Question about Cars & Trucks

Open Question

Cummins isx 500 turns over but wont crank after a few attempts it will start .new starter and batteries

New starter new batterries

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
cbcs2008
  • 46 Answers

SOURCE: new starter good batt. only clicks wont turn over 1995 montero

The Batt does not have a full charge or it is the wrong cranking AMP's for the car... find out if it is the right Batt and also that it is put on a "slow charge" over night or at least 6 hr's

Posted on Jan 20, 2009

Ad
aaangie220
  • 202 Answers

SOURCE: 2002 pontiac aztek wont crank or start

did you try the starter relay.

Posted on Feb 12, 2009

dmsr63
  • 2050 Answers

SOURCE: my 4runner wont start. it clicks once but wont

You will need a meter or a test light to check the starter. You will have a big wire cable going from the battery to the starter that always has 12 volts positve at it. The smaller wire will have 12 positive when the ignition key is turned to "start." If you have both of these at the starter, your starter is bad.

Posted on Aug 01, 2009

  • 564 Answers

SOURCE: i have 2003 cad cts mt new battery,new starter

does the vehicle have an anti theft device on it if so it may need to be reset. usually all you have to do is unlpug the negative batt cable. for about 5 mins.and reconnect it. if this does not solve the problem look i the owners manual to see how to override the system.

Posted on Dec 11, 2009

  • 7353 Answers

SOURCE: 1999 ford contour that wont crank

You mean wont CRANK or CRANKS but WONT RUN???? 4 cyl or V6 auto or manual trans????????? The 8th VIN digit would be most helpful as there are 4 different engines for that car. Its really cheaper to check items before you replace them. The starter should have a smaller BLACK wire that should have power on it when trying to crank the car. You say it wont crank, then check the neutral switch on the trans. Try putting it in neutral to start it. If it has a manual trans, the clutch switch on the pedal may be bad. There is a starter relay in the fuse box under the hood that powers the starter, does it click if you turn the key to start? if it does then the relay is at least trying to work, but doenst mean the contacts inside are good, If it does not click, then the neutral switch may be bad.Check the BLACK/YELLOW wire at the trans switch, if it has power on it, the switch may be bad, ground that (Black/Yellow)wire and see if it cranks. I dont know if there are any other relays in the fuse box that you can swap for the starter relay for test purposes.

Posted on Dec 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Security system. 2002 Camaro has been sitting without a battery in it. New batterry starter will not engage. Separate fob. The factory fob seems to work fine. Thanks, Dwight


If it has sit for a long while, I might put a couple drops of oil in each cylinder, turn the crank by hand. You could jump the starter relay to get the starter motor to crank a little. If you try something like that, make sure tranny is in park or neutral and functional parking brake is set.
Your security system has the pellet in the key? You could try a relearn procedure?
Turn the ignition switch to start, then release to the on position
The security lamp should be on
After 10 minutes the lamp will turn off
Repeat the 10 minute sequence 2 more times, with 5 seconds between them
Turn ignition switch off. Hopefully on the next start attempt it will start?
Sometimes after a vehicle sits for a long time, little gremlins get to chewing on the wires, cause all kinds of problems. Any applicable trouble codes?

Mar 04, 2017 | Cars & Trucks

2 Answers

98 olds aurora i turn key wont start. all else seems fine after a few attempps it will start any idea whats wrong?


You mean it cranks but won't start, or it just won't crank over?

If it won't crank, possibly a defective starter motor or starter solenoid. To be sure: when it won't crank, put a test light on the small wire to starter solenoid with key held in start position. Wire should have power. If it does, defective or failing starter motor or starter solenoid. If no power on the wire, check battery and starter connections for loose connection. Further testing requires a wiring diagram to see the whole starting system.

Feb 25, 2017 | Oldsmobile Aurora Cars & Trucks

2 Answers

Lights comes on. power to batterry and starter but when i crank i just hear clicks. car died on me while driving. suggestion?


If you hear clicks but do not hear the starter run, the starter may have failed without providing any symptoms in advance

Feb 26, 2013 | 1998 Buick Century

1 Answer

It was running fine two days ago now it wont start everbody saying its the starter butthe radio lights come on so it coulndnt be the batterry please do anbody have any reall suggestion


starter different from battery. radio lights come on so the battery has at least enough power to turn on the radio. Does it have enough power to supply minimum voltage and amps to the starter? A whole different story here.
Jump it. If it starts its the battery. If not, check: 1) 60a starter fuse, start relay, voltage at starter when attempting to start with key( two people required) and finally, run 12v directly to starter from known good battery to determine if starter/solenoid is good

Jun 29, 2010 | 2000 BMW 3 Series

1 Answer

Truck Wont Start and Battery Runs Down.


get a load test done on you battery and alter nator and check your starter for corrision check battery connections before you jump start it and when hooking up cables to your truck let it charge for a few minutes before you crank it if alternator is fried it will only run on juice of battery then will die.the clicking sound is your starter trying to engage but not enough cranking amps left in battery if you can get it going or take the battery out and take to a good auto shop and get them to load test it no point replacing a good battery just to find out it is alternator or starter
I personaaly think it may be alternator but suggest you test if battery is good starter as well ! more thing check that battery terminals are clean and tight

Dec 19, 2009 | 2000 Chevrolet Blazer

2 Answers

Turned key to start engine, battery was low engine only cranked three times. Turned key to off but engine was still trying to crank with the key in off position. put on battery charger and engine tried to...


stater bendex/new starter.or relay.but start with new starter.PS make sure your cables are clean AND THE BSTTREY IS HOT.a low or bad batt can do the same thihg

Nov 21, 2009 | 1995 Dodge Ram

2 Answers

Reset turbo boost relay 2003 Cummins


You will find step by step instructions on this software .. Download from here: Cummins Signature ISX and QSX15 Factory Manual Repair Servic Download...

Jun 08, 2009 | 2005 Dodge Ram 3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...