Question about Nissan Sentra

Open Question

Where is the freeze plug located on a 1997 nissan altima

Where is the freeze plug located and how hard is it to replace on a 1997 nissan altima

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2003 Nissan Altima?

Where is the sensor placed on the car?

Posted on Oct 07, 2008

jschoon77
  • 55 Answers

SOURCE: Location of oil filter on Nissan Altima 2005

The oil filter is located behind the right (passenger) inner fender cover. It is right next to the crankshaft pulley at the bottom of the front of the engine facing toward the right front wheel. I do not have a picture at this time.

Hope this is helpful!


Nissan Scope Technician- 10+ years experience in Nissan dealership.

Posted on Nov 04, 2008

USfalcon
  • 175 Answers

SOURCE: How to reset the ''Air Bag'' light on 1997 Nissan Altima?

u have to take ur car to garage or dealer to use the scaner to rest the code

Posted on Apr 05, 2009

  • 383 Answers

SOURCE: need to install a thermostat of a nissan altima

Dear Guest: If you have some reasonable mechanical aptitude, it is a simple task on this engine to do.
The thermostat is located near the front to the engine (the side closest to the belts) and on the side where the radiator is.
Follow the top radiator hose to the engine and you will have found the thermostat housing.
1. Make sure the engine is cool before doing this job.
2. Get a drain pan and drain the coolant from the radiator. The drain **** for the radiator is located at the bottom of the radiator. Some have an end which can be turned without tools and others require a flat screw driver to unscrew the fitting from the bottom of the radiator. Make sure you remove the radiator cap, as it will drain much faster. Once drained, put the drain **** back into the radiator. Be careful and DO NOT OVER TIGHTEN IT! It will snap off in the radiator!
3. Release the hose clamp which secures the hose to the thermostat housing and then grasp the hose at the neck where the clamp was and try to rotate the hose on the housing. DO NOT try to just pull the hose off. Break it loose first by rotating it on the housing. If it is stuck, get a small screw driver and carefully, slide it in between the hose and the housing, working it around until you can rotate the hose. At that point you can remove the hose and push it off to the side or take it loose at the radiator as well. CAUTION!!!!! the radiator tanks are plastic and will break if you are not careful!
4. There are 3 bolts which retain the housing to the cylinder head.
Typically the bolt head size is a 10mm. Using a 10mm socket, rotate the bolts in a counter clockwise direction, removing all three bolts. There are some that did use a 12 mm bolt head size. Most of the time the housing will just come loose. Sometimes, it will stick. If so, a light tap will break it loose. Pay attention as to how the thermostat is positioned in the cylinder head prior to removing it. Most of the time it will pop out easily or you can easily pry it out with a small screw driver. CAUTION!!!!
Do not damage the mating surface where the gasket seals.
Carefully clean the old gasket off. A single edge razor works fine.
5. The thermostat has a top and a bottom. If you look closely, you will see a place in the outer parameter of the thermostat where there is a small hole, often with a little metal tab which projects through the other side and is able to jiggle some. This is a small bleeder to help bleed the air trapped in the system when it is installed. This part of the thermostat must be at the 12:00 position.
Additionally, make sure the part with the hoop is sticking out toward you. The cylinder head has been machined to allow the thermostat to fit flush with it when installed properly.
6. Clean the old gasket from the thermostat housing. Nissan utilizes a liquid gasket sealer (silicon) which you apply a "SMALL" bead around the water inlet (the cylinder head side), let the sealer skin lightly and then put the housing in place making sure that the thermostat had remained seated during the installation. If it had come loose and you try to tighten the bolts, you will crack the thermostat housing.
7. When you tighten the thermostat housing bolts, there is a torque specification however most people don't have torque wrenches which measure in inch pounds. For those who have a torque wrench, 10mm bolts:56.4-66 inch lbs, 12mm bolts 12-14 ft lbs.
I have found that the easiest way to keep from over tightening the bolts is to grab the ratchet from the head and tighten the bolts because you don't have the leverage at that point.
8. Let the silicon dry for 10 minutes and and then fill the system back up with coolant. Reattach the hose and clamp being careful not to over tighten the hose clamp.
If you are replacing it, not more than a 50/50 mix. There is no special bleeding procedure Nissan has for this car. Just fill the radiator with coolant, turn the heater inside the car to the heat position to allow coolant flow into it as well, because it too is part of the cooling system in terms of coolant capacity. I usually fill the radiator until it shows 1/2 way up the tank. As the engine warms up,prior to the thermostat opening, more often than not, the coolant level will rise dramatically before it drops. Once the thermostats has opened top the system off, put the cap on and let it run for a while and watch for leaks. Take the car on a short loop and then recheck for leaks again. If everything has gone well, the temperature will read normal and no coolant will be leaking.
Hopefully this should be sufficient to answer your question.

