Question about Cars & Trucks
EGR stands for Exhaut Gas Recirculation valve. It will be located on the side of the intake manifold. It can cause poor to no idle and cause other sensor to throw a diagnostic code. This is probably one of the only sensor/valves that can be cleaned and put back on. It will cause problem after carbon buildup restricts it from opening and closing properly. They are also normally vacuum operated. So look for pretty much the only sensor/valve with a vacuum line attached to it. Clean the pendulum and sit with some carburetor cleaner and reinstall. If you are careful enough you can also reuse the gasket or o-ring. Also look for 2 or 3 small bolts holding it to the intake manifold. Hope this helps.
Posted on Nov 28, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
JUST RELEASE THE PRESSURE AT THE FUEL PRESSURE TEST PORT ON THE FUEL SUPPLY RAIL THAT SUPPLIES THE INJECTORS, IT IS A METAL VALVE LIKE A TIRE VALVE, THAT IS THE FACTORY RECOMMENDED METHOD..
Posted on Mar 11, 2009
SOURCE: expansion valve location
raven 1g: Your car doesn't use an expansion valve. It uses a fixed orifice tube which is located in the smaller of the two A/C lines, just before they enter the cabin area of the car.
Just disconnect the line and pull the orifice tube out of the line. Be careful not to break off anything and leave it in the line.
Posted on May 10, 2009
SOURCE: mazda millenia problems
here are a few problems to look out for:
Check-engine light: Check engine light comes on due to carbon buildup on the exhaust valves of 2.5L engine. (1995-02)
Engine noise: Some engines make a metallic tapping noise requiring a new friction-gear spring on the camshaft. (1995)
Headlights: The headlight drain hoses can get kinked by the aiming screws causing fogging. (1995-96)
Keys: It may be hard to turn the ignition key because the steering shaft is not positioned correctly. (1995)
Steering problems: The steering wheel may be off center requiring adjustment of the tie rods. (1995). You can also have a look at the following website where some owner have given their opinions on owning one. http://www.carsurvey.org/reviews/mazda/millenia/r68654/comments/
Posted on May 20, 2009
Here is the diagram in words as found at
Car Radio Battery Constant 12v+ Wire: Red/Black
Car Radio Accessory Switched 12v+ Wire: Blue
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Green/White
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 5 1/4′
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): Yellow
Left Front Speaker Negative Wire (-): Blue
Right Front Speaker Positive Wire (+): Pink
Right Front Speaker Negative Wire (-): Purple
Car Audio Rear Speakers Size: 6′ x 9′
Car Audio Rear Speakers Location: Rear Deck
Left Rear Speaker Positive Wire (+): Green
Left Rear Speaker Negative Wire (-): Yellow/Green
Right Rear Speaker Positive Wire (+): Green/Black
Right Rear Speaker Negative Wire (-): Green/Orange
Posted on Jul 16, 2009
Tips for a great answer:
Apr 26, 2013 | 2000 Mazda Millenia
Aug 25, 2012 | 2000 Mazda Millenia
Jun 07, 2012 | 1999 Mazda Millenia
Apr 25, 2010 | 2000 Mazda Millenia
Jul 16, 2009 | 2001 Mazda Millenia
May 20, 2009 | 2000 Mazda Millenia
Mar 11, 2009 | 2002 Mazda Millenia
66 people viewed this question
Usually answered in minutes!