Po161 code
SOURCE: where is the bank 2 sensor 1 located.
Oxygen sensors are always numbered like this:
Bank 1 sensor 1
Bank 2 sensor 1
Bank 1 sensor 2
Bank 2 sensor 2
some manufacturers use a kind of shorthand that reads different, but means the same thing:
Sensor 1/1 or O2s 1/1
Sensor 2/1 or O2s 2/1
Sensor 1/2 or O2s 1/2
Sensor 2/2 or O2s 2/2
Bank 1 is always the side of the engine where cylinder number 1 is located and, of coarse, Bank 2 is the opposite side.
On a 4 cylinder engine, there is only 1 bank and it is always referred to as Bank 1.
Sensor 1 is always the upstream sensor (The one located BEFORE the catalytic converter)
Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic converter.
Most GM engines have #1 cylinder located on the left bank, (or Driver's Side) of the engine,
So, the answer to your question would be that you are looking for the sensor located before the catalytic converter on the right (or Passenger Side) of the truck.
SOURCE: have a code po 430 catalyst efficiency below
You def have a catayst problem. Before changing the converter i would recommend changing both up and down stream oxygen sensor on bank 2. If they are old thats what the computer determines if the catalyst is good or not. Most of the time after changing the sensors and resetting the light the problem is solved.
SOURCE: where is the bank 1 sensor 2 o2 sensor for a 96
Oxygen sensors are numbered by which bank of cylinders they serve. Bank 1 is the left or drivers side bank of cylinders on the 4.3L which has the odd numbered cylinders 1,3, and 5. Bank 2 is the right or passenger side bank of cylinders numbered 2, 4, and 6. The Bank 1 Sensor 1 would be the sensor for the left hand side of the engine AHEAD of the converter. Bank 1 Sensor 2 is the sensor for the left hand side bank of cylinders BEHIND the converter.
SOURCE: were bank 1 sensor 2 located on a 1997 tahoe
bank 1 is the drivers side,and it is the down stream sensor,the one after the cat,converter,If this was helpful,please let us know,thank you.
SOURCE: 2002 chevy silverado hd2500 6.0 ecm code po332 low
If all connections are good "dry, tight, no corrosion" then yes. It should be a defective sensor. These sensors are piezo sensors and create a voltage when sensing a knock. A bank refers to a side on a V style engine, 2 refers to the rear sensor on your bank 2. Bank 1 should be the side with cylinder #1 which should be the cylinder closest to you on one of the sides. So your looking for the rear sensor on the opposite side.
2,076 views
Usually answered in minutes!
×