranks but has on spark to the coil. fule pump is working, asd was replaced, still on spark to coil

Posted by Anonymous on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 257 Answers

Check to see if you have power going to the distributor, if so it's going to be the pick-up or the module in dist.

Posted on Mar 02, 2016

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 3,218 Answers

Possible distributor pick up coil located inside distributor cap It will be the black plastic piece with the wire on it. These were common to fail and cause a no spark situation

Posted on Mar 02, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mcgyver468
  • 710 Answers

SOURCE: 98 dode ram wont crank no spark

May have no spark due to a bad crank sensor, which is responsible for spark when it gets a pulse through the cars' computer.

Posted on Apr 24, 2009

  • 201 Answers

SOURCE: 1992 dodge 318 engine turns over, but no start. No

if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10

Posted on May 09, 2009

  • 7 Answers

SOURCE: 1997 Dodge Ram 1500 5.2 liter won't start

I WOULD SAY IT IS THE COMPUTER {BRAIN} THAT IS WHAT SENDS THE FIREING ORDER AND VOLTAGE AND SETS THE TIMEING SPECK I WOULD SAY CHECK THE COMP

Posted on May 26, 2009

  • 412 Answers

SOURCE: 97 dodge neon died replaced parts and still no spark HELP.

YOU NEED TO CHECK DARK GREEN/ORANGE WIRE AT IGNITION COIL WHEN CRANKING ENGINE FOR POWER..IF NO POWER,SHUTDOWN RELAY IS NOT BEING ENERGIZED..THIS ENGINE ALSO HAS CAMSHAFT POSITION SENSOR ON END OF CYLINDER HEAD..ENGINE CONTROLLER NEEDS CAM AND CRANK SIGNALS TO ENERGIZE THE SHUTDOWN RELAY..UNPLUG CRANK SENSOR AND CHECK VOLTAGE ON ORANGE WIRE..SHOULD HAVE APPROX 8V..IF NOT..UNPLUG CAM SENSOR AND SEE IF 8V SUPPLY RETURNS..IF NO POWER TRY UNPLUGGING VEHICLE SPEED SENSOR LOCATED IN TRANS HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..IF 8V RETURNS..THE SPEED SENSOR IS SHORTED INTERNALLY..THESE 3 SENSORS SHARE THE SAME 8V SUPPLY CIRCUIT..WITH SPEED SENSOR UNPLUGGED,PLUG CRANK SENSOR BACK IN AND TRY TO START ENGINE..HAVE SEEN THIS SAME PROBLEM AT WORK RECENTLY

Posted on Jul 19, 2009

  • 22 Answers

SOURCE: my van just died on me, no spark. I replaced

did you check the crank sensor?

Posted on Oct 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 dodge neon that will crank but wont start. I have replaced the cam shaft sensor, crank sensor and the coil pack. Iam also not getting spark to the coil pack. Any suggestions?


Primary voltage to several systems, including the ignition coil, dark green wire with orange tracer. That voltage comes from asd relay. There is a fuse for asd relay. To check for voltage the engine has to cranking. The control side of asd relay, the computer has to ground it before it will energize. Did you check wiring circuits for cam and crank sensor connectors before replacing sensors? Are there any applicable trouble codes?
Are you ok with testing wiring circuits?

Feb 16, 2017 | 2005 Dodge Neon

1 Answer

1993 5.2l 4x4 dodge dakota. No spark no fuel


ASD relay ! Is there B+ voltage to the coil's ? Fuel pump relay electrical circuit diagnostic's . Do you have an know how to test with a DVOM digital volt ohm meter ? You can check out wiring diagrams at http://bbbind.com/free_tsb.html ! The ASD - auto shut down relay power's up the fuel pump relay , ignition system an some other thing's . It's in the under hood fuse box !

Sep 06, 2016 | 1993 Dodge Dakota

1 Answer

89 DODGE daytona es where does power come from to coil


With engine cranking, the B+ side of coil gets voltage from asd relay. the asd relay supplies voltage to several systems, not just the ignition coil.
How long since a tune-up? Any applicable trouble codes? It could be the computer won't ground the asd relay for some reason, it could be the computer doesn't see the proper signal from the distributor/ sensor inside distributor. There could be other issues?

Mar 21, 2016 | Dodge Cars & Trucks

2 Answers

89 DODGE DAYTONA NO SPARK AT COIL


If you have no fuel pressure you wont have spark

Mar 02, 2016 | 1989 Dodge Daytona

1 Answer

Car wont start no spark


On Chrysler products, the first thing you check is the ASD relay to see if it is working. It powers several things including the coil and injectors on some models.
No spark can be caused by not having power to the coil, or signals from the cam and crank sensors.

Apr 19, 2013 | 1997 Dodge Intrepid

1 Answer

1996 dodge ram 1500 i have fuel but no spark after the coil pack


You have fuel,As long as you can hear the pump come on this is a good sign,the ASD relay works, The ASD relay power the fuel pump the injector the power to the coil,The primary signal for spark is the crank sensor the location is behind passenger side cylinder head its is a three wire connection.This is your solution

Mar 08, 2012 | Dodge Ram 1500 Cars & Trucks

1 Answer

My 89 dodge dynasty has no spark. ive put in 2 new coils, and swapped out the ASD relay n SBEC w new ones but still nothing. if i jump 12v directly to pos on coil still no spark but my fuel pump will...


sounds like the fuse box is not sending volts to the coils check the fuses and check the line to the coil packs make sure there getting power hope this helps

Sep 24, 2010 | 1989 Dodge Dynasty

2 Answers

1997 dodge ram won't start. My fuel pump does not run and coil won't spark. Iv'e checked fuses and relays and they look fine. Could a bad fuel pump cause the asd to kill power to the coil?


First check any ignition/fuel related fuses. Check to make sure you have 12 volts coming into the pump and coil. If nothing to the fuel pump replace the fuel pump relay - if you do have power to the fuel pump then replace the pump. If nothing is coming to the coil it is either an ignition relay or a wiring issue. If you have 12 volts to the coil but no spark then replace the coil.
Also the fuel pump/relay would not kill the coil.

Jan 21, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

The car will crank over but it has no spark and i replaced the coil pack on it and still no spark


try replacing the power module. Ihad the same problem with my 87 daytona shelby Z and the power module was the culprit

Aug 01, 2008 | 1987 Dodge Daytona

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...