Question about Suzuki Cars & Trucks

Open Question

Bad vibration on suzuki vitara while accelerating

Chainged front uni joints. it went now it seems the back is dooing it

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pal03246
  • 713 Answers

SOURCE: MY 2005 NISSAN FRONTIER HAS A BAD U JOINT THAT IS

Very common problem. This piece is covered by Nissan for 60000 miles or 5 years. And its most likely one of the front u-joints that failed.

Posted on Jul 17, 2008

Bonemusher
  • 1 Answer

SOURCE: Hi, I have a 1991 Suzuki JLX Vitara with the Front Right hub is locked into 4WD and I can seem to unlock it and the gearbox of late feels notchy, sometimes difficult to change into gear

spray with wd40 then put mole or vice grips on flat edge where finger & thumb would normaly go gently as its cast alloy get someone to move car backwards & fowards a few inches IE rock back & forward as you try to move the diff lock but make sure both front wheels are in the straight ahead position put in 4w high or 4w low put screew driver in between mole or vice grip prise very gently should move I had to do this on mine as normaly indicates that its not been used in a while then drive gental every now & then with both diff lockes engaged to keep them free dont go far with them locked on dry roads as hand book describes use em or loose em! use in snow ice wet slippery muddy surfaces remember switch em off when back on dry roads.

Posted on Dec 23, 2008

CivicSI990
  • 41 Answers

SOURCE: s2000 vibration when decelerating

Clutch would show different ugly symptoms - it is definately a warped/warn rotor and/or brake pads from high speed deceleration or "riding the brakes".

Fairly easy to fix, probably 2-3 hours of work for each corner

Posted on Apr 03, 2009

  • 2 Answers

SOURCE: front end shakes when accelerating

The desciption you gave is exactly how it feels when you have an axle with a bad inner CV joint. It won't make a "clicking" noise like when you have a bad outer CV joint, but will shake pretty bad on accel. If you crawl under the car while it's on the ground (don't lift it) and grab on to the axle close to the inner CV joint and wiggle it, there shouldn't be very much play in it. If there is play in it, replace that axle.

Posted on May 01, 2009

boysor2933
  • 293 Answers

SOURCE: 1999 Suzuki Grand Vitara Vibrate/shake at 55-70 mph

Lift the back of your car.With a stable rest and with the two hind wheels hanging, run your car up to the speed where you experienced vibration. have someone take care of the throttle and shifting while you observe the transmission shaft. You may have an imbalanced shaft.

Posted on May 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 SUZUKI VITARA FRONT WHEELS VIBRATION BETWEEN 40 & 60


Could be a bad CV joint, a bad tire, bad brake rotor, or a steering linkage.

May 16, 2014 | 2003 Suzuki Vitara

1 Answer

Ok here is to start out with the problems with my 95 dodge intrepid


thew vibration may harmonic and that points to a spinning shaft THe tail shaft unijoints would be suspect or if independant suspension rear axle uni joints

Jan 24, 2013 | 1995 Dodge Intrepid

1 Answer

My 2001 silverado 4wd 5.3, hums noticeably in the cab when accelerating around 30mph + I do have a leak rear t-seal and both front t axles and have filled the front thinking that was the problem however...


when you say humming as if out of balance you may have ansqwered your own question. Tail shaft vibration comes in aroun 30 mph and the points I would look for are loose uni joints or a lost balance weight from the tail shaft. To check uni joints look for rust streaks from cross.The next step is to grab firmly either side of the joint and see if there is any movement while twisting you hands in opposite directions. next lift one half of the cross and check for movement in the bearings repeat this at all uni joints check the tail shaft slip joint by trying to twist each half and check for up and down movement at this spline. front shafts fail more readily than rear ones

Jan 06, 2013 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Vibration between 40 and 60 mph


when did you have your tires balanced last. If it has been awhile have them re-balanced. Your description sounds like you may have thrown a weight.

Aug 03, 2012 | 2003 Suzuki Vitara

2 Answers

I am getting a clunking loud metallic noise when i accelerate, stop and move again from my 2008 grand vitara. i don't know if it is the backlash but it doesn't sound real.


Hi its sounds as though a bearing is braking up inside its race,possibly on a c/v joint or universal joint, especially if front wheel drive.

May 11, 2010 | 2007 Suzuki Grand Vitara 4WD

2 Answers

1999 Suzuki Grand Vitara Vibrate/shake at 55-70 mph


Lift the back of your car.With a stable rest and with the two hind wheels hanging, run your car up to the speed where you experienced vibration. have someone take care of the throttle and shifting while you observe the transmission shaft. You may have an imbalanced shaft.

May 12, 2009 | 1999 Suzuki Grand Vitara

1 Answer

Vibration shudder at around 30km


Hey Pontiac,

There are two things, firstly get your front wheel rims put on a lathe machine to check for distortion, if not, then get the wheels balanced on a digital tyre balancer.

let me know if this works

Aug 17, 2008 | 1995 Suzuki Samurai

1 Answer

Wobbling of car while accelerating


the u joints in the drive shaft. (CV joints on front wheel drive) more strss on the joints when accelerating so they cause the vibration. no stress/load smooth run. Replace the joints and you'll feel a big difference.

Jun 24, 2008 | 1996 Suzuki Swift

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...