Posted on Apr 05, 2009

  • 6982 Answers

SOURCE: 1997 nissan altima will not start

OK...Some cars use a "prime" relay and a "run" relay on the fuel pump. since manually priming it seems to work, I'd check and see if you have a similar system. If so, the prime relay may be bad.

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced the fuel pump and filter on a 2000 Nissan Altona it's shooting fuel from the pump but not near the filter what can cause this


Nissan fuel pump recall : Nissan Altima Common Engine ...

repairpal.com > Problems > Nissan > Altima
Nissan issued a recall on the fuel pump for premature failure. ... I am in need of a newfuel pump and scared to drive my car and its leaking ... pump and fuel filter located and how can i access them if i wan to replace th. ... 2000 Nissan Altima.

Fuel pump and fuel filter - 2003 Nissan Altima - RepairPal

repairpal.com > Questions > Nissan > Altima > 2003 Nissan Altima
Mar 25, 2009 - Where is the fuel pump and fuel filter located and how can i access them if i wan to replace them?

Fuel Pump Replacement Cost for Nissan Altima - RepairPal ...

How To Replace Fuel Filter on Nissan Altima 2001 - YouTube? 6:46https://www.youtube.com/watch?v=Vwg2wm13ilMOct 25, 2011 - Uploaded by roluardoHow To Replace Fuel Filter on Nissan Altima 2001 ... How toreplace a 2002 Nissan 3.5 Maxima Fuel Filter 2000-2004 pt 1 - Duration: 14:20.fuel hose replacement. Car fuel leakage. fuel pump ...? 5:30https://www.youtube.com/watch?v=BPGaxxkK71cApr 4, 2014 - Uploaded by LearningZoneHere I am going to illustrate the fuel hoses (fuel lines)replacement for Nissan Sentra ... Fuel pump leak fix - quick and cheap - Duration: 11:16.

Jan 13, 2016 | Nissan Cars & Trucks

1 Answer

Cant find freeze plug on 2000 nissan altima


It is and check under the exhaust manifold for other one.

Feb 06, 2014 | Nissan Sentra Cars & Trucks

1 Answer

Problem with 2006 Nissan Altima 2006 nissan


Coil packs are located on top of spark plugs, one for each cylinder.

Aug 25, 2013 | 2006 Nissan Altima

1 Answer

Electrical equipment not working 1997 Nissan


Have you check the fuse to see if the fuse for the gauges are bad, also there is a fuse box under the hood that may contain additional fuses if one is not located in the fuse compartment under the dash.

Apr 17, 2010 | 1996 Nissan Altima

1 Answer

What kind of transmisson fluid do i need for my 1997 nissan altima which has a manual transmission


http://www.scribd.com/doc/7271731/1997-Nissan-Altima-Owners-Manual

Section 9 page 7...Looks like 80w90 gear oil for the manual transmission. The sure make it hard to find in the manual, but it is there.

Sep 24, 2009 | 1997 Nissan.5 Altima

1 Answer

Where is the speed sensor located on 1997 Nissan Altima SE 4 cly.


2004 nissan altima on right front of transaxle near right axle flange1997 nissan altima on transaxle.

Jul 26, 2009 | 2004 Nissan Altima

1 Answer

How to reset the ''Air Bag'' light on 1997 Nissan Altima?


u have to take ur car to garage or dealer to use the scaner to rest the code

Apr 05, 2009 | 1997 Nissan.5 Altima

1 Answer

1997 Nissan Altima problem


Check your battery fuse mine just also did that and it was the fuse under the hood. Location of fuse box is by the battery and it should be the big fuse close to the middle

Nov 03, 2008 | 1997 Nissan.5 Altima

2 Answers

What will my car sound like, if the timing chain needs to be replaced? I have a 1997 Nissan Altima.


there will be a rattle the front of the engine. the end with all your pulleys and belts on. And it will be hard to work out if it's in the engine or the pulleys.

It is a common that a TICKING coming from the front of the engine is the timing chain guide.

This -->LINK<-- will help you alot.

Regards

Philip

Jul 31, 2008 | 2000 Nissan Altima

1 Answer

1997 Nissan Alitma Headlight


you can go to auto store and if they are ina good mood they will do it for you

Jun 29, 2008 | 1997 Nissan.5 Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...